stop start RENAULT TWINGO RS 2009 2.G Electrical Equipment - Instrument Panel Workshop Manual

83A-17
MR-413-X44-83A000$224.mif
V5
INSTRUMENT PANEL
Fault finding - Function

Vdiag No.: 04, 08
83A
–Illumination of the “Particle filter” warning light:
Illumination of the “Particle filter” warning light indicates a minor particle filter fault to the driver.
If the “Service” warning light and “Particle filter” warning light come on simultaneously, refer to the “Service warning
light illumination” insert.
The New Twingo does not currently have a particle filter.
–Illumination of the “Major Electric Power-Assisted Steering fault warning” warning light:
Illumination of the “major electric power-assisted steering fault warning” warning light is requested by the electric
power-assisted steering up to 1 second after the engine is started.
If the “Stop” warning light and “Stop buzzer” are activated simultaneously, refer to the “Stop warning light
illumination” insert.
–Illumination of the “OBD” warning light
If the “OBD” warning light and “Service” warning lights come on simultaneously, refer to the “Service warning light
illumination” insert.
–Illumination of the “airbag fault” warning light:
Illumination of the “Airbag fault” warning light indicates an airbag warning light test phase by the instrument panel.
If the “Service” warning light and “Airbag fault” warning light come on simultaneously, refer to the “Service warning
light illumination” insert.
–Illumination of the “Passenger airbag disconnection” warning light:
Illumination of the “Passenger airbag disconnection” warning light indicates deactivation of the front passenger
airbag.

83A-26
MR-413-X44-83A000$448.mif
V5
INSTRUMENT PANEL
Fault finding - Interpretation of faults

Vdiag No.: 04, 08
83A
DF009
PRESENT
OIL PRESSURE SENSOR
1.DEF: Signal incoherent
NOTESSpecial note:
This check must be carried out with the engine stopped.
1.DEF
NOTESThe fault is declared present if the oil pressure sensor is not
detected as closed when the engine is stopped.
Top up the oil level before starting the check.
Look for any damage to the wiring harness and check the condition and connection of the oil pressure switch
and its connections.
Look for possible damage to the wiring harness, check the connection and condition of the instrument panel
connector.
If there is a repair method (see Technical Note 6015A, Electrical wiring repair, Wiring: Precautions for repair)
repair the connector, otherwise replace the wiring.
Check the insulation and continuity of the following connection:
Connection 28A between component 205 and component 247.
If there is a repair method (see Technical Note 6015A, Repairing electrical wiring, Wiring: Precautions for
repair) repair the wiring, otherwise replace it.
If the fault is still present, contact the Techline.
AFTER REPAIRDeal with any faults displayed by the diagnostic tool.
Clear the computer memory.
Carry out a road test followed by another check with the diagnostic tool.
TDB_V04_DF009P / TDB_V08_DF009P