ESP RENAULT TWINGO 2009 2.G Engine Starting Charging Workshop Manual

16A-5
MR-413-X44-16A000$500.mif
V2
16A
STARTING-CHARGING
Fault finding – Features
The function of the charging circuit is to:
●Ensure electrical energy is supplied to the vehicle whilst respecting the dynamic performance constraints
of the engine and transmission assembly: the alternator resisting torques and the torque gradients
measured must be managed.
●To control alternator loading and load shedding during engine management authorisation or variation of
the electrical load.
●To ensure the quality of the on board network voltage in terms of the voltage level and variation
(voltage gradient management).
●To optimise the battery charge by applying a voltage to its terminals correlating to its initial charge status
(in sleep mode) and to its internal temperature.
●To inform the engine management about the mechanical power taken from the accessories pulley,
the alternator charge rate and the rotor excitation current value.
●To run fault finding on the charging circuit: “Battery” warning light display.
The function of the starting circuit is to:
●Start the vehicle during a starting request with the ignition key if necessary. New Twingo
MR-413-X44-16A000$500.mif

16A-16V2 MR-413-X44-16A000$875.mif
16A
New Twingo
NOTESPerform this test only after running complete fault finding on the UCH using the
diagnostic tool (see 87B, UCH).
Because the UCH houses the CHARGING CIRCUIT function (sub-function: alternator)
and checks the alternator via a serial connection (BSS).
CHARGING
ALTERNATOR SUPPLY TEST TEST1
STARTING-CHARGING
Fault finding – Tests

16A-18V2 MR-413-X44-16A000$875.mif
STARTING-CHARGING
Fault finding – Tests16A
New Twingo
TEST1
CONTINUED 1
Keep the engine speed at 3000 rpm with all consumers switched on.
Main beam headlights, de-icing, passenger compartment ventilation.
Value of measured current? (i 2)
Compare i 1 and i 2
i 2 > i 1 + 5A i 2 < i 1 + 5A
The alternator flow rate is
correctReplace the alternator (see MR
411, 16A, Starting - Charging,
Alternator: Removal -
Stop the engine
Value of the electrical current?
> 1A < 1A
Replace the alternator
(see corresponding MR, 16A,
Starting - Charging, Alternator:
Removal - Refitting).Alternator is correct
A