navigation RENAULT TWINGO 2009 2.G Electrical Equipment - Radio R01-08 User Guide

86A-80
AFTER REPAIRCarry out another fault finding check on the system.
Deal with any faults.
V2 MR-413-X44-86A100$190.mif
RADIO
Fault finding – Fault Finding Chart86A
R01-08
Vdiag No.: A4
ALP 8Backlighting does not change when the vehicle lights are
switched on
NOTESUse the Wiring Diagrams Technical Note for Clio III or New Twingo.
NOTE: Switch on the side lights and position the lighting rheostat wheel in the centre
position.
The display, component code 653, is only available when the vehicle does not have
the navigation function.
The multimedia connection unit, component code 1714, is only available when the
vehicle has the navigation function.
Check the backlighting of the following components:
radio, display and instrument panel.
Are all of the components backlit?
Attempt to backlight these components
once again, and if no conclusion can be
made, contact the Techline.
Does the instrument panel light up?Perform fault finding on the instrument
panel (see 83A, Instrument panel).
YES
NO
NO
YES
A
R108_VA4_ALP8

86A-90
AFTER REPAIRCarry out another fault finding check on the system.
Deal with any faults.
V2 MR-413-X44-86A100$190.mif
RADIO
Fault finding – Fault Finding Chart86A
R01-08
Vdiag No.: A4
ALP 15 Fault when using the mobile connectivity terminal
NOTESSee Clio III or New Twingo wiring diagrams.
ALP 15 is used to run fault finding on the mobile connectivity terminal if a mobile
connectivity computer is not fitted on the vehicle.
In a vehicle equipped with a navigation computer, the terminal is connected to the
navigation computer, component code 662. Otherwise, it is connected to the radio,
component code 261.
Is the mobile device connected to the mobile connectivity
terminal switched on and is the volume sufficient?Increase the volume of the
mobile device.
Does the customer's mobile device operate correctly with
earphones that are in good condition?Explain to the customer that the
mobile device is defective.
Check the condition (appearance check) of the cable
connecting the mobile device to the analogue terminal.
Explain to the customer that the
cable of the mobile device is
faulty. Are the checks correct?
NO
YES
NO
YES
NO
YES
A
R108_VA4_ALP15