check engine RENAULT SCENIC 2011 J95 / 3.G Air Bag ACU4 - Seat Belt Pretensioners Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2011, Model line: SCENIC, Model: RENAULT SCENIC 2011 J95 / 3.GPages: 68, PDF Size: 0.38 MB
Page 12 of 68
AIRBAG - SEAT BELT PRETENSIONERS
Fault finding – Replacement of components
88C-12
88C
V3 MR-372-J84-88C000$040.mif
AIRBAG ACU4
VDIAG No.: 04
AIRBAG - SEAT BELT PRETENSIONERS
Fault finding – Replacement of components
REPLACING THE AIRBAG COMPUTER
BEFORE REPLACING ANY COMPUTER, YOU ARE REQUIRED TO CONTACT YOUR
TECHLINE.
So that the failure of the returned computer can be analyzed, the use of command RZ001
"erase fault memory" when DF001 "Computer" is present or stored is officially prohibited.
The airbag computers are sold in locked mode to avoid all risk of accidental triggering (all ignition lines are
inhibited).
The locked mode is signalled when the airbag fault warning indicator lights up on the instrument panel.
Follow this procedure to replace an airbag computer:
– Ensure that the ignition is switched off.
– Replace the computer.
– Modify the computer configuration if necessary.
– Enter the VIN into the computer with diagnostic tool command VP010 Write VIN.
– Switch off the ignition.
– Carry out a check using the diagnostic tool.
– Enter the After Sales operation date with diagnostic tool command VP008 Write last After Sales operation
date.
– Unlock the computer only if no faults are indicated by the diagnostic tool.
After an ACU4 computer has been replaced with a RC5 computer, it is also necessary to replace the impact
sensors. The ACU4 sensors are incompatible with the RC5 computer.
Note:
After the airbag computer is replaced, if the engine no longer starts, restore the injection operation by applying the
following procedure:
– Run command RZ001 to clear the faults from the injection computer memory (even if no present or stored faults
are declared).
– Switch off the ignition and wait for loss of dialogue with the injection computer.
– Drive for 1 minute at a speed greater than 21 mph (35 km/h) to restore the operation of the steering column lock.
ACU4 Vdiag04 J84 1.0