buttons SATURN AURA HYBRID 2007 Owners Manual

To unlatch the belt, just push the button on the
buckle. The belt should go back out of the way.
Before you close the door, be sure the belt is out
of the way. If you slam the door on it, you can
damage both the belt and your vehicle.
Shoulder Belt Height Adjustment
Before you begin to drive, move the shoulder belt
adjuster to the height that is right for you.
Adjust the height so that the shoulder portion of
the belt is centered on your shoulder. The
belt should be away from your face and neck, but
not falling off your shoulder. Improper shoulder
belt height adjustment could reduce the
effectiveness of the safety belt in a crash.
To move it down,
squeeze the buttons (A)
on the sides of the
height adjuster
and move the height
adjuster to the desired
position.
After you move the adjuster to where you want it,
try to move it down without squeezing the
buttons to make sure it has locked into position.
30

{CAUTION:
It can be dangerous to get out of your
vehicle if the shift lever is not fully in
PARK (P) with the parking brake rmly
set. Your vehicle can roll. Do not leave
your vehicle when the engine is running
unless you have to. If you have left the
engine running, the vehicle can move
suddenly. You or others could be injured.
To be sure your vehicle will not move,
even when you are on fairly level ground,
always set the parking brake and move
the shift lever to PARK (P).
Follow the proper steps to be sure your vehicle
will not move. SeeShifting Into PARK (P) on
page 120.
Mirrors
Manual Rearview Mirror
When you are sitting in a comfortable driving
position, adjust the mirror so you can see clearly
behind your vehicle. Hold the mirror in the center to
move it up or down and side to side. The day/night
adjustment allows you to adjust the mirror to avoid
glare from the lamps behind you. Push the tab
forward for daytime use and pull it for nighttime use.
Manual Rearview Mirror with
OnStar
®
When you are sitting in a comfortable driving
position, adjust the mirror so you can see clearly
behind your vehicle. Hold the mirror in the center to
move it up or down and side to side. The day/night
adjustment allows you to adjust the mirror to avoid
glare from the lamps behind you. Push the tab
forward for daytime use and pull it for nighttime use.
There are also OnStar
®buttons located at the
bottom of the mirror face. See your dealer for more
information on the system and how to subscribe
to OnStar
®. SeeOnStar®System on page 127for
more information about the services OnStar®
provides.
125

OnStar®service cannot work unless your vehicle
is in a place where OnStar®has an agreement
with a wireless service provider for service in that
area. OnStar
®service also cannot work unless
you are in a place where the wireless service
provider OnStar
®has hired for that area
has coverage, network capacity and reception
when the service is needed, and technology that
is compatible with the OnStar
®service. Not all
services are available everywhere, particularly in
remote or enclosed areas, or at all times.
OnStar
®service that involves location information
about your vehicle cannot work unless GPS
satellite signals are unobstructed and available in
that place as well.Your vehicle must have a working electrical
system (including adequate battery power) for the
OnStar
®equipment to operate. There are other
problems OnStar®cannot control that may prevent
OnStar®from providing OnStar®service to you
at any particular time or place. Some examples are
damage to important parts of your vehicle in an
accident, hills, tall buildings, tunnels, weather
or wireless phone network congestion.
Your Responsibility
You may need to increase the volume of your
radio to hear the OnStar®advisor. If the light next
to the OnStar®buttons is red, this means that
your system is not functioning properly and should
be checked by your dealer/retailer. If the light
appears clear (no light is appearing), your OnStar
®
subscription has expired. You can always press
the OnStar®button to conrm that your OnStar®
equipment is active.
130

The main components of your instrument panel are the following:
A. Air Outlets. SeeOutlet Adjustment on
page 160.
B. Turn Signal/Multifunction Lever. SeeTurn
Signal/Multifunction Lever on page 141.
C. Instrument Panel Cluster. SeeInstrument Panel
Cluster on page 162.
D. Windshield Wiper and Washer Lever. See
Windshield Wipers on page 143andWindshield
Washer on page 144.
E. Hazard Warning Flashers Button. SeeHazard
Warning Flashers on page 140.
F. Passenger Airbag Status Indicator. See
Passenger Airbag Status Indicator on page 165.
G. Instrument Panel Brightness Control. See
Instrument Panel Brightness on page 151.
H. Cruise Controls. SeeCruise Control on
page 145. Driver Information Center (DIC)
Buttons. SeeDriver Information Center (DIC)
on page 179.
I. Tilt Lever. SeeTilt and Telescopic Steering
Wheel on page 140.J. Horn. SeeHorn on page 140.
K. Audio Steering Wheel Controls (If Equipped).
SeeAudio Steering Wheel Controls on
page 206.
L. Ignition Switch. SeeIgnition Positions on
page 108.
M. Automatic Climate Control System. See
Automatic Climate Control System on
page 154.
N. Traction Control Button. SeeTraction Control
System (TCS) on page 217. Electronic Stability
Control Button. SeeElectronic Stability
Control on page 219.
O. Shift Lever. SeeAutomatic Transaxle Operation
on page 116.
P. Audio System. SeeAudio System(s) on
page 192.
Q. Glove Box. SeeGlove Box on page 131.
139

Cruise Control
Cruise control lets you maintain a speed of about
25 mph (40 km/h) or more without keeping
your foot on the accelerator. This can really help
on long trips. Cruise control does not work at
speeds below 25 mph (40 km/h).
{CAUTION:
Cruise control can be dangerous where
you cannot drive safely at a steady speed.
So, do not use your cruise control on
winding roads or in heavy traffic.
Cruise control can be dangerous on
slippery roads. On such roads, fast
changes in tire traction can cause
excessive wheel slip, and you could lose
control. Do not use cruise control on
slippery roads.
Setting Cruise Control
{CAUTION:
If you leave your cruise control on when
you are not using cruise, you might hit a
button and go into cruise when you do not
want to. You could be startled and even
lose control. Keep the cruise control switch
off until you want to use cruise control.
The cruise control
buttons are located on
the steering wheel.
I(On/Off):PressIto turn the cruise control
system on and off.
145

Automatic Operation
AUTO (Automatic):Select AUTO on both the fan
speed knob and the air delivery mode knob to
activate the automatic system. When automatic
operation is active the system controls the
inside temperature and air delivery.
Use the steps below to place the entire system in
full automatic control:
1. Turn the fan knob and the mode knob to the
AUTO position.
The current set temperature displays. When
AUTO is selected, the air conditioning
operation and air inlet is automatically
controlled. The air conditioning compressor
runs while the outside temperature is
over about 40°F (4°C). The air inlet is normally
set to outside air. If it is hot outside, the air
inlet can automatically switch to recirculate
inside air to help quickly cool down your
vehicle.
2. Set the temperature.
An initial setting of 73°F (23°C) is
recommended. Allow about 20 minutes for the
system to regulate. Press the
worxarrow
temperature buttons to adjust the temperaturesetting as necessary. If the temperature is set
at 60°F (15°C) the system remains at the
maximum cooling setting. If the temperature is
set at 90°F (32°C) the system remains at the
maximum heat setting. Choosing either
maximum setting does not cause the vehicle to
heat or cool any faster.
Be careful not to cover the sensor located on
the top of the instrument panel near the
windshield. This sensor regulates air
temperature based on the intensity of the sun.
Also do not cover the sensor grille on the
lower right side of the climate control
faceplate, as this regulates the inside
temperature.
To avoid blowing cold air at engine start-up in
cold weather, the system delays turning on
the fan until warm air is available. The length
of delay depends on the engine coolant
temperature. Turning the fan knob overrides
this delay and changes the fan to the selected
speed.
155

Manual Operation
The air delivery mode or fan speed, can manually
be adjusted.
Fan Speed Knob
9(Off):Select this position to turn off the fan.
Outside air still enters the vehicle. The direction
can be changed by changing the mode position.
The temperature can also be adjusted using either
the up or down arrow temperature buttons.
9(Fan):Turn the knob with the fan symbol to
manually adjust the fan speed.
wxTemperature Control:Press thewand
xarrows to increase or decrease the temperature
inside the vehicle.
Air Delivery Mode Knob
H(Vent):Use this mode to direct air to the
instrument panel outlets.
)(Bi-Level):Use this mode to direct half of the
air to the instrument panel outlets, and the
remaining air to the oor outlets.
6(Floor):Use this mode to direct most of the
air to the oor outlets with some air directed to the
side window outlets.
The right knob can also be used to select defog or
defrost modes. Information on defogging and
defrosting can be found later in this section.
#(Normal Air Conditioning):Press this button
to turn the air conditioning compressor on and
off. A light above the button comes on while the air
conditioning is on.
When air conditioning is selected or is in AUTO
mode, the system runs the air conditioning
automatically to cool and dehumidify the air
entering the vehicle.
While in this mode, the hybrid system does not
shut the engine down at complete stops.
On hot days, open the windows long enough to let
hot inside air escape. This reduces the time it
takes for your vehicle to cool down. Then
keep your windows closed for the air conditioner
to work its best.
156

On cool, but sunny days while using manual
operation of the automatic system, use bi-level to
deliver warm air to the oor and cooler air to
the instrument panel outlets. To warm or cool the
air delivered, press the temperature buttons to
the desired setting.
In AUTO mode the system cools and dehumidies
the air inside the vehicle. Also while in AUTO
mode, the system maximizes its performance by
using recirculation as necessary.
Heating:On cold days when using manual
operation of the automatic system, use oor mode
to deliver air to the oor outlets. To warm or
cool the air delivered, push the temperature
buttons to the desired setting.
To use the automatic mode, turn the knob to
AUTO and adjust the temperature by pressing the
temperature buttons.
When the heater is in use, there might be slight
noise or vibration during Auto Stops. This is due to
the coolant circulation pump that continues to
circulate heat through the system during the
engine Auto Stop.
The heater works best if the windows are kept
closed.h(Recirculation):Press the button to turn on
the recirculation mode. The air inside the vehicle
recirculates through the climate control system and
the vehicle, not from outside your vehicle. This
mode is helpful when trying to limit odors
from entering the vehicle and for maximum air
conditioning performance in hot weather. When the
button is pressed, an indicator light above the
button comes on. The recirculation indicator light
blinks three times if recirculation is used in a
mode in which it cannot function. Only use this
mode when it is needed for comfort, since window
fogging rapidly occurs if the air conditioning
compressor is not engaged.
Press this button to cancel the auto recirculation
feature. Each time the vehicle is started, the
system reverts to the auto recirculation function.
If you select recirculation while in defrost, defog or
oor, the light on the button ashes three times
and then goes out to indicate that this is not
allowed. This is to prevent window fogging.
157

Fuel Economy Light
If enabled, this light will
come on briey when
the vehicle is started.
This light will also come on when the vehicle is
operating at a fuel efficient point.
This light can be disabled by using the Driver
Information Center (DIC) buttons. With the engine
off and the key turned to accessory, set the
DIC to the outside air temperature and odometer
mode. Press and hold the reset button for
several seconds. The light will come on solid and
then ash several times and turn off to indicate
it is disabled. Repeat the procedure to enable the
light. SeeDIC Warnings and Messages on
page 182for more information.
Driver Information Center (DIC)
Your vehicle has a Driver Information Center (DIC).
The DIC display gives you the status of many of
your vehicle’s systems. The DIC is also used to
display driver personalization menu modes and
warning/status messages. All messages will appear
in the DIC display, located at the bottom of the
instrument panel cluster.
The DIC buttons are located on the left side of the
steering wheel. Your vehicle will have one of
the buttons shown above.
q/INFO (Information):Press this button to
scroll through the vehicle information mode
displays.
179

r(Reset):Press this button to reset some
vehicle information mode displays, select a
personalization menu mode setting, or
acknowledge a warning message.
Press and hold the information and reset buttons
at the same time for one second, then release
the buttons to enter the personalization menu. See
DIC Vehicle Personalization on page 187for
more information.
DIC Operation and Displays
The DIC comes on when the ignition is on. The
DIC has different modes which can be accessed
by pressing the DIC buttons. The button functions
are detailed in the following.
Information Modes
q
/INFO (Information):Press this button to
scroll through the following vehicle information
modes:
Outside Air Temperature and Odometer
Press the information button until the outside
air temperature and the odometer display. This
mode shows the temperature outside of the vehicle
in either degrees Fahrenheit (°F) or degrees
Celsius (°C) and the total distance the vehicle has
been driven in either miles (mi) or kilometers (km).
The outside air temperature appears on the left
side of the DIC display and the odometer appears
on the right side of the display.
To change the DIC display to English or metric
units, see “UNITS” underDIC Vehicle
Personalization on page 187.
180