battery RENAULT TWINGO RS 2009 2.G Air Conditioning Workshop Manual

61A-7
HEATING
Front side air distribution duct: Removal - Refitting
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
1 - Front left-hand side air distribution duct:
aLock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 413 Fault finding, 88C, Airbags and pretension-
ers).
aDisconnect the battery (see Battery: Removal - Re-
fitting) (MR 411, 80A, Battery).
aRemove the passenger's front airbag (see Passen-
ger's frontal airbag: Removal - Refitting) (MR
411, 88C, Airbags and pretensioners).
2 - Front right-hand side air distribution duct
aUnclip the upper storage compartment on the driv-
er's side (1) .II - OPERATION FOR REMOVAL OF PART
CONCERNED
Front left-hand side air distribution duct:
aPull out the front left-hand side air distribution duct at
(2) .
aRemove the front left-hand side air distribution duct
from above.
Front right-hand side air distribution duct:
aPull out the front right-hand side air distribution duct
at (3) .
aRemove the front right-hand side air distribution duct
from above. Equipment required
Diagnostic tool
119502
119503
119701

61A-8
HEATING
Front side air distribution duct: Removal - Refitting
61A
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
aRefit the front right-hand side air distribution duct
from above.
aFit the front right-hand side air distribution duct.
II - FINAL OPERATION.
aClip on the upper storage compartment on the driv-
er’s side.
aRefit the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411, 88C,
Airbags and pretensioners).
aConnect the battery (see Battery: Removal - Refit-
ting) (MR 411, 80A, Battery).
aUnlock the airbag computer using the Diagnostic
tool (see Fault finding - Replacement of compo-
nents) (MR 413 Fault finding, 88C, Airbags and pre-
tensioners).

61A-9
HEATING
Front centre air distribution duct: Removal - Refitting
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aLock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 413 Fault finding, 88C, Airbags and pretension-
ers).
aDisconnect the battery (see Battery: Removal - Re-
fitting) (MR 411, 80A, Battery).
aRemove the passenger's front airbag (see Passen-
ger's frontal airbag: Removal - Refitting) (MR
411, 88C, Airbags and pretensioners).
aUnclip the upper storage compartment on the driv-
er's side (1) .
aRemove the instrument panel (see Instrument pan-
el: Removal - Refitting) (MR 411, 83A, Instrument
panel).aUnclip the centre air vent and trim (2) .
aDisconnect the hazard warning lights switch connec-
tor.
aRemove:
-the centre air vent and trim,
-the control panel (see 61A, Heating, Control pan-
el: Removal - Refitting, page 61A-65) . Equipment required
Diagnostic tool
119502
119518

61A-10
HEATING
Front centre air distribution duct: Removal - Refitting
61A
II - OPERATION FOR REMOVAL OF PART
CONCERNED
aRemove the mounting bolt from the front centre air
distribution duct.
aUnclip on the front centre air distribution duct (3) .
aRemove the front centre air distribution duct from
above.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
aRefit the front centre air distribution duct from above.
aClip on the front centre air distribution duct.
aRefit the mounting bolt from the front centre air dis-
tribution duct.
II - FINAL OPERATION.
aConnect the hazard warning lights switch connector.
aRefit:
-the control panel (see 61A, Heating, Control pan-
el: Removal - Refitting, page 61A-65) ,
-the centre air vent and trim.
aClip on the centre air vent and trim.
aRefit the instrument panel (see Instrument panel:
Removal - Refitting) (MR 411, 83A, Instrument
panel).aClip on the upper storage compartment on the driv-
er’s side.
aRefit the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411, 88C,
Airbags and pretensioners).
aConnect the battery (see Battery: Removal - Refit-
ting) (MR 411, 80A, Battery).
aUnlock the airbag computer using the Diagnostic
tool (see Fault finding - Replacement of compo-
nents) (MR 413 Fault finding, 88C, Airbags and pre-
tensioners).
119699

61A-11
HEATING
Front footwell air distribution duct: Removal - Refitting61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aLock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 413 Fault finding, 88C, Airbags and pretension-
ers).
aDisconnect the battery (see Battery: Removal - Re-
fitting) (MR 411, 80A, Battery).
aRemove:
-the driver's front airbag (see Driver's frontal air-
bag: Removal - Refitting) (MR 411, 88C, Airbags
and pretensioners),
-the steering wheel (see Steering wheel: Removal
- Refitting) (MR 411, 36B, Power-assisted steer-
ing),
-the steering column switch assembly (see Steer-
ing column switch assembly: Removal - Refit-
ting) (MR 411, 84A, Control - Signals),
-the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411,
88C, Airbags and pretensioners),
-the instrument panel (see Instrument panel: Re-
moval - Refitting) (MR 411, 83A, Instrument pan-
el),
-the control panel (see 61A, Heating, Control pan-
el: Removal - Refitting, page 61A-65) .
aRemove the tweeter speakers (see Tweeter: Re-
moval - Refitting) (MR 411, 86A, Radio).
aRemove the radio (see Radio: Removal - Refitting)
(MR 411, 86A, Radio).aRemove the glovebox.
aRemove:
-the centre console (see Centre console: Removal
- Refitting) (MR 412, 57A, Interior equipment),
-the dashboard (see Dashboard: Removal - Refit-
ting) (MR 412, 57A, Interior equipment),
-the A-pillar trims (see Windscreen pillar trim: Re-
moval - Refitting) (MR 412, 71A, Body internal
trim).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
1 - Front right-hand footwell air distribution duct
aRemove:
-the bolts (1) from the front right-hand footwell air
distribution duct.
-the front right-hand footwell air distribution duct. Equipment required
Diagnostic tool
WITH 2 SPEAKERS, WITHOUT RADIO or RADIO
NO. 01 or RADIO NO. 03
RADIO NO. 01 or RADIO NO. 03
WITH 2 SPEAKERS, WITHOUT RADIO or VEHI-
CLE WITHOUT RADIO
119703

61A-13
HEATING
Front footwell air distribution duct: Removal - Refitting61A
aRemove the tweeter speakers (see Tweeter: Re-
moval - Refitting) (MR 411, 86A, Radio)
aRefit:
-the control panel (see 61A, Heating, Control pan-
el: Removal - Refitting, page 61A-65) ,
-the instrument panel (see Instrument panel: Re-
moval - Refitting) (MR 411, 83A, Instrument pan-
el),
-the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411,
88C, Airbags and pretensioners),
-the steering column switch assembly (see Steer-
ing column switch assembly: Removal - Refit-
ting) (MR 411, 84A, Control - Signals),
-the steering wheel (see Steering wheel: Removal
- Refitting) (MR 411, 36B, Power-assisted steer-
ing),
-the driver's front airbag (see Driver's frontal air-
bag: Removal - Refitting) (MR 411, 88C, Airbags
and pretensioners).
aConnect the battery (see Battery: Removal - Refit-
ting) (MR 411, 80A, Battery).
aUnlock the airbag computer using the Diagnostic
tool (see Fault finding - Replacement of compo-
nents) (MR 413 Fault finding, 88C, Airbags and pre-
tensioners). WITH 2 SPEAKERS, WITHOUT RADIO or RADIO
NO. 01 or RADIO NO. 03

61A-14
HEATING
Recirculation control cable: Removal - Refitting
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aLock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 413 Fault finding, 88C, Airbags and pretension-
ers).
aDisconnect the battery (see Battery: Removal - Re-
fitting) (MR 411, 80A, Battery).
aUnclip the upper storage compartment on the driv-
er's side (1) .
aRemove:
-the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411,
88C, Airbags and pretensioners),
-the instrument panel (see Instrument panel: Re-
moval - Refitting) (MR 411, 83A, Instrument pan-
el).aUnclip the « trim - air vent » assembly (2) .
aDisconnect the hazard warning lights switch connec-
tor.
aRemove the « trim - air vent » assembly (2) .
aUnclip:
-the fuse access flap (3) ,
-the dashboard lower trim. Equipment required
Diagnostic tool
119502
119518
119506

61A-16
HEATING
Recirculation control cable: Removal - Refitting
LEFT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
61A
-the fuse access flap.
aConnect the hazard warning lights switch connector.
aClip on the « trim - air vent » assembly.
aRefit:
-the instrument panel (see Instrument panel: Re-
moval - Refitting) (MR 411, 83A, Instrument pan-
el),
-the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411,
88C, Airbags and pretensioners).
aClip on the upper storage compartment on the driv-
er's side.
aConnect the battery (see Battery: Removal - Refit-
ting) (MR 411, 80A, Battery).
aUnlock the airbag computer using the Diagnostic
tool (see Fault finding - Replacement of compo-
nents) (MR 413 Fault finding, 88C, Airbags and pre-
tensioners).

61A-17
HEATING
Recirculation control cable: Removal - Refitting
RIGHT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
61A
REMOVAL
I - REMOVAL PREPARATION OPERATION
aLock the airbag computer using the Diagnostic tool
(see Fault finding - Replacement of components)
(MR 413, 88C, Airbags and pretensioners).
aDisconnect the battery (see Battery: Removal - Re-
fitting) (MR 411, 80A, Battery).
aUnclip the upper storage compartment on the driv-
er's side.
aRemove:
-the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411,
88C, Airbags and seat belt pretensioners),
-the instrument panel (see Instrument panel: Re-
moval - Refitting) (MR 411, 83A, Instrument pan-
el).aUnclip the « trim - air vent » assembly (2) .
aDisconnect the hazard warning lights switch connec-
tor.
aRemove the « trim - air vent » assembly (2) .
II - REMOVAL OPERATION FOR PART
CONCERNED
aUnclip the recirculation control cable from the control
panel (6) .
aRemove the control panel ball joint (7) . Equipment required
Diagnostic tool
124106
124105
119696

61A-18
HEATING
Recirculation control cable: Removal - Refitting
RIGHT-HAND DRIVE, and AIR CONDITIONING or STANDARD HEATING
61A
aUnclip the recirculation control cable (8) from the
distribution unit.
aPress on the tab (9) .
aRemove the distribution unit ball joint (10) .
aRemove the recirculation control cable.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
aRefit the recirculation control cable.
aFit the ball joint on the distribution unit.
aPress on the tab.
aClip the recirculation control cable on the distribution
unit.
aFit the ball joint to the control panel.
aClip the recirculation control cable on the control
panel.
II - FINAL OPERATION.
aConnect the connector to the hazard warning light
switch.
aRefit the « trim - air vent » assembly
aClip on the « trim - air vent » assembly.aRefit:
-the instrument panel (see Instrument panel: Re-
moval - Refitting) (MR 411, 83A, Instrument pan-
el),
-the passenger's front airbag (see Passenger's
frontal airbag: Removal - Refitting) (MR 411,
88C, Airbags and seat belt pretensioners).
aClip on the upper storage compartment, on the driv-
er's side.
aConnect the battery (see Battery: Removal - Refit-
ting) (MR 411, 80A, Battery).
aUnlock the airbag computer using the Diagnostic
tool (see Fault finding - Replacement of compo-
nents) (MR 413, 88C, Airbags and pretensioners).
124100