lock SSANGYONG REXTON 2006 Service Manual

RKSTICS
undefined
8710-08
Ignition Key Reminder
The system outputs "UNLOCK" signal for 5 seconds after the driver's door is opened and
the door lock switch is changed to "LOCK" (while the ignition key is in ignition switch).
The system outputs "UNLOCK" signal for 5 seconds (T2) when the door lock switch is
changed to "LOCK" from "UNLOCK" and the driver's door is closed within 0.5 seconds
(while the ignition key is in the ignition switch).
If the "UNLOCK" conditions are met, the system outputs "UNLOCK" signal unconditionally.
However, if the ignition key is removed after the door lock switch is changed from
"UNLOCK" to "LOCK", the system does not output "UNLOCK" signal. 1.
2.
3.
(*1): Door LOCK switches in both front seats
(*2): Door switches in both front seats

undefined
8710-08
RKSTICS
All Door Lock Prevention Function when a Door is Open
All doors, except the tailgate and hood, output "UNLOCK" signal for 5 seconds when the
"LOCK" signal is inputted (while the ignition key is removed and one of any doors is open).
When the door is closed during the UNLOCK output, the UNLOCK output stops immediately.
When the ignition key is inserted during the UNLOCK output, the output continues for approx. 5
seconds.
If the ignition switch is in the "ON" position or the ignition switch is removed, the above steps
are performed. If the key is in the key cylinder, the ignition key reminder function is activated.
This function does not work if the vehicle speed is over 10 km/h. 1.
2.
3.
4.
5.
(*1) LOCK switches in all doors including tailgate (*2) Door switches in all doors excluding tailgate

RKSTICS
undefined
8710-08
Tail Lamp Left On Warning
The buzzer sounds with the interval of 0.3 second when opening the driver's door while the
tail lamp is turned on and the ignition key is removed.
The buzzer output stops when turning off the tail lamp and closing the driver's door.
The system outputs "UNLOCK" signal for 5 seconds when the driver's and passenger's
door lock switch is locked (while the tail lamp is turned on and the driver's door is open).
This function is not available when the ignition key is in the "ON" position. 1.
2.
3.
4.

undefined
8710-08
RKSTICS
Front/Center Room Lamp Control
The overhead console lamp (front room lamp) comes on when opening the
door(driver's/passenger's) while the door coupled front rooom lamp switch is at the coupled
operating position and the key reminder switch is "OFF".
When the door (Driver's/Passenger's) is opened, the front room lamp comes on.
The room lamp stays on for 2 seconds and then dims out through 3 seconds when closing
the opened door.
The dimming operation must have greater than 32 steps per one second.
The room lamp output should stop immediately after turning on the ignition key during the
dimming operation.
The front room lamp comes on for 30 seconds when receiving the unlock signal from the
remote control key while the doors are closed.
The front room lamp and the center room lamp output period is extended by 30 seconds
when receiving the unlock signal from the remote control key again during output. (The
lamp stays on when unlocked by the remote control key.)
When a door is opened during its extended period, the lamp stays on. If closed, operates as
in step 2.
The room lamp output stops immediately after receiving the lock signal from
driver's/passenger's door lock switches while the driver's and passenger's doors are closed
or entering into the anti-theft mode by pushing LOCK button on the remote control key.
The front room lamp comes on when opening the driver's door or passenger's door and
goes off when closing the opened door while the ignition key is in ON position. 1.
2.
3.
4.
5.
6.
7.
8.
9.

RKSTICS
undefined
8710-08
Front Room LampCenter Room Lamp
Front room lamp (driver's or passenger's) is
turned on and off when pressing the switch (1 o
r
2). However, it comes on when a door is opened
and goes off when the door is closed. The front
room lamp comes on when opening any of front
doors with the front door coupled switch (3)
pressed in.
If the switch is at the door coupled position,
the center room lamp comes on when a rea
r
door is opened. The lamp always comes on
while the switch is at the other position.
Door coupled
switch
Ignition Key Hole Illumination
The ignition key hole illumination comes on when opening the driver's door or passenger's
door when the ignition key is removed.
The ignition key hole illumination stays on for 10 seconds when closing the door after step
1.
The output stops when the ignition key is turned to "ON" position.
The output stops when receiving the lock signal from the remote control key (under anti-
theft mode). 1.
2.
3.
4.
(*1) OPEN : Driver's or Passenger's door = OPEN, CLOSE : Driver's and Passenger's = CLOSE

RKSTICS
undefined
8710-08
Door Lock/Unlock Control by Door Lock Switch
The door lock system outputs "LOCK" signal for 0.5 seconds when positioning the driver's
or passenger's door lock switch to the lock position.
The door lock system outputs "UNLOCK" signal for 0.5 seconds when positioning the
driver's or passenger's door lock switch to the unlock position.
The door lock system outputs "LOCK" signal for 0.5 seconds when switching from LOCK to
UNLOCK by the driver's or passenger's door key cylinder.
The door lock system outputs "UNLOCK" signal for 0.5 seconds when switching from
UNLOCK to LOCK by the driver's or passenger's door key cylinder.
The alarm will not be activated when switched to UNLOCK by driver's or passenger's doo
r
key cylinder switch in theft deterrent mode.
It does not occur abnormal operation when reconnecting the battery after disconnecting the
battery cable.
All door lock signals are "UNLOCK" for 0.5 seconds just for once when receiving the
"LOCK" signal within 0.5 seconds after closing the driver's or passenger's door while the
ignition key is removed. 1.
2.
3.
4.
5.
6.
7.

undefined
8710-08
RKSTICS
Driver's door lock/unlock switch Passenger's door lock/unlock switch
Door Lock/Unlock by Central Door Lock Switch
The door lock system outputs "LOCK/UNLOCK" signal for 0.5 seconds when operating the
central door lock switch. (However, if the door lock switch (front doors) is at LOCK position,
the system outputs UNLOCK signal, and vice versa.)
The "LOCK" or "UNLOCK" inputs from the central door lock switch in anti-theft mode are
ignored. 1.
2.

RKSTICS
undefined
8710-08
Door LOCK/UNLOCK by Remote Control Key
The door lock relay output is "ON" for 0.5 seconds when receiving the remote control lock
signal.
The door unlock relay output is "ON" for 0.5 seconds when receiving the remote control
unlock signal. 1.
2.

undefined
8710-08
RKSTICS
Auto Door Lock
The door lock system outputs "LOCK" when the vehicle speed maintains over 50 km/h.
However, it doesn't output "LOCK" when all doors are locked or failed.
If any of doors is unlocked after outputting "LOCK" in step 1, outputs "LOCK" up to 5 times
(except step 1) at the interval of one second.
If any of doors is unlocked after 5 times of "LOCK" outputs, the door is regarded as "FAIL".
If the door that was regarded as fail changes (UNLOCK to LOCK) to unlock, only one
"LOCK" output will be done.
If any door is regarded as FAIL, the auto door lock function does not work (if it is occurred
when the vehicle speed is over 50 km/h, the auto door lock output does not occur even i
f
the vehicle speed falls below 50 km/h and accelerates again to over 50 km/h.).
Nonetheless, the central door lock function works properly.
When the system receives "UNLOCK" signal from a door switch, it outputs "LOCK" signals 5
times. If additional "LOCK" signal from another door switch is detected during the period, the
system outputs five "LOCK" signals
5 times for the door system outputs five "LOCK" signals 5 times for the door.
The door lock system outputs "UNLOCK" automatically if the "LOCK" output conditions are
established by this function or the key is cycled (IGN1=OFF) (even when there is no "LOCK"
output while the vehicle speed maintains over 50 km/h under lock condition).
(If the LOCK condition is established with the ignition switch ON, the system outputs
UNLOCK signal unconditionally when turning the ignition switch to OFF position.)
However, when the ignition key is turned to "OFF" position, the lock output conditions will be
cancelled.
The "FAIL" condition of the door will be erased when the ignition key is turned to "OFF"
position. 1.
2.
3.
4.
5.
6.
7.
8.

RKSTICS
undefined
8710-08
Auto Door Unlock (Crash Unlock)
The air bag collision signal input cannot be accepted within 7 seconds after turning the
ignition key to "ON" position.
After this period, the door lock system outputs "UNLOCK" for all doors for 5 seconds from
40ms after receiving the air bag collision signal.
Even though the key is turned to "OFF" position during the output of "UNLOCK", the output
continues on for remaining period.
The function is erased when turning "OFF" the IGN switch. 1.
2.
3.
4.
The "Unlock" control by air bag signal prevails over any "LOCK" or "UNLOCK" control by
other functions.
The "LOCK/UNLOCK" request by other functions will be ignored after/during the output
of "UNLOCK" by the air bag.
However, the door lock is controlled by other functions when the ignition switch is "OFF".
"LOCK" (or "UNLOCK") output is ignored if "LOCK" (or "UNLOCK") output is required
while performing the output of "LOCK" (or "UNLOCK").
If the door lock system outputs "LOCK" and "UNLOCK" simultaneously, only the "LOCK"
output can be activated. -
-
-
-