SKODA FABIA 2009 2.G / 5J Beat Car Radio Manual

SIMPLY CLEVER
www.skoda-auto.comAutorádio Beat
Škoda Auto anglicky 11.07
S00.5610.50.20
5J0 012 095 L ŠkodaAuto
CAR RADIO BEAT
Beat.indd 14.9.2007 9:18:28






  





  







 

 
 
 




  


 









 




  !
" 
# 
   
 



  


 




 



 


$ 

 
 
 
 

 


 
 
 





 

% 
& '() 

© ŠKODA AUTO a.s. 2007
Beat.indd 24.9.2007 9:18:31

Contents1
Contents
Radio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Radio - Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Important information. . . . . . . . . . . . . . . . . . . . . . . .
Anti-theft protection. . . . . . . . . . . . . . . . . . . . . . . . . .
Basic setting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Radio mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
External CD changer . . . . . . . . . . . . . . . . . . . . . . . . . .
2
2
2
3
3
5
6
s2e0.5.book Page 1 Wednesday, May 2, 2007 9:14 AM

Radio2
Radio
Radio - Overview
Left button
− switching on and off (pressing)
− Volume control (rotate)
Right button
− manual station finding, select the track in CD mode (rotate)
− fast station finding in current waveband, scroll through the contents of the CD (press)
− Calling up the menu Setup (press for some considerable time)
− other function settings in various menus (rotate)
Station keys -
− store and select the RDS station
− CD selection
− Enter code
Button to activate the CD mode
Button
− fast station finding
− Pre-winding the title in the CD mode
Button
− fast station finding
− Pre-winding the title in the CD mode
Button switching over be tween the wavebands AM/FM
Button for activating the traffic information mode
Button automatically stores the station
Button for adjusting the sound
Reception of traffic reports activated
Current waveband FM1/AM1 (memory spaces 1 - 6) or FM2/AM2 (memory spaces 7 - 12)
Selected station key
Name or frequency of the selected radio station
Important information
Warranty
The same warranty terms apply for the equipment as for new vehicles.
After the expiration of the warranty, a unit in need of repair will be replaced inex- pensively with a reconditioned, original unit with spare part warranty. However it is required that there is no housing dama ge and no unauthorised repair attempts have been made.
Note
A damage in the sense of the warranty must not be the result from improper handling of the system or from unprofes sional repair attempts. In addition, no external damage must be present.
Radio mode
The radio should only be used, if the traffic situation permits it.
The volume settings must be selected in su ch a way that acoustic signals from the outside, such as e.g. a Martins horn from utility vehicles (police cars, ambulances and fire brigade), can be heard at any time.
Power output
4x20 W
A1
A2
A316
A4CD
A5
A6
A7AM/FM
A8TP
A9AS
A10
A11
A12
A13
A14
s2e0.5.book Page 2 Wednesday, May 2, 2007 9:14 AM

Radio3
WARNING
Please always pay full attention to the traffic situation around you! As the driver you are fully responsible for the traffic safety. Only use the functions in such a way that you always maintain the control over your vehicle in all traffic situations!
Using the display
Carefully handle the display because dent s and scratches can occur through pres- sure of the finger or contact with sharp objects.
The display can be cleaned with a soft cl oth and finger marks can be wiped away with pure alcohol.
Note
Do not use solvent such as turpentine or petrol as they will corrode the display surface.
Anti-theft protection
Anti-theft coding
Your radio is equipped with a convenience co ding. If the radio is being operated for the first time, the safety code is not only stored in the radio but also in the vehicle.
After disconnecting and reconnecting the batte ry, first of all switch on the ignition and then the radio.
If you wish to install the radio in another vehicle, the safety code must be entered. In this case, please do not hesitate to contact a Škoda Service Partner or a Škoda importer.
As the unit only functions after entering the safety code, this practically excludes its use after a theft - a contribution to increased anti-theft safety.
Note
The code is stored in the instrument cl uster. Through this it is automatically decoded (convenience coding). A manual entry of the code is normally not necessary.
Enter code
– Switch on the radio if the ignition is on. SAFE is displayed and then
1000 .
– Enter the safety code using the station keys - .
– Confirm the safety code by pressing the station key .
If you have confirmed a wrongly entered co de, you can repeat once again the entire process.
If the code number is entered incorrectl y for the second time, the unit will be blocked for approx. one hour. It is only po ssible to repeat the entry of the safety code after an hour has expired and while the unit is switched on and the ignition key remains in the ignition lock.
The cycle - two attempts, blocked for an hour - furthermore applies.
Basic setting
Switching the unit on and off
– The system is switched on or off by pressing the rotary/push knob .
If the key is pulled out of the ignition lock when the system is switched on, the system switches off automatically. You can switch on again the unit by pressing the rotary/push knob . If the engine is switch ed off, the unit (protection of the vehicle battery before discharging) switches of f automatically after approx. one hour.
14
6
A1
A1
s2e0.5.book Page 3 Wednesday, May 2, 2007 9:14 AM

Radio4
If you have switched off the radio by withdrawing the ignition key, the radio switches on again once the ignition is on.
Audio settings
Setting the bass
– Press the button , BASS appears in the display.
– Set the desired value by turning the button .
Setting treble
– Press the button , TRE appears in the display.
– Set the desired value by turning the button .
By pressing again the button or 5 seconds after the setting, the set values are stored and the radio returns to the normal mode.
Adjusting volume ratio
Balance
– By pressing the button repetitively, BAL appears in the display.
– You can set with the button the desired value of the volume ratio
between the left and right side.
Fa d er
– Press the button once again, FA D appears in the display.
– You can set with the button the desired value of the volume ratio
between the front and the rear.
By pressing again the button or 5 seconds after the setting, the set values are stored and the radio returns to the normal mode.
Setting the special functions
– Press the button for some considerable time, in order to activate
the menu Setup.
– Select the individual functions of the menu by pressing the button
briefly.
– Confirm the changed setting by turning the button .
– By pressing the button for some considerable time or 30 seconds
after the setting, the set values are automatically stored and the unit
returns to the normal mode.
GALA
Your radio increases automatically its volume with the increasing vehicle speed. A higher setting value results in a stronger volume increase.
ON VOL
Your radio stores the last volume set before switching off. If the value is higher, the volume is reduced to the value of the parameter ON VOL after switching on the radio again.
PHONE
If your vehicle is equipped with a handsfree system, you can switch on or off the monophone play function of the mobile phone calls via the loudspeakers of the vehicle.
AUX
Switching on or off the function s of the external audio source.
You can set the desired value in the range of LEV1 to LEV3. If you set the value OFF, the tone is not replayed from the external audio source.
BEEP
Switching on or off the tone signal when storing the radio stations.

A2

A2


A2

A2

A2
A2
A2
A2
s2e0.5.book Page 4 Wednesday, May 2, 2007 9:14 AM

Radio5
CD
Play function of the CD tack (tracks) in continuous or random order. If you select PLAY , the tracks are replayed in normal order. If you select SCHFFL (Schuffle), the tracks are replayed in random order.
LO U D
In case of low volume level, the function reinforces the range of bass and treble frequencies.
Note
Each setting change is stored by changing to another menu point.
Radio mode
Waveband switch-over
Your radio is fitted with the wavebands FM and AM, in order to change, press the button for a considerable time.
In the ranges FM1/AM1 and FM2/AM2 there are each 6 memory spaces available, in order to change, press the button briefly.
The process of searching for and storing the radio stations
Manual search
– Search the frequency of the desire d radio station by pressing the
button .
Automatic station finding SEEK
– The radio searches for the next radio station in the selected waveband
by pressing the button or .
Function SCAN
– The radio station of the current waveband is briefly played (10
seconds) by pressing the button briefly.
– This function is ended by pressing the button once again and the
current station is replayed.
Store station
– After selecting the radio station, hold the station key , on which it
should be stored until it briefly switches to mute and a brief signal
sounds.
Automatic station finding with storing the radio stations
– Press the button . An automatic station finding is started during
which the 6 stations with the strongest signal in the memory level FM2
and/or AM2 are stored. STORE is displayed on the display. This applies
only to the wavebands FM2 and AM2.
When storing the radio stations on the station keys is finished, you can call up the desired radio station by pressing a station key .
Note
The stored radio stations are updated and stored once again by repetitively pressing the button .
Radio text
Certain radio stations transmit additi onal text information - called radio
text.
Note
•The text information must not be available to all radio stations.
AM/FM
AM/FM
A2

A2
A2
A3
AS
A3A3
AS
s2e0.5.book Page 5 Wednesday, May 2, 2007 9:14 AM

Radio6
•Depending upon the quality of the received signal, the radio needs a specific time, in order to correctly read all the illustrated characters.
Tra f f i c re p o r t s
Activating and deactivating the traffic information
Press the button , TP appears in the display. If a set radio station does not transmit a traffic report, the radio searches for a station which transmits the traffic report. TP SEEK is displayed on the display.
If no radio station which transmits the traffic reports is found, NO TP is shown on the display.
An incoming traffic report au tomatically interrupts the CD play function or listening to a radio station, which at that moment is not transmitting a traffic report. INFO and the name of the current radio station is displayed on the display. At the end of the traffic report, the radio automatically returns to the original play function.
If you wish to deactivate the traffic in formation, press once again the button , TP goes out on the display.
External CD changer
Mode of the external CD changer
Your radio can be equipped with an original CD changer which can be
installed in your vehicle.
Selecting CD mode
– Start the play function of the ex ternal CD changer by pressing the
button .
– Select a CD with a station key .
Select track
– During the CD play function turn th e button to the left or to the
right, in order to select the previous or the next track.
– Press the button or for fast replay of the track (reverse or
forward). The play function is co ntinued after releasing the button.
Function SCAN
– Press the button , in order to scroll through the CD. The first 10
seconds of each title are played.
– In order to return to the normal mode, press once again the button
.
End the play function of the CD
– In order to end the play function of the CD and to activate the radio,
press the button . The CD remains in the unit.
Information on how to use a CD
CD to jump
Uneven road surfaces and strong vi brations may cause the CD to jump.
Formation of condensation
When it is cold and after rain showers, moisture can deposit in the CD drive (condensation). This can effect the CD jump or impair the play function. In such cases wait until the moisture has dissipated.
Notes for the care of the CDs
If a CD is soiled, please never clean the CD in the direction of a circle but rather with a soft fluffly cloth from inside to outside. In case of severe layers of dirt we recom- mend to clean the CD with a commercially av ailable CD cleaner. Also in this case do not clean the CD in the direction of a circ le but rather from inside to outside and then let it dry off.
TP
TP
CD
A3
A2

A2
A2
AM/FM
s2e0.5.book Page 6 Wednesday, May 2, 2007 9:14 AM

Radio7
Overheating protection
If the temperature in the unit exceeds 85°C, the play function of the CD is ended for safety reasons.
Caution
•Never use liquids such as gasoline, paint thinner or disk cleaner, otherwise the surface of the CD could get damaged.
•Never expose CDs to direct sun rays!
•Please never write or affix the CD!
Note
Dirt or damage of a CD can lead to diffic ulties when “reading” the information. The difficulty in reading the error depends on th e dirt or on the severity of the mechan- ical damage. Severe scratches cause reading errors which can make the CD jump or “ get stuck”. All CDs must be treated carefully and always be stored in a protective case.
s2e0.5.book Page 7 Wednesday, May 2, 2007 9:14 AM

SIMPLY CLEVER
www.skoda-auto.comAutorádio Beat
Škoda Auto anglicky 11.07
S00.5610.50.20
5J0 012 095 L ŠkodaAuto
CAR RADIO BEAT
Beat.indd 14.9.2007 9:18:28