key RENAULT TWINGO 2009 2.G Electrical Equipment - Airbags And Pretensioners Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2009, Model line: TWINGO, Model: RENAULT TWINGO 2009 2.GPages: 67, PDF Size: 0.3 MB
Page 2 of 67
88C-2
MR-413-X44-88C000$077.mif
V3
88C
AIRBAGS AND PRETENSIONERS
Fault finding - Introduction
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding procedure applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this manual):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
–Visu-Schéma (CD-ROM), paper.
Type of diagnostic tools
–CLIP
Special tooling required
3. REMINDERS
To run fault finding on the vehicle computers, switch on the ignition. Proceed as follows:
–turn the ignition key to APC,
–connect the diagnostic tool and perform the required operations.
To cut off the + after ignition feed, proceed as follows:
–disconnect the diagnostic tool,
–turn the ignition key to OFF,
–verify that the forced + after ignition feed has been switched off by checking that the computer warning lights on
the control panel have gone out. Vehicle (s): New TWINGO
Function concerned: AIRBAGName of computer: TEMIC MRSZ
Vdiag No.: 04
Special tooling required
Multimeter
–Dummy module (Part no. Elé. 1835 yellow)
–Dummy module (Part no. Elé. 1837 - 2)
–Dummy module (Part no. Elé. 1837 - 5)
–Dummy module (Part no. Elé. 1837 - 6)
ABGMRSZ_V04_PRELI
MR-413-X44-88C000$077.mif
MRSZ AIRBAG
Vdiag: 04
Page 8 of 67
88C-8
MR-413-X44-88C000$154.mif
V3
MRSZ AIRBAG
Vdiag: 04AIRBAGS AND PRETENSIONERS
Fault finding - List and location of components88C
Version 10 trigger lines (continued)
Number Description
1Driver's frontal airbag
2Passenger frontal airbag
3Side chest-level airbag (passenger or driver)
4Rear curtain airbag (passenger or driver)
5Rear seat belt pyrotechnic retractor
6Lap belt pyrotechnic pretensioner (passenger and driver)
7Airbag computer
8Driver's seat belt buckle sensor
9Side impact sensor (passenger or driver)
10 Sensor for front passenger airbag inhibition by key
11 Instrument panel
12 Information to other systems (transmission via CAN)
(*) Component which can be deactivated by key
Page 10 of 67
88C-10
MR-413-X44-88C000$154.mif
V3
MRSZ AIRBAG
Vdiag: 04AIRBAGS AND PRETENSIONERS
Fault finding - List and location of components88C
Version: 6 trigger lines (continued)
Number Description
1Driver's frontal airbag
2Passenger frontal airbag
3Side chest-level airbag (passenger or driver)
4Lap belt pyrotechnic pretensioner (passenger or driver)
5Airbag computer
6Driver's seat belt buckle sensor
7Side impact sensor (passenger or driver)
8Instrument panel
9Sensor for front passenger airbag inhibition by key
10 Information to other systems (transmission via CAN)
(*) Component which can be deactivated by key
Page 12 of 67
88C-12
MR-413-X44-88C000$154.mif
V3
MRSZ AIRBAG
Vdiag: 04AIRBAGS AND PRETENSIONERS
Fault finding - List and location of components88C
Version: 4 trigger lines (continued)
Number Description
1Driver's frontal airbag
2Passenger frontal airbag
3Lap belt pyrotechnic pretensioner (passenger or driver)
4Airbag computer
5Driver's seat belt buckle sensor
6Sensor for front passenger airbag inhibition by key
7Instrument panel
8Information to other systems (transmission via CAN)
(*) Component which can be deactivated by key (according to fault finding configuration)
Page 13 of 67
88C-13
MR-413-X44-88C000$154.mif
V3
MRSZ AIRBAG
Vdiag: 04AIRBAGS AND PRETENSIONERS
Fault finding - List and location of components88C
1 - "Airbag Off" warning light:
The "airbag off" warning light is representative of the passenger airbag and passenger chest airbag inhibition status
if fitted.
–"off" = passenger airbag (switch on "ON") and passenger chest airbag (if fitted) active,
–"on" = passenger airbag (switch on "OFF" or fault detected on the switch line) and passenger chest
airbag (if fitted) inactive.
The "Airbag Fault" warning light comes on under the following conditions:
–detection and registering of an airbag system fault,
–a crash has been detected and registered,
–the computer is "crash locked" by the diagnostic tool,
–the computer must be programmed or reprogrammed.
2 - Passenger airbag inhibitor:
The passenger airbag inhibitor (by key) informs the airbag computer of a request to inhibit the passenger front airbag
and passenger chest airbag, if fitted.
3 - Driver's seat belt buckle sensor:
The seat belt buckle sensor gives the airbag computer the signal of whether the driver's belt is fastened or not.
4 - The driver and passenger buckle pyrotechnic pretensioners:
The buckle pyrotechnic pretensioner is integrated into the front seat belt buckle.
The pretensioner holds the occupant in the seat in the event of a crash.
5 - The driver and passenger rear seat belt pyrotechnic retractors:
The rear seat belt pyrotechnic retractor is integrated into the rear seat belt inertia reel.
The pyrotechnic seat belt retractor holds the occupant in the seat in the event of a crash.
Page 17 of 67
88C-17
MR-413-X44-88C000$308.mif
V3
MRSZ AIRBAG
Vdiag: 04AIRBAGS AND PRETENSIONERS
Fault finding - Function88C
By default, when the key is in the inhibition position, the following protections and signals are inhibited in the event of
a crash:
–Passenger front air bag.
–Passenger chest-level airbag, if fitted.
The passenger front airbag and passenger chest-level airbag are inhibited when the locking switch is
positioned on OFF or when DF028 "PASSENGER AIRBAG STATUS INDICATOR LIGHT CIRCUIT" or DF193
"PASSENGER AIRBAG LOCKING STATUS CHANGE" is present in the computer memory.
–Seat belt locking monitoring:
This function is carried out by the instrument panel (seat belt reminder indicator light and buzzer). The MRSZ
computer only sends the driver's seat belt buckle sensor status.
An instrument panel warning light indicates that the seat belt is not being worn by the driver and a beep sounds as a
reminder when the vehicle speed exceeds 12 mph (20 km/h).
–Monitoring the information displayed on the instrument panel:
The instrument panel controls the correct operation of the "Airbag fault" and "Airbag OFF" warning lights and
informs the airbag computer, via the multiplex network, of any possible malfunctions in the warning light circuits.
Page 20 of 67
88C-20
MR-413-X44-88C000$462.mif
V3
MRSZ AIRBAG
Vdiag: 04AIRBAGS AND PRETENSIONERS
Fault finding - Configurations and programming88C
CONFIGURATIONS/CONFIGURATION READINGS (continued)
Passenger airbag locking mode "BY KEY" or "WITHOUT"
Vehicle type reading: LC034 "VEHICLE TYPE" (New Twingo)
OTHER COMMANDS
–VP006: LOCK COMPUTER
This command should be used for any operation on the system. It permits inhibition of all trigger lines.
–VP007: UNLOCK COMPUTER
This command is used to unlock the computer when it is new or has been inhibited by command
VP006.
–VP010: WRITE VIN
This command is used to enter the VIN number into the computer.
–SC004: READ IMPACT CONTEXTS
Use this command during repair of the vehicle following an impact. The command enables the list of
trigger lines active and the system status upon impact to be accessed in the computer which is being
replaced.
CLEARING
–RZ001: FAULT MEMORY
This command is used for clearing the stored faults from the computer.Diagnostic tool titleConfiguration
readingConfiguration
Passenger airbag locking modeLC060 CF248