warning SKODA FABIA 2010 2.G / 5J Swing Car Radio Manual

General information3
WARNING
Please concentrate fully at all times on yo ur driving! As the driver you are fully
responsible for road safety. Only use the functions of the radio in such a way
that you are always in full control of your vehicle in all traffic situations!Using the displayCarefully handle the display because dents and scratches can occur through pressure
of the finger or contact with sharp objects.
The display can be cleaned with a soft clot h and finger marks can be wiped away with
pure alcohol.
Note
Do not use solvent such as turpentine or petrol as they will corrode the display
surface.Anti-theft protectionAnti-theft codingYour radio is equipped with a convenience coding. If the radio is being operated for the
first time, the safety code is not only st ored in the radio but also in the vehicle.
After disconnecting and reconnecting the battery , first of all switch on the ignition and
then the radio.
If you wish to install the radio in another ve hicle, the safety code must be entered. In
this case, please do not hesi tate to contact an authorised Škoda Service Partner or a
Škoda importer.
As the unit only functions after entering the sa fety code, this practically excludes its use
after a theft - a contribution to increased anti-theft safety.
Note
The code is stored in the instrument cluster. This ensures that it is automatically
decoded (convenience coding). Manual inpu t of the code is normally not necessary.Enter code– Switch on the radio if the ignition is on.
– Enter the safety code using the station keys - .
– Confirm the safety code by pressing the station key .
If you have confirmed a wrongly entered code, you can repeat once again the entire
process.
If the code number is entered incorrectly for the second time, the unit will be blocked
for approx. one hour. It is possible to enter again the safety code after one hour has
expired, when the unit and the ig nition have been switched on.
The cycle - two attempts, blocked for an hour - will continue to apply.Basic settingSwitching the unit on and off– The system is switched on or off by briefly pressing the control button .
If the key is pulled out of the ignition lock while the unit is switched on, the unit will
switch off automatically. Yo u can switch on the unit agai n by pressing the control
button . If the ignition is switched off, th e unit (discharge protection of the vehicle
battery) switches off automati cally after approx. one hour.
If you have switched off the radio by withdr awing the ignition key, the radio switches
on again once the ignition is on.Tone settings– Press the button and then the station key and select the desired parameter.
1
4
6
A1
A1

A12
s214.14.book Page 3 Thursday, January 28, 2010 1:29 PM

CD player
10

A USB extension cable or USB distributor (HUB) must not be used to connect the
unit.
WARNING

On no account place an external audio source on the dash panel. You could
make sudden manoeuvres in the passenger compartment and injure the occu-
pants.

On no account place an ex ternal audio source close to the airbags. You could
be thrown back in the passenger comp artment by the airbags being deployed
and injure the occupants.

You must not hold the external audio source in the hand or on the knees
while driving. You could make sudden manoeuvres in the passenger compart-
ment and injure the occupants.

Always guide the connection cable of th e external audio source in such a
way that is does not restrict you when driving.Caution
The AUX-IN input must only be used for audio sources!
Note

The external audio source, which is connected via AUX-IN, can only be used if no
unit is connected via MD I at the same time.

If an external audio source is connected via AUX-IN, which is equipped with an
adapter for external power supply, it can occur that the audio signal is interrupted. This
depends on the quality of the adapter which is used.

The loudspeakers in the vehicle are matched to a power output of the radio of
4x20 W.

For the equipment sound system*, the loudspeakers are matched to a power
output of the amplifier of 4x40 W + 6x20 W.
s214.14.book Page 10 Thursd ay, January 28, 2010 1:29 PM