remote control RENAULT TWINGO 2009 2.G Chasiss ESP Workshop Manual

38C -2V3 MR-413-X44-38C050$010.mif
38C
Bosch 8.1 ESP
Vdiag No.: 05
1. APPLICABILITY OF THE DOCUMENT
Th is d ocument p resents the fault finding procedure applica ble to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING:
Documentation type
Fault finding procedures (this document):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
–Visu-Schéma (CD-ROM), paper.
Type of diagnostic tools
–CLIP
Special tooling required
3. REMINDERS
Procedure
To run fault finding on the vehicle computers, switch on the ignition.
Depending on the type of vehicle equipment, proceed as follows:
To cut off + after ignition feed, proceed as follows:Vehicle: New TwingoComputer name: Bosch 8.1 ESP
Function concerned: Bosch ESPVdiag No.: 05
Special tooling required
Multimeter
Elé. 1681Universal bornier
For vehicles with key/radio frequency remote control, use the key to switch on the ignition.
For vehicles with a Renault card,
–with the vehicle card in the card reader,
–press and hold the start button (longer than 5 seconds) with start-up conditions not fulfilled,
connect the diagnostic tool and perform the required operations.
For vehicles with key/radio frequency remote control, use the key to switch off the ignition.
For vehicles with a Renault card,
press the Start button twice briefly (less than 3 seconds),
ensure that the + after ignition feed has been cut off by checking that the computer indicator lights on the instrument
panel have gone out.
ESP_V05_PRELI
ANTI-LOCK BRAKING SYSTEM
Fault finding – Introduction