remote start SSANGYONG KORANDO 2012 Service Manual

01-8
Steering wheel remote
control switchPassenger door switch
Lower main panel
switch
Start/stop switch
Cruise control switch
Hazard warning switch
bezel assembly
Multifunction switch
FATC switch
Drive door main switch
& Outside rearview mirror
switch
3. SWITCH SYSTEM LAYOUT

03-46
Panic alarm by SKM smart key's remote control ▶
When the BCM receives "Panic command by smart key remote control" as a BCAN signal, it
activates panic alarm by operating the horn and turn signal lamp for 30 seconds with a interval of
0.5s ON/0.5s OFF. However, the BCM used in EU region is operated when receiving the panic
command from the smart key remote control and the signal that the smart key is in the vehicle with
Power OFF, ACC and IGN ON.
The BCM stops the panic function and operates the function depending on the signal in the event of
following commands during turn signal lamp and horn operation by the "Panic command from smart
key remote control".
The panic alarm stops and then the theft deterrent alarm starts its operation when occurring the theft
deterrent alarm conditions during panic alarm.
All the functions are controlled by SKM and operated by signal from SKM. 1.
2.
3.
4.
Stops panic function activated by "Panic command from smart key remote control" through
BCAN signal
Panic function is activated when receiving other command -
-

03-68
2. IMMOBILIZER/REMOTE CONTROL KEY CODING
1) System Overview
While the communication between BCM/SKM and ECU is based on the CAN communication, the
communication between transponder and BCM/SKM is based on LF (Low frequency) and RF (Radio
frequency). When the ignition switch is turned to ON position, the BCM checks the verified transponder
according to the immobilizer verification procedure, if correct, allows the vehicle to start the engine. The
immobilizer indicator comes on during the communication and if the verification is carried out
successfully the indicator goes off.
If there is something wrong in the system, the indicator blinks.
2) System Layout

03-70
4) Components of REKES Key
Battery cover
Side & main cover Battery: CR2032TransponderKey plate Remote control PCB
How to replace battery ▶
Remove the battery cover using a flat screwdriver to replace the battery.
How to replace transponder ▶
Remove battery cover and battery
Remove rubber cover and screw then remove key plate
Remove side cover and main cover
Replace transponder -
-
-
-
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, please attend on the site.
In any cases, the immobilizer system can not be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove, damage
or modify it.
The remote engine starter cannot be installed to the vehicle equipped with the immobilizer system. -
-
-
-
-

04-4
1. SYSTEM LAYOUT
The vehicles with smart key system are equipped with the SKM (Smart Key Module) unit. The SKM,
which does not use the traditional key or remote controller to access the vehicle, provides 3 functions.
The passive UNLOCK function unlocks the door after confirming the smart key information and the
driver's door conditions when the driver carrying a smart key touches the door handle. The passive
START function starts the engine when the START switch is pressed by the driver sitting on the driver's
seat. The passive LOCK function locks the door when the door handle switch is pressed by the driver
after exiting the vehicle.
Buzzer
Start switch
SKM unit
Outside door handle
switch and antenna

06-6
Steering wheel remote
control switchPassenger door switch
Lower main panel
switch
Start/stop switch
Cruise control switch
Hazard warning switch
bezel assembly
Multifunction switch
FATC switchDrive door main switch
& outside mirror switch
Switch layout ▶