fuse SKODA SUPERB 2012 2.G / (B6/3T) User Guide

[x] Cancel search | Manufacturer: SKODA, Model Year: 2012, Model line: SUPERB, Model: SKODA SUPERB 2012 2.G / (B6/3T)
Pages: 235, PDF Size: 5.86 MB

Load previous 10 pages

Page 213 of 235

SKODA SUPERB 2012 2.G / (B6/3T) User Guide ›
Switch off the ignition and all of the lights before replacing a bulb.
› Faulty bulbs must only be replaced with the same type of bulbs. The designa-
tion is located on the light socket or the g

›
Switch off the ignition and all of the lights before replacing a bulb.
› Faulty bulbs must only be replaced with the same type of bulbs. The designa-
tion is located on the light socket or the glass bulb.
› A stowage compartment for replacement bulbs is located in a plastic box in the
spare wheel or underneath the floor covering in the boot. WARNING
■ Accidents can be caused if the road in front of the vehicle is not sufficiently
illuminated and the vehicle cannot or can only be seen with difficulty by other
road users.
■ Always read and observe the warnings before completing any work in the
engine compartment » page 176, Engine compartment .
■ Bulbs H7 and H3 are pressurised and may burst when changing the bulb -
risk of injury! We therefore recommended wearing gloves and safety glasses
when changing a bulb. ■ Gas discharge bulbs (xenon bulbs) operate with a high voltage, professional
knowledge is required - danger to life! CAUTION
■ Do not take hold of the glass bulb with naked fingers (even the smallest
amount of dirt reduces the working life of the light bulb). Use a clean cloth, nap-
kin, or similar. ■ When removing and installing the tail light make sure that the paintwork of the
vehicle and the tail light are not damaged. Note
■ This Owner's Manual only describes the replacement of bulbs where it is possi-
ble to replace the bulbs on your own without any complications arising. Other
light bulbs should be changed by a
ŠKODA specialist garage.
■ We recommend that a box of replacement bulbs be always carried in the vehi-
cle. Replacement bulbs can be purchased from
ŠKODAOriginal Accessories.
■ We recommend that the headlight settings are checked by a ŠKODA specialist
garage after replacing a bulb in the main or low beam.
■ Gas discharge bulbs and LED diodes are replaced by a ŠKODA specialist garage. Ð Headlights
Fig. 186
Headlights: Location of the bulbs/Removing bulbs for the parking
light and main beam Fig. 187
Removing the bulb for the low
beam
First read and observe the introductory information and safety warn-
ings on page 210.
Overview of the location of the bulbs
» Fig. 186. 1
- parking light and main beam
2
- low beam light
3
- front turn signal light
Change the light bulb for the parking light
› Open the bonnet.
› Remove the rubber cover 1
» Fig. 186
.
› Remove the holder A
»
Fig. 186
.
› Remove the faulty bulb from the holder and insert a new one.
£
ä
211
Fuses and light bulbs

Page 215 of 235

SKODA SUPERB 2012 2.G / (B6/3T) User Guide Tail lamp assembly
Fig. 189
Outer part of the tail light/Removing the internal part of the tail
light Fig. 190
Outer part of the tail light: Bulbs/Inner part of the tail light: Bulbs
First read and

Tail lamp assembly
Fig. 189
Outer part of the tail light/Removing the internal part of the tail
light Fig. 190
Outer part of the tail light: Bulbs/Inner part of the tail light: Bulbs
First read and observe the introductory information and safety warn-
ings on page 210.
Overview of the location of the bulbs
» Fig. 190. 1
- Turn signal lights
2
- Parking lights/Brake light
3
- parking lights
4
- Reversing light
5
- Rear fog light
ä Removing and installing the outer part of the tail light
› Open the boot lid.
› Remove the plug
» Fig. 189 -  and unscrew the tail light with a torx
wrench » page 196, Vehicle tool kit .
› Carefully remove the light. Do not pull the grommet with the cables out of the
bodywork.
› To re-install the tail light, first of all guide it with the support A
°» Fig. 190 to-
wards the front onto a bolt on the bodywork.
› Carefully press the tail light onto the bodywork.
› Screw the tail light into place and push in the plugs
» Fig. 189 - .
Changing bulbs in the outer part of the tail light
› To replace the bulb, turn the bulb holder
anti-clockwise up to the stop and re-
move it from the housing.
› Replace the bulb, insert the holder with the bulb into the housing and turn
in a
clockwise direction to the the stop.
Removing and installing the inner part of the tail light
› Open the boot lid.
› Remove the tail light cover on the inner side of the boot lid
» Fig. 189 -  .
› Press the lug
» Fig. 189 -  and remove the lamp holder from the tail light
housing.
› To re-install, insert the lamp holder into the tail light housing.
› Press the lug until it clicks into place.
› Insert the tail light cover on the inner side of the boot lid.
Changing bulbs in the inner part of the tail light
› Remove the faulty bulb 4
» Fig. 190
from the holder and insert a new bulb.
› Turn the bulb 5
in an anti-clockwise direction
up to the stop and remove. In-
sert a new bulb into the holder and turn in a clockwise direction to the the
stop. Ð
213
Fuses and light bulbs

Page 217 of 235

SKODA SUPERB 2012 2.G / (B6/3T) User Guide Licence plate light (Combi)
Fig. 193
Boot lid: Licence plate light
First read and observe the introductory information and safety warn-
ings on page 210.
›
Insert a flat screwdriver into the open

Page 229 of 235

SKODA SUPERB 2012 2.G / (B6/3T) User Guide Engine
Running in 158
Starting and stopping the engine 103
Engine compartment Brake fluid 181
Coolant 179
Overview 178
Vehicle battery 182
Engine oil Changing 179
Checking 178
Replenishing 179
Engine

Page 230 of 235

SKODA SUPERB 2012 2.G / (B6/3T) User Guide Lights
Indicator lights 18
switching on and off 49
Loads 216
Locking Remote control 31
Locking and unlocking from the inside 30
M
MAXI DOT 15
Main menu 16
Settings 16
Mirror Additional interior mirror

Page: < prev 1-10 11-20