LED SEAT TOLEDO 2019 Owners Manual

Owner’s manual
SEAT Toledo
6JA012720BL
Inglés
6JA012720BL (11.18)
SEAT Toledo Inglés (11.18)

The essentials
Menu “Pause”
Continue The interrupted timer continues.
New lap A new timer starts. The halted lap
ends and is included in the statistics.
Interr.
lap The timer of the current l
ap ends and
is cancelled. It is not included in the
st atistics.
End The curr

ent timer ends. The lap is in-
cluded in the statistics. Menu “Partial time”
Partial
time For approx. 5 seconds a partial time is
displayed. The timer continues in par
-
all

el.
New lap The timer of the current lap stops and
a new l
ap st

arts immediately. The
time for the lap you have just comple-
ted is included in the statistics.
Stop The current lap timer will be interrup-
ted. The l
ap does not end. The

Pause
menu is displayed. Menu “Statistics”
View of the latest lap times:

Seat belts
Head-on collisions and the laws of
physics Fig. 77
A driver not wearing a seat belt is
thr own f
orward violently. Fig. 78
The unbelted passenger in the rear
seat is thr own f

orward violently, hitting the driv-
er wearing a seat belt The effects of the laws of physics in the case
of a head-on collision ar
e easy t
o e

xplain: the
moment a vehicle starts moving, a type of en- ergy called “kinetic energy” starts acting on
both the vehicle and its passengers.
The amount of “kinetic ener

gy” depends on
the speed of the vehicle and on the weight of
the vehicle and of its passengers. The higher
the speed and the greater the weight, the
more energy there is to be “absorbed” in an
accident.
The most significant factor, however, is the
speed of the vehicle. If the speed doubles
from 25 km/h (15 mph) to 50 km/h (30 mph),
for example, the corresponding kinetic ener-
gy is multiplied by four.
Because the vehicle occupants in our exam-
ple are not restrained by seat belts, in the
event of crashing against a wall, all of the oc-
cupants

Safety
 
It lights up on the dash panel
Front passenger front airbag disabled.
Check whether the airbag should remain disabl edThe control lamp monitors all airbags and
seat belt tensioners in the v
ehicl

e, including
control units and wiring connections.
Monitoring of airbag and belt tensioner
system
Both the airbag and belt tensioner systems
operation is constantly monitored electroni-
cally. Each time the ignition is switched on,
the control lamp T illuminates for several
seconds (self-diagnosis) and the instrument
panel display* shows AIRBAG/TENSIONER.
The system must be checked when the
control lamp T :

Transporting children safely
Transporting children
saf ely
Saf et
y for children
Introduction For safety reasons, as we have learned from
accident statistics, w
e r

ecommend that chil-
dren under 12 years of age travel in the rear
seats. Depending on their age, height and
weight, children travelling in rear seats must
use a child seat or a seat belt. For safety rea-
sons, the child seat should be installed in the
rear seat, behind the front passenger seat or
in the centre back seat.
The physical laws involved and the forces
acting in a collision apply also to children

Fuses and bulbs
No. Consumer
24 Air conditioning fan, heating, control unit for
air conditioning, heating
26 Front seat heating switch. 27 Rear window wiper
29 Airbag
30 Electric windows, reversing light switch, air
conditioning control unit, P
ark Assist contr
ol
unit, exterior mirror, power supply for middle
button bar, power supply for the side button
bar, interior mirror
31 Fuel pump, radiator fan control unit, cruise
contr
ol, r

elay coil for the windscreen and rear
window washer system, switch for the lights
32 Diagnostics socket, headlight range regula-
tor, contr

ol lever under the steering wheel,
ambient lighting regulator
33 Ignition relay coil, clutch pedal switch
34 Heatable washer jets of windscreen washer
36 USB charging socket 37 Radar
39 Additional electric heating 41 Rear window heater
42 Electric windows - passenger
43 Towing bracket - Connector contact No. Consumer
44 12 V connection in the interior, 12 V connection
in the boot
45 Rear right window
46 Windshield and front window washing sys-
tem, contr
ol l

ever under the steering wheel
47 Towing bracket - Connector contact
48 Towing bracket - Right hand light 49 Fuel pump control unit
50 Radio 51 Heat for exterior mirrors
52 Keyless Access
53 Steering lock (Keyless Access)
54 ABS/ESC control unit
56 Diagnosis
59 Full LED Fuses in the engine compartment
Fig. 87
In the engine compartment: lid of the
fuse bo x - Variant 1

Fuses and bulbs
Full-LED headlight system*
Full -LED headlights handl
e all light functions
(daylight, side light, t
urn signal, dipped beam
and route light) with light emitting diodes
(LEDs) as a light source.
Full-LED headlights are designed to last the
lifetime of the car and light bulbs cannot be
replaced. In case of headlight failure, go to an
authorised workshop to have it replaced.
Double headlight bulb change
Changing bulbs requires a certain degree of
practical skill. If in doubt, we recommend you
have defective bulbs changed by a special-
ised service or, in case of an emergency, seek
professional assistance.

Emergencies
Note
Check the condition of the seal. If dam-
aged, a repl acement can be acquir
ed from
an Official Service. Changing the side and num-
ber plat
e bulbs
Side t

urn signals Fig. 107
Turn signal integrated in the rear view
mirr or The side turn signals are LEDS and are inte-
gr
at
ed in the e

xterior mirrors.
In case of failure, go to an authorised work-
shop to have them replaced. Changing the bulb on the number
plate
Fig. 108
Removing number plate light Fig. 109
Changing the bulb. Removing the bulb holder

Opening and closing
Automatically disabling sensors
If the v ehicl
e is not l
ocked or unlocked for a
long period of time, the proximity sensor on
the passenger door is automatically disa-
bled.
If one of the sensor surfaces on the door han-
dles is often activated in an unusual manner
with the vehicle locked (e.g. by the branches
of a bush rubbing against it), all proximity
sensors are disabled for a time. If this only
happens with the exterior sensor on the driv-
er

Operation
If an obstacle is present, the closing mecha-
nism will st op and the windo
w will r
oll back a
few centimetres.
If an obstacle prevents closing for the next 10
seconds, the closing mechanism will once
again stop and the window will roll back an-
other few centimetres.
If in the next 10 seconds you attempt to close
the window after it has rolled back the sec-
ond time, only the closing mechanism will be
stopped even if the obstacle is still present.
The roll-back function is still connected.
The roll-back function will only be disconnec-
ted if you once again attempt to close the
window in the following 10 seconds. In this
case, the window will close at full force.
If you wait for a further 10 seconds, the roll-
back function will be once again connected. Lights and visibility
Lights Intr oduction Read the additional information carefully