ad blue RENAULT TWINGO 2009 2.G Chasiss - Power Assisted Steering Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2009, Model line: TWINGO, Model: RENAULT TWINGO 2009 2.GPages: 54
Page 16 of 54
36B-16
MR-413-X44-36B000$469.mif
V2
EPAS
Vdiag No.: 04 - 08
36B
DF001
PRESENT
OR
STOREDMOTOR THERMAL PROTECTION
DEF: Operating temperature too high
NOTESConditions for applying the fault finding procedure to stored faults:
Apply this fault finding procedure even if the fault is stored.
Notes:
This fault does not indicate a system failure, but indicates overheating either of the
Electric Power-Assisted Steering (EPAS) motor or of the computer during repeated
manoeuvres.This fault may appear after the steering wheel is moved repeatedly
(parking) and causes a gradual reduction in steering but the fault warning light does
not come on.
Use the diagnostic tool to check the conformity of PR129 Motor power (60 A) and PR130 Motor power (45 A)
(zero in absence of PR001 Torque applied to steering wheel).
Contact the Techline in the event of any nonconformity.
Check the conformity of the computer and steering column (45 or 60 A) in relation to the table below:
Left-hand drive Right-hand drive
Torque sensor wiring harness blue black
Motor wiring45 Agreen black
Motor wiring60 Ablue grey
45 A 60 A
Computer label yellow white
In the event of a nonconformity, consult "RENAULT NET" to repair the vehicle according to the technical vehicle
definition.
Disconnect the battery then allow the electric power-assisted steering to cool down.
Reconnect the battery, clear the faults, start the vehicle and check the operation of the electric power-assisted
steering by turning the steering wheel full lock to the left or right.
The fault should not recur in the next 30 seconds.
If the fault recurs as present or stored, contact the Techline.
AFTER REPAIRDeal with any other faults.
Clear the stored faults.
Check that the EPAS is working.
DAE_V04_DF001 /DAE_V08_DF001
POWER – ASSISTED STEERING
Fault finding – Interpretation of faults
Page 49 of 54
36B-49
MR-413-X44-36B000$938.mif
V2
POWER – ASSISTED STEERING
Fault finding – Fault finding Chart
EPAS
Vdiag No.: 04 - 08
36B
ALP 7 PERMANENT ASSISTANCE
NOTESOnly consult this customer complaint after a complete check with the
diagnostic tool.
Check the conformity of the computer and the steering column (45 or 60 A) in relation to the table below:
Left-hand drive Right-hand drive
Torque sensor wiring harness blue black
Motor wiring 45 A green black
Motor wiring 60 A blue grey
45 A 60 A
ECU label yellow white
In the event of non-conformity, consult RENAULT NET to repair the vehicle according to the technical vehicle
definition.
Check that the configuration reading LC002 Strategy number corresponds to the vehicle equipment.
Configure the computer correctly using the diagnostic tool, if necessary (see Configuration).
Check the pressure and condition of the tyres, the condition of the joints and the front axle geometry.
If the fault is still present, contact Techline.
AFTER REPAIRPerform a test using the diagnostic tool.
DAE_V04_ALP7/ DAE_V08_ALP7