diagram SKODA YETI 2009 1.G / 5L Owner's Manual

Wheels and Tyres
217
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Changing wheels aroundIf significantly greater wear is present on the front tyres, we recommend changing the front wheels around with the rear wheels as shown in the diagram
⇒fig. 180
. You will
then obtain approximately the
same life for all the tyres.
It may be advantageous to swap the tyres ov
er “crosswise” when certain types of wear
characteristic arise on the running surface of
the tyres (but not in the case of unidirec-
tional tyres). The co-workers of the authorised Škoda Service Partners are extensively familiar with the combination possibilites. We recommend that you change the wheels around every 10 000 km in order to achieve even wear on all wheels and to obtain optimal tyre life.New tyres and wheelsTyres and wheel rims are important design elements. One should therefore use the tyres and wheel rims which have been releas
ed for use by Škoda Auto. They are exactly
matched to the vehicle type and therefore
contribute significantly to good road
holding and safe driving characteristics
⇒
.
Only fit radial tyres of the same type on all 4 wheels, size (rolling circumference) and, if possible, the same tread pattern on one axle. The authorised Škoda Service Partners have
access to the most current information
about which tyres we have rele
ased for use on
your vehicle.
We recommend that you have any work relati
ng to tyres or wheels carried out by an
authorised Škoda Service Partner
. The authorised Škoda Service Partners have all of
the necessary special tools and replacement pa
rts available plus the required specialist
knowledge and are also in a position to pr
operly dispose of the old tyres. A large
number of authorised Škoda Service Partners also have an attractive range of tyres and wheels available. The tyre/wheel combinations which are appr
oved for your vehicle are indicated in
your vehicle documents. Approval and licensing may differ according to the legislation prevailing in individual countries. Proper knowledge of the tyre data makes it easier for you to select the correct type of tyre. Tyres do, for example, have the following
inscription
on their walls:
225 / 50R 17 91 T
What this means is: The following
speed restrictions
apply to tyres.
The date of manufacture
is also stated on the tyre wall (possibly only on the
inside
of
wheel):
DOT ... 45 09...
Fig. 180 Changing wheels around
225
Tyre wi dt h i n mm
50
Height/width ratio in %
R
Code letter for the type of tyre -
Radial
17
Diameter of wheel in inches
91
Load index
T
Speed symbol
Speed symbol
Permissible maximum speed
S
180 km/h
T
190 km/h
H
210 km/h
V
240 km/h
W
270 km/h
Y
300 km/h
sgg.6.book Page 217 Thursday, September 24, 2009 2:32 PM