rims RENAULT SCENIC 2006 J84 / 2.G Power Assisted Steering Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2006, Model line: SCENIC, Model: RENAULT SCENIC 2006 J84 / 2.GPages: 56, PDF Size: 0.18 MB
Page 12 of 56
POWER ASSISTED STEERING
Fault finding - Configurations and programming36B
36B - 12V6 MR-366-X84-36B000$330_eng.mif
PAS
Vdiag No.: 04, 06, 08, 0C
and 12
SC001: COMPUTER CALIBRATION
NOTESThis configuration is performed after replacing the EPAS computer.
WARNING
The computer is supplied with the default calibration 0.
An incorrect configuration may damage the function.
Command SC001 is used to define the vehicle specifications.
The configuration is determined by the following specifications:
–Vehicle type:
–The diameter of the vehicle wheel rims:
–The vehicle engine type and gearbox type:
CALIBRATION PROCEDURE:
–Connect the diagnostic tool and select EPAS,
–select command SC001 Computer calibration,
–configure the computer in line with the vehicle definition,
–exit fault finding mode without switching off the tool (close the application only),
–switch off the ignition,
–wait 15 seconds for the end of power-Iatch then restart,
–make sure that the configuration reading corresponds to the desired calibration:
LC005 or ET026 Computer calibration.