seat SSANGYONG TURISMO 2013 Owner's Guide

03-20
Power Seat
To adjust seat cushion angle
When moving the front and rear parts of the
slide switch upwards or downwards, the front
and rear up/down motors rotate the rails to
move the front and rear side of the cushion
up/down.
To adjust seat height
When moving the slide switch up/down,
the front rear up/down motor rotates the rail to
move the whole seat cushion up/down.Manual Seat
To adjust seat cushion angle and
height
Turn the adjusting knob on the side of the seat
clockwise or anticlockwise to adjust the height
or angle of the front side or rear side of the
cushion.
To adjust driver seat lumbar support
When you raise and lower the adjusting lever
on the power and manual seats, the lumbar
support goes in and out of the seat.
The lumbar support is only fitted to the vehicle without the seat air bag.

03-217410-01
Internal Configuration of Seat Cushion
2) Front Seat Mechanism (Based on Power Seat)
Internal Configuration of Seatback
Lumbar support
Recline motor
Seat cushion rear
up/down motor
Seat cushion rear
up/down railSlide motor
The descriptions in this chapter are based on the driver’s seat and rear 1st seat.
(1) Components
Slide rail
Seat cushion front
up/down rail
Seat cushion front
up/down motor

03-22
Seat cushion angle adjustment (rear
end)
Front side of seat moves
up/down controlled by seat
position control switch
(2) Operation of seat
Sliding
Seat moves from front to rear
controllde by sliding control
switch
Seat cushion angle adjustment
(front end)
Rear side of seat moves
up/down controlled by seat
position control switch

03-237410-01
Seat cushion height adjustment
Seat moves up/down
controlled by seat height
control switch
Seatback reclining
Seat back reclining controlled
by seat reclining control switch

03-24
When seating
When jumping
(3) Operation of center seat
Pull up the center seat when to jump
Push down the center seat when to seat -
-

03-257410-01
Seat back flat cable
(4) Rear 1st & 2nd row seat mechanisms
Seat back folding cable
Flat lever
Seat back
folding cable
Seat back
flat cableFolding lever
Jumping mechanism
Sliding lever
Sliding cable

03-26
(5) Operation of rear seat (Rear 1st and 2nd seat)
Seat sliding ▶
Front
Rear

03-277410-01
Rear 1st/2nd seat
Rear 2nd
Rear 1st
(6) Seat back flat
- When to recline or to flat fully.
(7) Seat back folding
- Fold the rear 1st or 2nd raw seat back to put something on or to utilize it as a table.

03-28
(8) Rear 3rd seat
Pull the lever behind back seat to fold the back seat.
-
As the seat is folded, disconnect hook and spread out the board
-

03-297410-01
Driver & Front
Passenger
Seat Warmer Switches
3) To Activate Driver & Front Passenger Seat Warmer
Operating condition ▶
Turn the ignition key to the "ON" position and start the engine.
If the cranking signal is inputted, the seat warmer stops working during cranking.
Operation description ▶
When pressing the seat warmer switch for the driver and/or front passenger seat with IGN ON, the
seat warmer operates. Press the switch again to stop the seat warmer.
Operation procedures ▶
When pressing the seat warmer switch for the driver and/or front passenger seat, the seat warmer
relay in the ICM box is activated to supply power to the seat warmer.
ICM Box Driver & Front
Passenger
Seat Warmer Activated
The driver and front passenger seat warmers have separate circuits, allowing them to function
independently.