weight SKODA FABIA 2000 1.G / 6Y Workshop Manual

Downloaded from www.Manualslib.com manuals search engine FABIA 2000➤Inspection and Maintenance
General pointsEdition 09.04
S00.5301.14.2002-1 page 2 02
U - 1.9 ltr. TDI PD/96 kW/diesel engine
W - 1.2 ltr./40 kW/petrol engine
Y - 1.2 ltr./47 kW/petrol engine
Z - 1.4 ltr. TDI PD/55 kW/diesel engine
4 - Airbag System:
0 - no airbag
1 - 1 Front airbag
2 - 2 Front + 2 side airbags
4 - 2 Front airbags
8 - light weight utility vehicle
5 - Model:
6Y - FABIA, FABIA COMBI, FABIA SEDAN, FABIA
PRAKTIK, FABIA RS
6 - Internal code
7 - Model year:
Y - 2000
1 - 2001
2 - 2002
3 - 2003
4 - 2004
5 - 2005
8 - Manufacturing plant:
3 and 4 - Mladá Boleslav
6 - Kvasiny
7 - Vrchlabí
B - Solomonovo
N - Mladá Boleslav
X - Poznan
9 - Vehicle body number
Type plate
The type plate -arrow- is attached to the front of the left
wheel house.

Downloaded from www.Manualslib.com manuals search engine FABIA 2000➤Inspection and Maintenance
Electrical SystemEdition 09.04
S00.5301.14.2002-6 page 11 02
Test and setting conditions
•Tyre inflation pressure O.K.
•Lenses must neither be damaged nor soiled.
•Reflectors and bulbs O.K.
•Vehicle load must be achieved.
Load: With an individual or 75 kg on the driver's seat in an
otherwise unladen vehicle (dead weight).
The unladen weight is the weight of the vehicle with full
fuel tank (at least 90 %) including the weight of all the op-
erational equipment elements (e.g. spare wheel, tool kit,
jack etc.).
The vehicle must have rolled a few metres or have been
depressed a few times at the front and rear to allow the
springs to settle.
•Both the vehicel and headlight beam setting device
must be on a level flat surface.
•Align the vehicle and headlight beam setting device in
accordance with the device manufaturer's indications.
•Check the control system of vehicles equipped with
headlight beam control by repeatedly turning the
thumbwheel in the dash panel. Then turn the thum-
bwheel to basic position.
•Set the inclination value.
Inclination value:
The inclination value is marked in „%“ at the top of the
headlight housing. The main headlights must be set to
this value. The percentage value applies up to 10 metres
projection distance. This will be 12 cm for an inclination
value of e.g. 1.2 %.
Inspecting headlight beam setting and adjusting
if necessary
Main headlights:
–Check whether the horizontal light/dark limit touches
the separation mark -1- on the test surface when the
low beam light is on .
–Check whether the kink -2- between the left horizontal
part and the ascending right part of the light/dark limit
intersects with the central mark -3- on the vertical line.
The light core of the light beam must be located to the
right of the vertical line.132
S02-0091