key battery SKODA ROOMSTER 2010 1.G Blues Car Radio Manual

Using the display
Carefully handle the display because dents and scratches can occur through pres-
sure of the finger or contact with sharp objects.
The display can be cleaned with a soft cloth and finger marks can be wiped away
with pure alcohol. Note
Do not use solvent such as turpentine or petrol as they will corrode the display
surface. Ð
Anti-theft protection Anti-theft coding Your radio is equipped with a convenience coding. If the radio is being operated
for the first time, the safety code is not only stored in the radio but also in the ve-
hicle.
After disconnecting and reconnecting the battery, first of all switch on the ignition
and then the radio.
If you wish to install the radio in another vehicle, the safety code must be entered.
In this case, please do not hesitate to contact a
ŠKODA Service Partner or a
ŠKODA importer.
As the unit only functions after entering the safety code, this practically excludes
its use after a theft - a contribution to increased anti-theft safety. Note
The code is stored in the instrument cluster. This ensures that it is automatically
decoded (convenience coding). Manual input of the code is normally not necessa-
ry. Ð
Enter code –
Switch on the radio if the ignition is on. SAFE
is displayed and then 1000.
– Enter the safety code using the function keys 1 -
4 .
– Confirm the safety code by pressing down on the function key 6 .If you have confirmed a wrongly entered code, you can repeat once again the en-
tire process.
If the code number is entered incorrectly for the second time, the unit will be
blocked for approx. one hour. It is possible to enter again the safety code after
one hour has expired, when the unit and the ignition have been switched on.
The cycle - two attempts, blocked for an hour - will continue to apply. Ð
Basic setting Switching the unit on and off –
The system is switched on or off by pressing the control button 1 .
If the key is pulled out of the ignition lock while the unit is switched on, the unit
will switch off automatically. You can switch on the unit again by pressing the
control button 1 . If the ignition is switched off, the unit (discharge protection of
the vehicle battery) switches off automatically after approx. one hour.
If you have switched off the radio by withdrawing the ignition key, the radio
switches on again once the ignition is on. Ð
Tone settings –
Press the button  repeatedly to select the desired parameter.
– Set the desired value by turning the rotary/push knob 2 .
You can select between the following parameters:
● TRE - Treble setting;
● BAS - Bass setting;
● BAL
- setting of the volume ratio between the left and the right side;
● FAD* - setting of the volume ratio between the front and the rear. Ð
Setting the special functions –
Press the button MENU afterwards select the function key
SET. You activated
the Setup menu.
– You can select individual functions of the menu by pressing the function keys.  3
General information