sensor SKODA OCTAVIA 2009 2.G / (1Z) Amundsen Navigation System Manual
[x] Cancel search | Manufacturer: SKODA, Model Year: 2009, Model line: OCTAVIA, Model: SKODA OCTAVIA 2009 2.G / (1Z)Pages: 38, PDF Size: 2.52 MB
Page 13 of 38

Range selector key SETUP
11
– Press on the button , doing so always chooses the
frequency for the heard radio statio
n which offers the best reception
at the present time.
– When pressing on the button , the unit attempts to hold a radio
station emitting regionally long en
ough until the reception quality is
so bad, that there is a risk of a program loss.
Delete stored stations – Press the function key and confirm the following safety interroga-
tion in order to delete all radio stations stored in the memory list.
Tra f f i c s t a t i o n s e t - u p sPress the range selector key and then the range selector key
.
Switching the traffic announcements on or off A tick in the check box
7 indicates that the traffic radio function is already switched
on. Dynamic route Opens a pop-up window where it is considered if the TMC traffic reports, received during the route calculat
ion, are to be entered.
Screen set-upsPress the button in the
RADIO
mode and then the function keys
and .
Brightness – Press the function key and select the desired setting for
brightness (5°stages) in a pop-up window.
– A light sensor, which is located in the top right corner of the front
panel, is used for the automati
c correction of the brightness
depending on the light conditions in the vehicle.
Day/Night – Press on the func tion key and s el ec t a setting in the pop-up
window.
– Press the function key if switching the headlights on and off
should also change the map display from night to day design.
– Press on the function key
or to manually determine the
night and day design of the map display.
Confirmation tone – Press on the function key and select a setting in the
pop-up window.
– Press or to switch the tone for confirmation of a function key
operation on the screen on or off.
Media set-upsPress the button in the
MEDIA
mode.
Function keys in the menu°-°Media•
- a tick in the check box
7 means that the function of the
traffic information is switched on.•
- Check box for setting the play function mode Scan,
Mix and Repeat incl. sub-folder (“switched
on”) or without sub-folder (“switched
off”).•
- Setting the volume of the exte
rnal audio source (audio source
AUX is located on the unit).
Automatic
Fix
Delete memoryAllTRAFFIC
SETUP
Traffic information (TP)
˜ Dynamic routeSETUP
System
Screen
Brightness
Day/Night
Automatic
Day
Night
Confirmation tone
On
OffSETUP
Traffic information (TP)Scan/Mix/Repeat incl.
AUX Volume
s36c.b.book Page 11 Thursday, April 9, 2009 2:50 PM
Page 26 of 38

Range selector key NAV (Navigation)
24
Range selector key NAV (Navigation)OverviewSafety information regarding the use of the navigation systemThe route is recalculated each time if
you ignore driving recommendations or
change the route. This process takes only a few seconds. Driving recommendations can only then be re-transmitted. Incomplete navigation data The navigation system cannot receive any da
ta from GPS satellites if you drive for
longer periods under thick forest canopy or
when your vehicle is in a garage, under-
pass or tunnel. In this case, th
e navigation system orientat
es itself solely with the
help of the vehicle sensors. In regions not at all or only partially digita
lised and stored as such on the navigation
CD, the navigation system will try to prov
ide guidance to the destination. Please
note that under these circumstances the
guidance to the destination may not be
completely correct if, for example, one-wa
y streets and road categories (motorway,
country road etc.) are not at all or only
partially included in the navigation data
used.
WARNING
•
Always concentrate fully on your driv
ing. Inattention by the driver can
lead to accidents and injuries.•
Do not allow yourself to be distracted or loose your concentration, pay
attention to the traffic situation and do not carry out settings or use the radio navigation system.•
Only use the radio navigation system if road, weather and traffic situa-
tions permit this and you are not distracted.•
The various volume settings must be selected in such a way that audible
signals from the outside, such as e.g. a
Martins horn from police cars and fire
brigade, can be heard at all times.
WARNING
•
Please observe the legal requirements
for road traffic when following the
driving recommendations provided by your radio navigation system.•
The driving recommendations provided may vary from current situa-
tions, e.g. due to road works or out of date navigation data. In such a case, always observe the traffic regulations and ignore the driving recommenda-tions.•
Traffic signs and traffice regulations al
ways have priority over the driving
recommendations provided by the navigation system.•
Route guidance is subject to consta
nt changes despite the information
about one-way streets, pedestrian zone
s etc. stored on the navigation CD.
Information on traffic lights, stop and right of way signs, parking and stop- ping restrictions as well as lane constrictions and speed restrictions is not included in the radio navigation system.•
Adjust your speed to suit weather, road and traffic conditions. Do not
allow, for example, the radio navigation
system to make you drive faster in
fog - risk of accident!GeneralYou can continue to listen to the radio
or play CDs during the route guidance
When entering an address (town, street), only those letters or symbols which make up a logical entry will be presented. A list
of possible names will be shown. Do not
forget to enter the blank space in names ma
de up of more than one word, such as
High Wycombe. The route will be recalculated if you leave
or disregard the route that was originally
calculated. This process takes only a few seconds. The last voice response can be repeated
by pressing the button or the menu control
button . The volume of a navigation recommendation can be changed whilst it is being made.
A10
s36c.b.book Page 24 Thursday, April 9, 2009 2:50 PM
Page 27 of 38

Range selector key NAV (Navigation)
25
The GPS satellites will not be able to reac
h the aerial once you are in a tunnel or
underground garage. The unit will orie
ntate itself via the wheel sensors.
Note
All dtns. (country-, village-, road-, spec
ial destination names) must be entered
including
all country specific (or language-spe
cific for points of interest) special
characters.Navigation data, navigation CD and memory cardInserting the navigation CD – Push a navigation CD with the written
side facing up as far as possible
into the CD case until it is automatically drawn in.
– If you wish to take out the navigation CD, press the button . Update navigation data – If the data of the navigation CD is
not
identical to the data on the SD
card, a corresponding message will be displayed.
– Press on the function key to overwrite the data stored on the
SD card with the data
from the navigation CD.
Store the navigation data from the navigation CD onto the memory card – Push a navigation CD with the written
side facing up as far as possible
into the CD case until it is automatically drawn in.
– Push the memory card into the card case . – Press the range selector key and while in the main menu
Navi-
gation
, press the range selector key .
– Select the function key using the menu control
button and then press the function keys and .
The navigation data can be stored ei
ther on the CD or on the SD card.
If an SD card with navigation data of the
same country as on the CD is inserted in
the unit (however the data on the CD correspond to a newer version), a question is displayed after inserting the CD asking if the data should be overwritten with the new version or if only the data of th
e CD should be used for navigating.
If an SD card is inserted with the cards
of other countries than the card contained
on the CD, a question is displayed asking
if the data on the CD should be added
onto the SD card or if only the
data of the CD should be used.
You can copy data from seve
ral navigation CDs onto an SD card. The navigation
data on the SD card are automatically li
nked by the navigation system. For this
reason, we recommend to use an SD card
with sufficient memory capacity. A
memory capacity of approx. 4°
GB is necessary in order to copy the navigation data
of Western Europe. Using the data of a navigation CD for a short period of time If you only drive for short
periods through an area which is not stored on the SD
card, insert the navigation CD for the driven area. Up to date navigation data and new navigation CD Road guidance is subject to
constant changes (e.g. new streets, changes of street
names and house numbers). A navigation CD
is a huge data store, which unfortu-
nately will not be up to date after a certai
n time. This can lead to complaints during
route guidance. It is for this reason that you must regula
rly update the navigation data on your unit
with a current navigation CD. Remaining function buttons The following function buttons are only active
if a navigation CD is inserted in the
unit and the memory card
contains navigation data.
•
- displays information regarding the navigation CD
(area and version number
of the navigation CD);
•
- displays information regarding the stored navigation
data and their volume;•
- opens the menu with which you can delete the navi-
gation data on the memory card;
š
Install
A12
NAV
SETUP
Data base navigation
A10
Install data
Start
Show CD data informationShow SD data informationDelete SD navigation data
s36c.b.book Page 25 Thursday, April 9, 2009 2:50 PM