buttons SKODA OCTAVIA TOUR 2004 1.G / (1U) User Guide

78CONTROLS AND EQUIPMENTVentilation (fresh air operation)With the following settings, unheated fresh
air flows out of vents 3 and 4:

Switch off air conditioner by pressing
pushbutton D

Switch off recirculated air mode by press-
ing pushbutton E

Rotary switch B to desired position

Rotary control A fully to the left

Rotary control C to ........................
Open vents 3 and 4
If desired, the rotary control C can also be
turned into other positions.
General notes
If the air conditioning is switched on,
air may flow out of the vents at a tempe-
rature of as low as +5 °C in certain con-
ditions. Lengthy periods sitting in the
car and irregular distribution of the air
flow from the vents (in particular in the
leg area) and large temperature differ-
ences, e.g. when getting out of the car,
may result in more sensitive persons
suffering chills.

For this reason, please follow the in-
structions presented in this chapter.

If the ambient temperature is high and
the air very humid, condensed water may
drip off the evaporator and form a pud-
dle under the vehicle. This is quite nor-
mal and does not indicate a leak.

All the controls can be set to any desired
intermediate position except rotary switch
B (in the range of positions 1 to 4) and the
pushbuttons D and E.
Using air conditioner economically
In the cooling mode, the compressor of
the air conditioner draws power from the
engine and thus affects the fuel consump-
tion.

If the inside temperature is very high
after the car has been parked in the sun, it
is recommended to open doors or windows
briefly to enable the hot air to escape.

The air conditioner should not be switched
on during a journey if the windows are ope-
ned.

If the desired interior temperature can
be reached without switching on the air
conditioner, it is better to select the fresh
air mode.

If the air conditioning system has not
been switched on for a lengthy period,
odours may be produced at the evaporator
because of deposits. Switch on the air con-
ditioning system at least once a month, also
during the cold season of the year, to the
maximum blower speed in order to remove
such odours. At the same time open a win-
dow.

79
CONTROLS AND EQUIPMENT
Climatronic
(automatic air conditioning)*
ControlsPushbuttons
1 - Defrosting windshield
Display panels
2 - Display of blower stage
3 - Display of ambient temperature If the Climatronic is switched off at
pushbutton 11. OFF appears here in
place of the entire display.
4 - Display for defrosting windshield
5 - Display for recirculated air position
6 - Display for direction of air flow
7 - Display of selected interior tempera- ture
8 - Display AUTO (automatic mode), ECON (cooling system OFF) Pushbuttons
9 - Automatic mode
10 - Recirculated air mode
11 - Pushbutton for „Blower slower“ and for
entire system „OFF“
12 - Pushbutton for „Blower faster“ and for switching on entire system
13 - Pushbutton for „Air flow to head“ 14 - Pushbutton for „Air flow into footwell“
15 - Reducing interior temperature
16 - Increasing interior temperature
17 - Pushbutton „ECON“ (cooling system
off)
Interior temperature sensor
18 - Interior temperature sensor (18a - on vehicles with left steering, 18b -
on vehicles with right steering)

80CONTROLS AND EQUIPMENTAfter the appropriate pushbuttons have
been pressed, displays 2, 7 and 8 change
or displays 4, 5 and 6 appear, respectively.
The automatic control of the system can
be influenced with all of the Climatronic
pushbuttons.
Recommended standard setting for all
seasons of the year:
Temperature approx. 22 °C (72 °F), set
pushbutton AUTO mode, vents 3 and 4
so that the air flows to the top.
This setting ensures that a comfortable cli-
mate is achieved as rapidly as possible in
the car.
That is why this setting should only be al-
tered if you so wish for your own personal
well-being.
Arrangement of air vents - refer to page 83.
Operating the Climatronic systemAfter the ignition is switched on, the sys-
tem operates in the automatic mode. The
positions 2, 3 , 7 and 8 then appear in the
display panel.
The Climatronic maintains the selected in-
terior temperature in the car fully automati-
cally.
This is done by automatically changing the
temperature of the air flowing out of the
vents as well as the blower speed (air quan-
tity) and the air distribution.
The system also allows for strong sunlight.
It is therefore not necessary to adjust the
heating manually.
If a variation is made to the automatic mode
before switching off the ignition, the se-
lected functions remain stored perma-
nently. Only the „recirculated air mode“
function is cancelled 20 minutes after the
ignition is switched off.
Switching over from degrees Celsius to
degrees Fahrenheit and vice versa
First of all, press and hold pushbutton 17
and then operate pushbutton 9.
The appropriate unit of measure for the
temperature appears in the display.
Notes on automatic mode (AUTO)The interior temperature can be selected
as desired with pushbuttons 15 and 16. The
temperature remains stored until another
temperature is selected.
The interior temperature can be set be-
tween +18 °C (64 °F) and +29 °C (86 °F).
The system automatically controls the tem-
perature within this range.
If a temperature below 18 °C (64 °F) is se-
lected, „LO“ appears in the display. If a tem-
perature higher than 29 °C (86 °F) is se-
lected, „HI“ appears in the display.
In both of these end positions the system
operates with maximum cooling or heating
capacity, respectively. In such cases, the
temperature is not controlled.
It may be in certain operating conditions
that the system temporarily carries out func-
tions which are not necessarily expected.
For example, after starting the engine when
cold, air may be directed primarily into the
footwell for a few seconds. This is inten-
tional so that any moist air which is still in
the system does not cause the windscreen
to mist up.
If the windscreen mists up, first of all press
the pushbutton 9 and then the pushbutton
1. After the windscreen is free of mist, press
again pushbutton 9.

81
CONTROLS AND EQUIPMENT
Variation from automatic modeThe automatic mode offers the ideal re-
quirements for the well-being of the occu-
pants of the car throughout all the seasons
of the year in practically all cases.
In individual situations, however, it may be
necessary to vary certain subfunctions of
the automatic mode by pressing individual
pushbuttons. In this case, the Climatronic
continues to operate automatically as be-
fore:

The blower speed and thus the air quan-
tity can be increased or reduced by press-
ing pushbuttons 11 and 12. This is indicated
by an increase or reduction in the number
of dashes in position 2.

When pushbutton 1 is pressed
- the ECON mode is switched off,
- the windshield and side windows can be defrosted or kept clear (direct vents 4 to
the side windows),
- the dehumidifying and defrosting effect on the windshield can be intensified. Note
To achieve
intensive demisting of the
windscreen, press button 1, set the blower
to maximum speed (button 12) and in-
crease the temperature by pressing button
16 until the display „HI“ appears. The air
vents for upper and lower body must be
closed (button 13 and 14). The air vents 3
must be closed - refer to p. 103. The recir-
culated air mode must be switched off -
button 10.

The recirculated air mode is switched
on and off by pressing button 10. The sym-
bol 5 appears in the display.
The recirculated air mode prevents polluted
ambient air from entering the interior of the
car, for example when driving through a
tunnel or in congested traffic.
The recirculated air mode can also be se-
lected in order to warm up or cool down the
vehicle particularly rapidly. In this operat-
ing state, the air is drawn out of the interior
of the car and is heated or cooled, respec-
tively.
Warning
The recirculated air mode must only
be used for short periods as no fresh
air is supplied to the interior and the
windows may mist up.

82CONTROLS AND EQUIPMENTIt is recommended not to smoke inside the
car when using the recirculated air mode as
the smoke which is drawn out of the interior
settles on the evaporator of the Climatronic
system. This produces a permanent odour
problem when the Climatronic system is op-
erated, which can only be eliminated by re-
placing the evaporator.
The air flow can be directed to the head
or into the footwell by pressing the push-
buttons 13 and 14.
The air distribution buttons 1, 13 and 14 can
also be pressed in combination.
The cooling system is switched off with
pushbutton 17 (ECON). In this operating
mode, the heating system is controlled
automatically (without dehumidification and
cooling effect) and the desired interior tem-
perature is reached as rapidly as possible
and maintained at a constant level.
The ECON mode is switched off by press-
ing pushbutton 1. It is sufficient to once
again press pushbutton 17 to switch on the
ECON mode again. Please note that in the ECON mode the
desired interior temperature cannot be any
lower than the ambient temperature.


You can set the interior temperature with
pushbuttons 15 and 16.
The combination of ECON mode and
recirculated air is only possible if first of all
pushbutton 10 is pressed in the ECON
mode and then the ECON button 17.
The ECON mode is switched off by press-
ing pushbuttons 1, 9 or 10.

You can switch off the entire Climatronic
system (heating, cooling, ventilation) with
pushbutton 11. To do this, press and hold
pushbutton 11 until the first blower stage
appears in position 2. Once again press
pushbutton 11 to switch off the system. Only
„OFF“ appears in the entire display 3.
Use this function only in exceptional cases,
e.g. if there is a fault in the system. It is not
normally necessary to switch off the entire
system. Note
Once you no longer require the special
functions, switch on the automatic mode
again right away by pressing pushbutton
9
(AUTO).

83
CONTROLS AND EQUIPMENT
Air ventsHeated or unheated fresh air flows out of
all the vents after the appropriate push-
buttons are pressed.
The vents are controlled with pushbuttons
1, 13 and 14.
The vents 3 and 4 can also be closed and
opened individually with the vertical thumb-
wheel:
Vent closed - vertical thumbwheel of air
outlet vent in position A and C
Vent open fully - vertical thumbwheel of air
outlet vent in position B.It is also possible to alter the direction of the
air flow with the horizontal and vertical
thumbwheels of the air outlet vents 3 and 4.
The vertical air flow is regulated by the po-
sition of the side knurled wheel.
The horizontal air flow is regulated by the
knurled wheel below the air vent grille.
The rear footwell vents are controlled to-
gether with vents 5. Warning


Clear visibility is an essential ele-
ment of road safety. It is only assured
if all the windows of the car are free
of ice, snow and misting.
For this reason, please familiarize
yourself with the correct operation of
the heating and ventilation system,
dehumidifying and defrosting the
windows as well as with the cooling
mode.

Maximum heating capacity and
rapid demisting of the windows can
only be achieved once the engine has
reached its normal operating tem-
perature.