48A-2
NON-SIDE OPENING ELEMENTS
Bonnet: Removal - Refitting
48A
2 - OPERATION FOR REMOVAL OF PART
CONCERNED
aRemove:
-the bolts (4) ,
-the bonnet.
IV - REFITTING BY MEANS OF THE BONNET
HINGE BOLTS
1 - OPERATION FOR REFITTING PART
CONCERNED
aRefit:
-the bonnet,
-the bolts (4) .
aAdjust the opening clearances and flush fitting (see
48A, Non-side opening elements, Bonnet: Remo-
val - Refitting, page 48A-1) .
2 - FINAL OPERATION
aClip on the pipe at (2) .
aConnect the pipe at (1) .
aRefit:
-the front wing (see 42A, Front upper structure,
Front wing: Removal - Refitting, page 42A-3) ,
-the halogen headlights (see Halogen headlight:
Removal - Refitting) (MR 411, 80B, Headlights),
-the front bumper (see Front bumper: Removal -
Refitting) (MR 412, 55A, Exterior protection),-the front wheel arch liner (see Front wheel arch
liner: Removal - Refitting) (MR 412, 55A, Exterior
protection).
121519
48A-4
NON-SIDE OPENING ELEMENTS
Bonnet: Adjustment
48A
ADJUSTMENT
aFor information on the adjustment values for the
bonnet (see Vehicle panel gaps: Adjustment va-
lue) (MR 412, 01C, Vehicle bodywork specifica-
tions).
aThere are two options for adjusting the bonnet:
-using the bonnet bolts,
-using the bonnet hinge bolts. This operation requi-
res the removal of the front wheel arch liner (see
Front wheel arch liner: Removal - Refitting) (MR
412, 55A, Exterior protection).
aObserve the adjustment sequence.aSymbols A, B, C and D show the adjustment op-
tions.
The black dot in the centre represents the body of
the bolt.
The grey section represents the component to be
adjusted.
The white section represents the adjustment area.
121253
109496
48A-5
NON-SIDE OPENING ELEMENTS
Bonnet: Adjustment
48A
I - ADJUSTMENT BY MEANS OF THE BONNET
BOLTS
aLoosen the bolts (5) .
aAdjust the bonnet panel gaps.
aTighten the bolts (5) .
II - ADJUSTMENT BY MEANS OF THE BONNET
HINGE BOLTS
aRemove the front wheel arch liner (see Front wheel
arch liner: Removal - Refitting) (MR 412, 55A, Ex-
terior protection).
aLoosen the bolts (6) .
aAdjust the bonnet flush fitting.
aTighten the bolts (6) .
aRefit the front wheel arch liner (see Front wheel
arch liner: Removal - Refitting) (MR 412, 55A, Ex-
terior protection).
121818
