remote control SSANGYONG NEW ACTYON SPORTS 2012 User Guide

02-52
Specification of Receiver ▶
Operating requirements 1.
You should remove the ignition key. -
Code registration requirement 2.
You can register the code only using the diagnostic device. -
Transmitter code registration 3.
You can register up to 5 transmission codes to the remote control key.
The receiver does not output the received code during registration.
Connect the device to the diagnostic terminal.
The code can be registered only by the panic signal from the transmitter.
(Other switches (LOCK/UNLOCK/ESCORT) can't code.) a.
b.
c.
Remote Door Lock ▶
All doors are locked when briefly pressing the door LOCK burron on remote control key (less
than 0.5 seconds).
The system outputs LOCK signal immediately after receiving the door lock message from the
remote control key. The system activates the theft deterrent mode when all doors are locked
while they are fully closed (the hazard warning lamps blink twice.). 1.
2.

02-538710-01
Door Unlock ▶
The door unlock operates when pressing the door switch on the remote control key for longer
than 0.5 seconds.
The door unlock relay is "ON" for 0.5 seconds when receiving the door unlock message from
the remote control key.
The hazard warning lamps blink once only when all the doors unlocked successfuly. 1.
2.
3.

02-54
Remote Panic ▶
If you press and hold the door UNLOCK and PANIC button (more than 2 seconds) on the
remote control key, the panic function is activated.
The vehicle activates the panic alarm by using the horn and hazard warning lamp for 27
seconds when receiving the panic message from the remote control key. 1.
2.

02-558710-01
Remote Escort ▶
When you press and hold the door LOCK button (more than 0.5 seconds) the escort function
is activated.
The headlamp comes on for 20 seconds and goes off automatically, when the escort
message is received from the remote control key. 1.
2.
Auto Door Lock in 30 Seconds after Pressing Door Unlock Button ▶
If no door is opened for 30 seconds after inputting remote door unlock, the doors are
automatically locked and the armed mode of anti-theft system is activated again (RELOCK
function). 1.

02-60
You can register up to 2 transmission codes to the remote control key.
The receiver does not output the received code during registration.
The remote control key should be coded using the diagnostic device. a.
b.
c.
1) Operating requirements
You should remove the ignition key.
2) Code registration requirement
You can register the code only using the diagnostic device.
3) Transmitter code registration
5. REKES Key Coding

02-618710-01
4) How to Code REKES Key
If you replace the REKES key or immobilizer & rechargeable key to new one, you should code the
REKES key using the diagnostic device. (maximum 5)
Connect the diagnostic device to the vehilce and select the vehicle type and system (RK-
STICS). When the following screen is displayed, select 'REMOCON CODING'. 1.
Remove the remote control key from the ignition key box and press 'Next'. Press the door
UNLOCK (PANIC) button on the remote control key once (for approx. 2 seconds or longer). 2.

02-62
When you code newly purchased remote control key:
When you lost the remote control key and purchase a new one, if you code only the newly
purchased one, the existing remote control key becomes unavailable. You must code the
newly purchased remote control key together with the existing one. -The first key coding completion screen is displayed with beep sound as follows: Press 'Next'
and perform the second remote control key coding in the same way. 3.
When the second key coding is completed, the following screen is displayed. Finish the
remote control key coding by pressing 'Previous'. 4.
Exit the diagnostic screen, remove the device from the diagnostic connector and perform the
function test for the remote control key. If it does not work well, perform the above procedures
again. 5.

03-57010-06
Item Front view Rear view Internal structure
Rechargeable key
RKSTICS key
DifferenceNoneLabel color,
Specification displayBattery specification
and
transponder function
2. OVERVIEW
The functions of the immobilizer and the rechargeable key are controlled by the immobilizer &
rechargeable unit. Both functions are used in this system. This immobilizer & rechargeable unit
starts the engine by communicating with the engine control unit and increases the life of the
existing REKES battery by charging the battery of the remote control key.
Immobilizer & rechargeable unit
Rechargeable Key VS RKSTICS Key ▶
Rechargeable
battery used

03-6
3. FUNCTIONS OF IMMOBILIZER & RECHARGEABLE KEY
The functions of the immobilizer and rechargeable key are similar to that of the normal REKES
key. But, there are the immobilizer function that permits the engine to start only after confirming
the encrypted coding and battery charging function.
The followings are common functions of the normal REKES key and the immobilizer &
rechargeable key.
Door Unlock and Panic Function
Breifly press (below 0.5 sec): Door unlock and
　　　　　　　　　　　　 theft deterrent
mode deactivated
Press and hold (over 2 sec): Panic function
1. Door unlock (Briefly press)
If you send the door unlock signal using the
remote control key, with all the doors locked,
the door will be opened and the theft
deterrent mode will be deactivated. If the
door coupled switch of front room lamp is
pressed, the lamp will come on for 30
seconds. It will turn off immediately after the
lock button of the remote control is pressed.
2. Panic function: activated in the theft deterrent mode
When pressing the door UNLOCK and PANIC button for
approx. 2 seconds or longer, the warning alarm sounds
and the hazard warning lamp blinks for approx. 27
seconds.
The function is inactivated if any button of remote control
is pressed. ·
·
Breifly press (below 0.5 sec): Door lock and theft deterrent mode is activated
Press and hold (over 0.5 sec): Escort function
1. Door unlock (Briefly press)
Pressing this button locks all doors and activates the theft deterrent mode.
2. Escort function
If you press the button for more than 0.5 seconds in theft deterrent mode, the headlamp
comes on for about 20 seconds.
This function is deactivated if you press the door lock button of the remote control key. ·
·LED flasher
Briefly press: blink once
Press and hold: blink twice
Door Lock and Escort Function

03-97010-06
Immobilizer and Warning Lamp ▶
This indicator comes on when the ignition key
is communicating with the engine control unit
(during engine starting) and goes out after
starting the engine.
When turning the ignition key to the "ON"
position, the ECU (engine control unit)
transmits the challenge message to the
immobilizer & rechargeable unit.
(This is to verify whether the key is valid. If the
verification fails, it transmits re-verification
signals 3 times for 2 seconds. If three re-
verifications fail, it stops verification and starts
re-verification after 10 seconds.) (1)
ECUOnly when the two signals are identical, it recognizes the
key as the authorized one and transmits the positive
message to the ECU. (6)
The ECU enable the engine to be started. (7)
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, please attend on the site.
In any cases, the immobilizer system can not be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove,
damage or modify it.
The remote engine starter cannot be installed to the vehicle equipped with the immobilizer
system. ·
·
·
·
·ON: In communication
Blinks twice at one second intervals: Immobilizer
system fault
Blinks once at 2 second intervals: Immobilizer unit
not coded
The immobilizer indicator does not come
on if the communication time between
immobilizer key and ECU is too short.
Instrument
panel