refrigerant type SSANGYONG MUSSO 1998 Workshop Repair Manual

7B/C-2 MANUAL & SEMIAUTO-HVAC
Application
Type
Capacity
Condenser Fan Motor OutputDescription
Parallel type (Multi Flow Condenser)
11,000 kcal/h
160W
CONDENSER
Application
Desiccant
Type
CapacityDescription
XH - 9 (30g)
Aluminum type
240cc
RECEIVER DRIER
Application
High
LowDescription
OFF: 27±2kgf / cm
2, DIFF : 6±2kgf / cm2
OFF : 1.8±0.2kgf / cm2, ON 1.9±0.3kgf/ cm2
DUAL PRESSURE SWITCH
SPECIFICATIONS
COOLING CAPACITY
Application
Type
Max. Capacity
Max. Blowing Capacity
Refrigerant
Refrigerant AmountDescription
Air mix type
4,500kcal/h
7.Om
3/min
R134a
650 - 75Og
Application
Model
Type
Output
Oil
Magnetic Clutch OutputDescription
FK- ll
Vane rotary type
140.5cc/rev
ZXL 200PG (PAG oil)
45W
COMPRESSOR

MANUAL & SEMIAUTO-HVAC 7B/C-13
Replacement of Refrigerant Connection (O-ring
Type)
1. When connecting a O-ring type, apply compressor oil to
portions shown in illustration. Be careful not to apply oil to
threaded portion.
Notice
Use specified compressor oil.
2. O-rings must be closely attached to inflated portion of pipe
and always replace used O-rings.
3. After inserting the pipe to the union, tighten the nut by hand
as much as possible and tighten the nut to specified torque.
4. When connecting liquid pipe(B) and low pressure hose(A)
to evaporate pipe, apply compressor oil to the O-ring.
5. When tightening, set the center of pipe and tighten fully.
6. Tighten the nut by specified wrench.
Installation Notice
Tightening Torque Inlet Side to 12 - 15Nm
Low Pressure Hose (A) 30 - 35 Nm