gas type Seat Mii 2018 Owner's manual

Safety
Airbag system
Brief intr oduction
Intr oduction Front airbags have been installed for both
driver and passenger
. The fr
ont airbags can
also protect the chest and head of driver and
passenger if the seats, seat belts head re-
straints and, for the driver, the steering wheel
are correctly adjusted and used. Airbags are
considered as additional safety equipment.
An airbag cannot replace the seat belt, which
must be worn at all times, even in front seats
where front airbags have been installed.
The airbag can protect vehicle occupants in
the event of an accidents, cushioning the
movement of the occupants in the direction
of the collision in frontal and side accidents.
Deployed airbags fill with a propellant gas.
This causes the airbag covers to break and
the airbags to deploy extremely quickly in
their entire deployment space within frac-
tions of a second. When an occupant with the
seat belt properly fastened puts pressure on
the inflated airbag, the propellant gas es-
capes to absorb the force of the impact and
slow the movement. This reduces the risk of
severe or fatal injuries. Airbag deployment
does not mean that other types of injury such
as swelling, bruising and skin injuries can be ruled out. Upon deployment of the airbag,
friction can cause the generation of heat.
Airbags do not pr
ot

ect the arms or the lower
part of the body.
The most important factors for triggering the
airbag are the type of accident, the angle of
impact, the vehicle speed and the character-
istics of the object the vehicle hits. Therefore,
airbags are not triggered every time the vehi-
cle is visibly damaged.
The activation of the airbag system depends
on the magnitude of the deceleration of the
vehicle caused by a collision, which registers
through an electronic control unit. If the de-
celeration magnitude value is below the ref-
erence value programmed in the control unit,
the airbags will not deploy even though seri-
ous damage might be caused to the vehicle
as the result of an accident. Damage suf-
fered by the vehicle, reparation costs or ab-
sence of damage suffered from the accident
are not indications of whether an airbag
should have been deployed. Due to the vary-
ing nature of collision situations, it is impossi-
ble to define a speed range of the vehicle
and reference values. For this reason, it is not
possible to cover all types of collisions and
collision angles resulting in the deployment of
the airbag. Factors necessary for the airbag
to be deployed can be, the characteristics of
the object (hard or soft) against which the ve-
hicle collides, the collision angle and the ve-
hicle speed. Airbags act in conjunction with the three-
point seat belts in certain accident situations,
when the v
ehicle deceleration rate is severe
enough to trigger the airbags. Airbags only
deploy once and only under certain circum-
stances. Seat belts remain present to offer
protection in situations where airbags are not
triggered or where they have already de-
ployed. For example, when a vehicle hits an-
other after an initial collision or is hit by an-
other vehicle.
The airbag system is an integral part of the
car

Practical tips
Checking and refilling lev-
el s
Fuel Identification of the fuel 1)Fig. 176
Identification of fuels according to Eu-
r opean Union (EU) Dir
ectiv
e 2014/94/Fuels are identified with different symbols.
Depending on the fuel, the diff
erent symbol

s
are on the pump and the tank lid of your vehi-
cle. The identification serves to prevent con-
fusion when choosing the fuel.
Petrol with ethanol (“E” stands for Etha-
nol). The number indicates the percent-
1 age of ethanol in the petrol. “E5” means,
f
or e
x

ample, an ethanol ratio of 5% max.
Diesel with biodiesel (“B” stands for Bio-
diesel). The number indicates the per-
centage of biodiesel in the diesel. “B7”
means, for example, a proportion of bio-
diesel of max. 7%.
Natural gas: “CNG” means Compressed
Natural Gas.
Type of petrol  Applies to v
ehicl
es: with petrol engine
The correct grade of petrol is listed inside the
fuel tank flap.
The vehicle is equipped with a catalytic con-
verter and must only be run on unleaded
petrol. The petrol must comply with the
standard EN 228 and be sulphur-free. Fuels
with a 10% ethanol ratio can be refuelled
(E10) 2)
. The types of petrol are differentiated
by using the octane numbers (RON) or via
the anti-knock index (AKI).
The following pieces of text show the infor-
mation included in the corresponding stickers
on the tank lid (examples): 2 3 Super unleaded petrol 95 octane petrol or
normal 91 oct
ane petr
ol at l

east
We recommend refuelling with super 95 oc-
tane petrol (91 AKI). If not available: normal 91
octane petrol (87 AKI) (with a slight power
loss).
Super unleaded petrol, 95 octanes at
least
You should use super 95 octane petrol (91
AKI) at least.
If super is not available, if necessary, use nor-
mal 91 octane petrol (87 AKI). In this case only
use moderate engine speeds and a light
throttle. Refuel with super as soon as possi-
ble.
Unleaded super plus 98 octane petrol or
super 95 octane petrol at least
We recommend refuelling with super plus 98
octane petrol (93 AKI). If not available: super
95 octane petrol (91 AKI) (with a slight power
loss).
If super is not available, if necessary, use nor-
mal 91 octane petrol (87 AKI). In this case only
use moderate engine speeds and a light 1)
Depending on country
2) Follow the regulations of the country you are
driving in.
186

Practical tips
However, the heating power and the propor-
tion of nitr ogen and carbon dio
xide can fluc-
t
uate within the quality groups. Therefore, ve-
hicle consumption can also vary when using
a single type of gas only.
The engine management automatically
adapts to the natural gas used according to
its quality. Therefore, different quality gases
can be mixed in the tank, without the need for
comprehensive draining before applying a
different quality gas.
Natural gas and safety
If you can smell gas or suspect that there is a
leak