Park SMART FORTWO COUPE 2008 Repair Manual

Towing
278
>> Practical hints.
About towingsmart recommends that the vehicle be trans

ported with all wheels off the ground using
flatbed or appropriate wheel lift/dolly equip

ment.!
Use flatbed or wheel lift/dolly equipment
with the key in the starter switch in position0.
Do not tow with sling
type equipment. Towing
with sling
type equipment over bumpy roads
will damage radiator and supports.
To prevent damage during transport, do not
tie down the vehicle by its chassis or suspen

sion parts. Use the towing eye.
Switch off the tow
away protection*
(
page 78).
When circumstances do not permit the
recommended towing methods, the vehicle
may be towed with all wheels on the ground or
front wheels raised only so far as necessary
to have the vehicle moved to a safe location
where the recommended towing methods can
be employed.
!
If the vehicle is towed with the front axle
raised, the gear selector lever must be in
neutral positionN and the engine must be shut
off (key in starter switch position0). Active
braking action through the ESP
® may other

wise seriously damage the brake system.
When towing the vehicle with all wheels on the
ground, the gear selector lever must be in
neutral positionN and the key must be in
starter switch position0.
When towing the vehicle with all wheels on the
ground or the front axle raised, the vehicle
may be towed only for distances up to 30 miles
(50 km) and at a speed not to exceed 30 mph
(50 km/h).
i
If the the battery is disconnected or dis

charged the gear selector lever will remain
locked in park position P. Contact an autho

rized smart center for assistance or call
Roadside Assistance.G
Warning!
smart does not recommend towing a vehi

cle when all wheels are on the ground.
However, in an emergency a tow bar can
be utilized if:
• the engine will not run
• there is a malfunction in the brake
system
• there is a malfunction in the power
supply or in the vehicle’s electrical
system
A tow bar is necessary to adequately con

trol the towed vehicle.
Prior to towing the vehicle with all wheels
on the ground, make sure that the key is
in starter switch position0.

Towing
>> Practical hints.
281 Towing the vehicle
Towing with all wheels on the ground or front
axle raised: !
The vehicle may only be towed when:
• You are sure that no gear is engaged,
• the engine is shut off,
• the key is in starter switch position0.
>Set the parking brake.
>Secure the towing rope or tow bar to the
towing eye.
>Depress the brake pedal.
>Move the gear selector lever to neutral
positionN.appears in the transmission position
indicator.
>Turn the key in starter switch position0
>Release the parking brake.
>Release the brake pedal.

Fuses
282
>> Practical hints. The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and systems
secured by that fuse will stop operating.
!
A blown fuse must be replaced by an
appropriate spare fuse (recognizable by its
color or the fuse rating given on the fuse) of
the amperage recommended in the fuse chart.
Any smart center will be glad to advise you on
this subject.
If a newly inserted fuse blows again, have the
cause determined and rectified at an autho

rized smart center.Before replacing fuses:
>Set the parking brake.
>Make sure the gear selector lever is in park
positionP.
>Turn off all electrical accessories.
>Turn off the engine.
>Remove the key from the starter switch.
G
Warning!
Only use fuses approved by smart with
the specified amperage for the system in
question and do not attempt to repair or
bridge a blown fuse this may cause an
overload leading to a fire, and/or cause
damage to electrical components and/or
systems. Contact a smart centert if you
encounter any electrical problems.

Fuses
284
>> Practical hints.
Fuse chartNo.
Accessory/Componant
Amperage
Color
1
Engine
25 A
Neutral
2
Windshield wipers
25 A
Neutral
3
Power window, left and right
20 A
Yellow
4
Blower
25 A
Neutral
5
Front fog lamps
10 A
Red
6
Right parking and lamp, instrument lighting, terminal 58R
7.5 A
Brown
7
Parking and lamp, left
7.5 A
Brown
8
Engine
25 A
Neutral
9
Engine
7.5 A
Brown
10
Engine
15 A
Blue
11
ESP
®
25 A
Neutral
12
Switches strip, on
board diagnosis socket, turn signal lamp, transmission
control unit
10 A
Red
13






14
Charge air cooler, air conditioning compressor
15 A
Blue
15
Audio, subwoofer, interior lighting
15 A
Blue
16
Fuel pump
15 A
Blue
17
Rear window wiper (coupé only)
15 A
Blue
18
ESP
®, power steering, air bag, instrument panel
10 A
Red
19
Motor control unit, on
board diagnosis socket, transmission control unit
7.5 A
Brown
20
Air conditioning system, exterior mirror adjustment, washer pump, audio,
seat heating, gear selector lever control unit
10 A
Red

Electrical system
300
>> Technical data.
Electrical system
All models
Generator (alternator)
14 V/90 A
Starter motor
12 V/0.95 kW
Battery
12 V/42 Ah
Spark plugs
DENSO XU22 HDR9
Electrode gap
0.035 in (0.9 mm)
Tightening torque
11
15lb
ft(15
20Nm)

Service fluids and capacities
306
>> Technical data.
Premium unleaded gasoline
!
To maintain the engine’s durability and
performance, premium unleaded gasoline
must be used. If premium unleaded gasoline is
not available and low octane fuel is used,
follow these precautions:
• Have the fuel tank only partially filled with
unleaded regular gasoline and fill up with
premium unleaded gasoline as soon as
possible.
• Avoid full throttle driving and abrupt
acceleration.
• Do not exceed an engine speed of 3 000 rpm
if the vehicle is loaded with a light load such
as two persons and no cargo.
•Do not exceed
2/3 of maximum accelerator
pedal position if the vehicle is fully loaded
or operating in mountainous terrain.
Fuel requirementsOnly use premium unleaded fuel:
• The octane number (posted at the pump)
must be 91 min.
It is an average of both the R
esearch
O
ctane N
umber (RON) and the M
otor O
ctane
N
umber (MON): (RON+MON) /2. This is also
known as the ANTI
KNOCK INDEX.
Unleaded gasoline containing oxygenates
such as ethanol, IPA, IBA and TBA can be used
provided the ratio of any one of these
oxygenates to gasoline does not exceed 10%;
MTBE must not exceed 15%.
The ratio of methanol to gasoline must not
exceed 3% plus additional cosolvents.
Using mixtures of ethanol and methanol is not
allowed. Gasohol, which contains 10% ethanol
and 90% unleaded gasoline, can be used.
These blends must also meet all other fuel
requirements, such as resistance to spark
knock, boiling range, vapor pressure, etc.
G
Warning!
Gasoline is highly flammable and poison

ous. It burns violently and can cause
serious personal injury.
Never allow sparks, flame or smoking
materials near gasoline!
Turn off the engine before refueling.
Whenever you are around gasoline, avoid
inhaling fumes and skin or clothing
contact, extinguish all smoking materials.
Direct skin contact with fuels and the
inhalation of fuel vapors are damaging to
your health.