gearbox RENAULT SCENIC 2011 J95 / 3.G Engine And Peripherals EDC16 Injection Workshop Manual

[x] Cancel search | Manufacturer: RENAULT, Model Year: 2011, Model line: SCENIC, Model: RENAULT SCENIC 2011 J95 / 3.G
Pages: 236, PDF Size: 1.32 MB

Page 11 of 236

RENAULT SCENIC 2011 J95 / 3.G Engine And Peripherals EDC16 Injection Workshop Manual 13B - 11
DIESEL INJECTION
Fault finding - System operation13B
V10 MR-372-J84-13B150$094.mif
EDC16 INJECTION
Program No.: C1
Vdiag No: 44, 48 and 4C
Multiplex connection between the vehicles various c

13B - 11
DIESEL INJECTION
Fault finding - System operation13B
V10 MR-372-J84-13B150$094.mif
EDC16 INJECTION
Program No.: C1
Vdiag No: 44, 48 and 4C
Multiplex connection between the vehicle's various computers
The Mégane II electronic system is a multiplex network. This enables dialogue between the various vehicle
computers. As a result:
– the activation of the fault warning lights on the instrument panel is performed by the multiplex network, with the
vehicle speed sensor on the gearbox deactivated,
– the vehicle speed signal is transmitted by the ABS-ESP computer via the multiplex network.
The system can inject diesel fuel into the engine at a pressure of up to 1350 bar. Before each operation, check that
the injection rail is depressurised and that the fuel temperature is not too high.
When working on the high pressure injection system, you must follow the cleanliness guidelines and safety advice
specified in this document.
Removal of the internal parts of the pump and injectors is prohibited. Only the fuel flow actuator, the diesel fuel
temperature sensor and the air vent unit can be replaced.
For safety reasons, it is strictly prohibited to undo a high pressure pipe union when the engine is running.
It is not possible to remove the pressure sensor from the fuel rail because this may cause circuit contamination
faults. If the pressure sensor fails, the pressure sensor, the rail and the five high pressure pipes must be replaced.
It is strictly prohibited to remove any injection pump pulley bearing the number 070 575. If the pump needs to be
replaced, replace the pulley.
Supplying + 12 V directly to any component in the system is prohibited.
Ultrasonic decoking and cleaning are prohibited.
Never start the engine unless the battery is connected correctly.
Disconnect the injection computer when carrying out any welding work on the vehicle. IMPORTANT
The engine must not operate with:
– Diesel fuel containing more than 10 % diester,
– Petrol, even in tiny quantities.