dashboard warning lights Seat Leon 5D 2006 Owner's manual
[x] Cancel search | Manufacturer: SEAT, Model Year: 2006, Model line: Leon 5D, Model: Seat Leon 5D 2006Pages: 292, PDF Size: 8.86 MB
Page 34 of 292

Airbag system
32Monitoring of airbag and belt tension device system
The functionality of the airbag and belt tension device system is constantly 
monitored electronically. Each time th e ignition is switched on, the warning 
lamp 
 lights for several seconds and the display in the instrument panel* 
shows  AIRBAG / TENSIONER .
The system must be checked when the warning lamp 
 :
•
does not come on when the ignition is switched on,
•
does not go out about 4 seconds after the ignition is switched on,
•
goes out and then comes on again after the ignition is switched on,
•
or if it comes on or flickers while the car is moving.
In the event of a malfunction, the warning lamp remains on continuously. In 
addition, depending on the malfunctio n, a fault message appears in the 
display of the combi-instrument for approx. 10 seconds and a short acoustic 
signal is given. In this event, you should have a qualified workshop check the 
system immediately.
If any of the airbags are deactivated by the Authorised Service Centre, the 
indicator lights for several  seconds more after the veri fication and will turn off 
if there is no fault.
WARNING
•
If there is a malfunction, the air bag and belt tension device system 
cannot properly perform its protective function.
•
If a malfunction should occur, have the system checked immediately by 
a qualified workshop. Otherwise there is a risk that, in the event of an acci-
dent, the airbag system and belt tension devices may not be triggered, or 
may not be triggered correctly.
Repair, care and disposal of the airbagsThe parts of the airbag system are installed in various places in your vehicle. 
If you work on the airbag system or remove and install parts of the system 
when performing other repair work, parts of the airbag system may be 
damaged. The consequence may be that, in the event of an accident, the 
airbag inflates incorrectly  or does not inflate at all.
The relevant safety requirements must be observed when the vehicle or 
components of the airbag are scrapped . The specialist workshops and the 
Vehicle disposal centres are familiar with these requirements.
WARNING
•
If repairs are not carried out by a professional, or if the airbags are used 
incorrectly, the risk of severe or fatal injuries is increased. The airbags may 
fail to inflate, or could inflate in the wrong circumstances.
•
Do not cover or stick anything on  the steering wheel hub or the soft 
plastic surface of the airbag unit on the passenger side of the dashboard, 
and do not obstruct or modify them in any way.
•
It is important not to attach any objects such as cup holders or tele-
phone mountings to the surfaces covering the airbag units.
•
To clean the steering wheel or dash panel, you may use only a dry cloth 
or one moistened with water. Never clean the dash panel and surface of the 
airbag module with cleansers containing solvents. Solvents cause the 
surface to become porous. If the airbag inflates, disintegrating plastic 
parts can cause substantial injuries.
•
Never attempt to repair, adjust, remove or install parts of the airbag 
system.
•
Any work on the airbag system or re moval and installation of the airbag 
components for other repairs (such as repairs to the steering wheel) should 
be performed only by a qualified workshop. Qualified workshops have the 
necessary tools, repair information and qualified personnel.
leon_ingles  Seite 32  Donner stag, 24. August 2006  1:56 13