ignition RENAULT TWINGO RS 2009 2.G Electrical Equipment - Radio Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 2009, Model line: TWINGO RS, Model: RENAULT TWINGO RS 2009 2.GPages: 42, PDF Size: 0.29 MB
Page 7 of 42
86A-7
MR-413-X44-86A000$378_eng.mif
V1
86A
RADIO
General Information
For repairs or fault finding, the receiver is fitted with a test menu (see radio self-test procedure).
The radio will operate for approximately 20 minutes without the ignition being switched to the accessories position.
The radio bleeps then switches off.
Notes:
●All radios are designed to control a CD changer.
●There is a special procedure for replacing the CD changer located in the dashboard front panel.
RADIO FUNCTION
The tuner has three selection modes displayed on the screen and accessible from the radio front panel:
–manual mode (MANU),
–preset mode (PRESET),
–alphabetical mode (LIST).
CD FUNCTION
The CD player can play conventional discs and any audio tracks on a CD-ROM.
CDs can be played in order or tracks can be chosen at random.
If a CD changer is being used, random play is possible on only one of the possible 6 compact discs.
THERMAL PROTECTION
If the radio temperature is too high for it to function properly, the volume is automatically reduced (without changing
the volume shown in the display).
Should one of the speaker tracks short circuit, the supply to the amplifier will be cut off.
VOLUME CONTROL
The volume can be increased according to the vehicle speed. To activate the function, select the desired volume
adjustment curve in expert mode (press and hold the source button until you hear a bleep): SPEED 5 for maximum
increase, 0 to switch off the increase function.
*RDS: Radio Data System
MR-413-X44-86A000$378_eng.mif
Page 20 of 42
86A-20
MR-413-X44-86A000$819_eng.mif
V1
RADIO
Fault finding chart86A
ALP 3The radio does not switch on automatically or switches off
after 20 minutes
Check that the system is operating correctly.
–Switch to + after ignition position.
–Switch on the radio.
–Switch off the + after ignition feed; the radio
should switch off.
–Switch on + after ignition feed again; the
radio should switch on.
Has the fault disappeared?
NO
Check the + accessories feed with a
multimeter.
Is there + 12 V on connection SP2 of the radio
(component 261)?
YES
Replace the radio.
YESEnd.
NOCheck supply fuse F29 (15A) (see Wiring
Diagrams Technical Note for New Twingo,
code 1016).
A