technical specifications RENAULT SCENIC 2011 J95 / 3.G Air Bag ACU4 - Seat Belt Pretensioners Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2011, Model line: SCENIC, Model: RENAULT SCENIC 2011 J95 / 3.GPages: 68, PDF Size: 0.38 MB
Page 1 of 68
8Electrical equipment
V3 MR-372-J84-88C000$TOC.mif
V3
88C
"The repair procedures given by the manufacturer in this document are based on the
technical specifications current when it was prepared.
The procedures may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from
which his vehicles are constructed."
V3
All rights reserved by Renault s.a.s.
Edition Anglaise
Copying or translating, in part or in full, of this document or use of the service part
reference numbering system is forbidden without the prior written authority of
Renault s.a.s.
© Renault s.a.s. 2011
AIRBAG - SEAT BELT PRETENSIONERS
AIRBAG ACU4
Vdiag: 04
Fault finding - Introduction 88C - 2
Fault finding - System operation 88C - 9
Fault finding - Computer track allocation 88C - 10
Fault finding - Replacement of components 88C - 12
Fault finding - Configuration and programming 88C - 13
Fault finding - Summary table of faults 88C - 18
Fault finding - Interpretation of faults 88C - 19
Fault finding - Fault Interpretation 88C - 49
Fault finding - States and parameter summary table 88C - 66
Fault finding - Conformity check 88C - 67
Fault finding - Fault finding chart 88C - 68
Page 2 of 68
AIRBAG - SEAT BELT PRETENSIONERS
Fault finding - Introduction
88C - 2
88C
V3 MR-372-J84-88C000$010.mif
188C
AIRBAG ACU4
Vdiag: 04
AIRBAG - SEAT BELT PRETENSIONERS
Fault finding - Introduction
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding method applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this manual):
– Assisted fault finding (incorporated into the diagnostic tool), paper version (Workshop Repair Manual
or Technical Note) and Dialogys.
Wiring Diagrams:
– Visu-Diagram (CD-ROM), paper.
Type of diagnostic tools:
–CLIP
Special tooling required:Véhicule: SCENIC II
Function concerned: AIRBAGName of computer: AUTOLIV - ACU 4
Program no.:
Vdiag No.: 04
SPECIAL TOOLING REQUIRED
– Multimeter.
– Set of adapters and terminal blocks for using the airbag and
pretensioner wiring harness check function of CLIP and XRBAG
tools for updates including the terminal blocks listed below.
– Modifying the series of new airbag ignition module
connectors entails modifying the dummy ignition module.
LOCAL MODIFICATION OF THE DUMMY IGNITION MODULE:
–Remove the ignition module from its red mounting and
remove one of the brown locking notches.
– 22-track computer terminal block: Elé. 1685
– 64-track computer terminal block: Elé. 1717
– 22-track seat terminal block: Elé. 1687
– 10-track rotary switch terminal block: Elé. 1617
ACU4 Vdiag04 J84 1.0
MR-372-J84-88C000$010.mif