battery replacement RENAULT TWINGO RS 2009 2.G Electrical Equipment - Battery Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2009, Model line: TWINGO RS, Model: RENAULT TWINGO RS 2009 2.GPages: 8, PDF Size: 0.05 MB
Page 2 of 8
80A-2
MR-413-X44-80A000$250.mif
V4
80A
BATTERY
Battery – Initialisation
When removing or disconnecting the battery, check that the battery is working correctly by performing a number of
initialisations on different vehicle functions. These initialisations do not require a tool of any kind.
Anti-theft code:
–Entering a 4-digit radio or radionavigation code (see 86A, Radio, Radio: Protection code). Setting the time on
the radio or the radio navigation system:
–To set the radio navigation system time, enter the four digit code. Insert the navigation CD-ROM then drive the
vehicle to pick up the satellite signals. It is now possible to set the time (see 86A, Radio, Radio: Setting the
time).
Initialisation of the window winders:
–Check that the electric windows are still initialised. The windows should open and close when the switch is
pressed. If this does not happen, re-initialise (see 87D, Electric windows - sunroof, Electric windows:
Initialisation).
Initialising the sunroof:
–Check that the sunroof is still initialised. The sunroof should open or close to the requested position without
stopping. If this does not happen, re-initialise (see 87D, Electric windows - Sunroof, Electric sunroof:
Initialisation).
Initialising the electric power assisted steering:
–In order that the electric power-assisted steering recognises the "steering wheel angle" signal, move the steering
wheel from lock to lock with the engine running (see 36B, Power-assisted steering, Fault finding -
Replacement of components).
Initialising the computers:
– The other computers are automatically initialised when the vehicle is being driven. Drive the vehicle for at least
1 minute at a speed greater than 18 mph (30 km/h) so that the tyre pressures are displayed again.
MR-413-X44-80A000$250.mif
Page 5 of 8
80A-5
MR-413-X44-80A000$750.mif
V4
80A
BATTERY
Battery – Check
Test procedure using the MIDTRONICS tool
Test conditions
The measurement must be taken when the vehicle is stationary and the ignition is off.
If the engine has been run in the last hour, switch the battery status to test and carry out the following operations:
•engine switched off,
•switch on the main beam headlights for 2 minutes,
•switch off the main beam headlights,
•wait for 2 minutes,
•switch off the ignition.
Equipment to be used:
•Tester approved by the Service Department: MIDTRONICS MICRO R330.
•Tool available as part no.: Elé. 1593.
•Equipment available in France from the Parts Department.
•Tool available in 6 languages.
For other countries, consult your contact in your country. Special tooling required
Elé. 1593 Battery tester
MIDTRONICS R330
WARNING
Failure to observe the procedure or poorly maintained equipment may result in incorrect measurements, which
could be:
–detrimental to the customer (the battery is not sound),
–detrimental to RENAULT (unnecessary replacement of a sound or rechargeable battery),
–detrimental to the dealership (if the battery is tested as sound or rechargeable for a part return under
warranty, the warranty reimbursement request will be cancelled).
MR-413-X44-80A000$750.mif