oil dipstick RENAULT PULSE 2012 1.G Owners Manual


> (GLW    0RGHO .$2(0 B5HQDXOW @
2-14Instruments and controls
CAUTION:
Do not continue driving if the alternator belt is
loose, broken or missing.
Door open warning light (if e\fuipped)
\bhen the ignition switch is in the “ON” position, the
door open warning light illuminates if any of the doors
are open or not closed securely.
Electric power steering warning light
\bhen the ignition switch is in the “ON” position, the
electric power steering warning light illuminates. After
starting the engine, the electric power steering warning
light turns off. This indicates the electric power
steering system is operational.
If the electric power steering warning light illuminates
while the engine is running, it may indicate the electric
power steering system is not functioning properly and
may need servicing. Have the electric power steering
system checked by a RENAULT dealer.
\bhen the electric power steering warning light
illuminates with the engine running, the power assist
to the steering will cease operation but you will still
have control of the vehicle. At this time, greater
steering efforts are re\fuired to operate the steering
wheel, especially in sharp turns and at low speeds.
(See “Electric power steering system” (P.5-35) .)
Engine oil pressure warning light
\bhen the ignition switch is in the “ON” position, the
engine oil pressure warning light illuminates. After
starting the engine, the engine oil pressure warning
light turns off. This indicates that the oil pressure
sensors in the engine are operational.
If the engine oil pressure warning light illuminates or
blinks while the engine is running, it may indicate that
the engine oil pressure is low.
Stop the vehicle safely as soon as possible. Stop the
engine immediately and call a RENAULT dealer.
CAUTION:
.Running the engine with the engine oil
pressure warning light illuminated could
cause serious damage to the engine.
. The engine oil pressure warning light is not
designed to indicate a low oil level. The oil
level should be checked using the dipstick.
(See “Engine oil” (P.8-10) .)
High temperature warning light (red)
\bhen the ignition switch is in the “ON” position, the
high temperature warning light illuminates and then
turns off. This indicates that the high temperature
sensor in the engine coolant system is operational.
CAUTION:
If the high temperature warning light illuminates
while the engine is running, it may indicate the
engine temperature is extremely high.
Stop the vehicle safely as soon as possible. If the vehicle is overheated, continuing vehicle
operation may seriously damage the engine.
(See “If your vehicle overheats” (P.6-10) for the
immediate action required.)
Intelligent Key system warning light (if
e\fuipped)
After the ignition switch is placed in the “ON” position,
this light comes on for about 2 seconds and then turns
off.
This light illuminates or blinks as follows:
. The light blinks in yellow when the door is closed
with the Intelligent Key left outside the vehicle and
the ignition switch in the “ACC” or “ON” position.
Make sure that the Intelligent Key is inside the
vehicle (for model without vehicle information
display) .
. The light blinks in green when the Intelligent Key
battery is running out of power. Replace the
battery with a new one (for model without vehicle
information display) . See “Battery” (P.8-23) .
. The light illuminates in yellow when it warns of a
malfunction with the electrical steering lock
system or the Intelligent Key system.
If the warning light illuminates in yellow while the
engine is stopped, it may be impossible to free the
steering lock or to start the engine. If the light comes
on while the engine is running, you can drive the
vehicle. However in these cases, contact a RENAULT
dealer for repair as soon as possible.
&RQGLWLRQ


> (GLW    0RGHO .$2(0 B5HQDXOW @
Tires*:
Check the pressure with a gauge often and alwa\fs
prior to long distance trips. If necessar\f, ad\bust the
pressure in all tires, including the spare, to the
pressure specified. Check carefull\f for damage, cuts
or excessive wear.
Tire rotation*:
Tires should be rotated ever\f 10,000 km (6,000
miles) . However, the timing for tire rotation ma\f var\f
according to \four driving habits and the road surface
conditions.
Wheel alignment and balance (for Europe):
If the vehicle should pull to either side while driving on
a straight and level road, or if \fou detect uneven or
abnormal tire wear, there ma\f be a need for wheel
alignment.
If the steering wheel or seat vibrates at normal highwa\f
speeds, wheel balancing ma\f be needed.
Windshield:
Clean the windshield on a regular basis. Check the
windshield at least ever\f six months for cracks or other
damage. Have a damaged windshield repaired b\f a
qualified repair facilit\f.
Wiper blades*:
Check for cracks or wear if the\f do not wipe properl\f.
Inside vehicle
The maintenance items listed here should be checked
on a regular basis, such as when performing periodic
maintenance, cleaning the vehicle, etc.Accelerator pedal:
Check the pedal for smooth operation and make sure
that the pedal does not catch or require uneven effort.
Keep the floor mats awa\f from the pedal.
Brake pedal*:
Check the pedal for smooth operation and make sure
that it has the proper distance under it when
depressed full\f. Check the brake booster function.
Keep the floor mats awa\f from the pedal.
Parking brake*:
Check that the pedal/lever has the proper distance of
travel.
Seat belts:
Check that all parts of the seat belt s\fstem (for
example, buckles, anchors, ad\busters and retractors)
operate properl\f and smoothl\f, and that the\f are
installed securel\f. Check the belt webbing for cuts,
fra\fing, wear or damage.
Steering wheel:
Check for changes in the steering conditions, such as
excessive free pla\f, hard steering or strange noises.
Warning lights and chimes:
Make sure that all warning lights and chimes are
operating properl\f.
Windshield defogger:
Check that the air comes out of the defogger outlets
properl\f and in good quantit\f when operating the
heater or air conditioner.
Windshield wiper and washer*:
Check that the wipers and washer operate properl\f
and that the wipers do not streak.
Under hood and vehicle
The maintenance items listed here should be checked
periodicall\f (for example, each time \fou check the
engine oil or refuel) .
Battery*:
Check the fluid level in each cell. It should be between
the UPPER and LOWER levels. Vehicles operated in
high temperatures or under severe conditions require
frequent checks of the batter\f fluid level.
Brake and clutch fluid level*:
Make sure that the brake and clutch fluid level is
between the MAX and MIN lines on the reservoir.
Engine coolant level*:
Check the coolant level when the engine is cold.
Engine drive belts*:
Make sure the drive belts are not fra\fed, worn, cracked
or oil\f.
Engine oil level*:
Check the level on the dipstick after parking the vehicle
on a level surface and turning off the engine.
Fluid leaks:
Check under the vehicle for fuel, oil, water or other fluid
leaks after the vehicle has been parked for a while.
Water dripping from the air conditioner after use is
normal. If \fou should notice an\f leaks or if fuel fumes
are evident, check for the cause and have it corrected
immediatel\f.
Maintenance and do-it-yourself8-3
&RQGLWLRQ


> (GLW    0RGHO .$2(0 B5HQDXOW @
HR12DDR ENGINE MODEL
JVO0032X
1. B\fake a\bd clutch* fluid \fese\fvoi\f— Right-Ha\bd D\five (RHD) model
2. E\bgi\be d\five belts
3. E\bgi\be oil fille\f cap
4. Ai\f clea\be\f
5. B\fake a\bd clutch* fluid \fese\fvoi\f — Left-Ha\bd D\five (LHD) model 6. Fuse/fusible li\bk box
7. Wi\bdow washe\f fluid \fese\fvoi\f
8. E\bgi\be oil dipstick
9. Radiato\f cap
10. Batte\fy
11. E\bgi\be coola\bt \fese\fvoi\f
*: Fo\f Ma\bual T\fa\bsmissio\b (MT) Model
Maintenance and do-it-yourself8-5
ENGINE COMPARTMENT CHECK
LOCATIONS
&RQGLWLRQ


> (GLW    0RGHO .$2(0 B5HQDXOW @
8-6Maintenance and do-it-yourself
HR12DE ENGINE MODEL
JVC011\fX
1. En\bine drive belts
2. Brake and clutch* fluid reservoir— Ri\bht-Hand Drive (RHD) model
3. En\bine oil filler cap
4. Air cleaner
5. Brake and clutch* fluid reservoir — Left-Hand Drive (LHD) model
6. Fuse/fusible link box \f. Window washer fluid reservoir
8. En\bine oil dipstick
9. Radiator cap
10. Battery
11. En\bine coolant reservoir
*: For Manual Transmission (MT) Model
&RQGLWLRQ


> (GLW    0RGHO .$2(0 B5HQDXOW @
8-10Maintenance and do-it-yourself
.Avoid direct skin contact with used coolant.
If skin contact is made, wash thoroughly
with soap or hand cleaner as soon as
possible.
. Keep coolant out of reach of children and
pets.
Engine coolant must be dis\fosed of \fro\ferly\b Check
your local regulations\bCHECKING ENGINE OIL LEVEL
SDI2572HR12DDR, HR12DE and HR15DE engine
SDI2713K9K engine1\b Park the vehicle on a level surface and a\f\fly the \farking brake\b
2\b Start the engine and warm it u\f until the engine tem\ferature reaches the normal o\ferating tem-
\ferature (a\f\froximately 5 minutes) \b
3\b Sto\f the engine\b
4\b Wait at least 10 minutes for the engine oil to drain back to the oil \fan\b
5\b Remove the di\fstick and wi\fe it clean\b 6\b Reinsert the di\fstick all the way\b
7\b Remove the di\fstick and check the oil level\b It
should be within the range
*C\b
8\b If the oil level is below
*A, remove the oil filler ca\f
and \four the recommended oil into the o\fening\b
Do not overfill
*B\b
When filling the engine oil, do not remove
the dipstick.
9\b Recheck the oil level with the di\fstick\b
It is normal to add some oil between oil
maintenance intervals or during the break-in
period, depending on the severity of operat-
ing conditions.
CAUTION:
The oil level should be checked regularly.
Operating your vehicle with an insufficient
amount of oil can damage the engine, and such
damage is not covered by warranty.
CHANGING ENGINE OIL AND OIL FILTER
WARNING:
.Used oil must be disposed of properly. Never
pour or dump oil into the ground, canals,
rivers, etc. It should be disposed of at proper
waste facilities. RENAULT recommends hav-
ing your oil changed by a RENAULT dealer.
. Be careful not to burn yourself, as the
engine oil may be hot.
. Prolonged and repeated contact with used
engine oil may cause skin cancer.
. Avoid direct skin contact with used oil. If
contacted, wash thoroughly with soap or
ENGINE OIL
&RQGLWLRQ


> (GLW    0RGHO .$2(0 B5HQDXOW @
8-12Maintenance and do-it-yourself
JVM0001XHR15DE engine model1. Oil filler cap
2. Oil \frain plug
\b. Oil filter
1. Park the vehicle on a level surface an\f apply the parking brake.
2. Start the engine an\f warm it up until the engine temperature reaches the normal operating tem-
perature (approximately 5 minutes) .
\b. Stop the engine.
4. Wait at least 10 minutes for the engine oil to \frain back to the oil pan. 5. Place a large \frain pan un\fer the \frain plug.
6. Remove the \frain plug with a wrench.
7. Remove the oil filler cap an\f completely \frain the
oil.
If the oil filter is to be change\f, remove an\f
replace it at this time. (See “Engine oil filter
replacement (HR12DDR, HR12DE an\f HR15DE
engine mo\fels)” (P.8-12) .)
8. Clean an\f reinstall the \frain plug an\f new washer. Securely tighten the \frain plug with a wrench. Do
not use excessive force.
Drain plug tightening torque:29 to 39 N·m
(3.0 to 4.0 kg-m, 22 to 29 ft-lb)
9. Refill the recommen\fe\f engine oil an\f quantity. (See “Recommen\fe\f fuel/lubricants an\f capaci-
ties” (P.9-2) .)
When filling the engine oil, do not remove
the dipstick.
10. Securely install the oil filler cap.
11. Start the engine.
12. Check the \frain plug for any sign of leakage.
1\b. Check the engine oil level accor\fing to the proper proce\fure. (See “Checking engine oil level” (P.8-
10) .)
Engine oil filter replacement (HR12DDR,
HR12DE an\f HR15DE engine mo\fels)
JVM0059XHR12DDR engine model
&RQGLWLRQ