boot SUBARU BRZ 2018 Owners Manual

164 2-1. Driving procedures
BRZ_U (A4450BE-A)
WARNING
■When driving on slippery road surfaces
●Sudden braking, acceleration and steering may cause tire slippage and
reduce your ability to control the vehicle, resulting in an accident.
● Sudden acceleration, engine braking due to shifting, or changes in engine
speed could cause the vehicle to skid, resulting in an accident.
● After driving through a puddle, lightly depress the brake pedal to make
sure that the brakes are functioni ng properly. Wet brake pads may prevent
the brakes from functioning properly. If the brakes on only one side are wet
and not functioning properly, steering control may be affected, resulting in
an accident.
■ When shifting the select lever or shift lever
●On vehicles with an automatic transmission, be careful not to shift the
select lever with the accelerator pedal depressed. Shifting the select lever
to a gear other than P or N may lead to unexpected rapid acceleration of
the vehicle that may cause an accident and result in death or serious
injury.
● Do not place items in the select lever’s or shift lever’s surrounding area. It
may cause incorrect operation.
● If the select lever’s or shift lever’s boot is pulled out during cleaning, return
it to its previous position. If the select lever’s or shift lever’s boot is left
pulled out, the select lever or shift lever may become difficult to operate.
■ If you hear a squealing or scrapin g noise (brake pad wear limit indica-
tors)
Have your SUBARU dealer check and replace the brake pads as soon as
possible.
Rotor damage may result if the pads are not replaced when needed.
It is dangerous to drive the vehicle when the wear limits of the brake pads
and/or those of the brake discs are exceeded. ( →P. 159)
■ Breaking-in of new brake pads and linings
A safe location and situation should be selected for break-in driving.

341
4-1. Maintenance and care
4
Maintenance and care
BRZ_U (A4450BE-A)
CAUTION
■
When using a high pressure car wash
Do not bring the nozzle tip close to boots (rubber or resin manufactured
cover), connectors or the following parts. The parts may be damaged if they
come into contact with high-pressure water.
• Traction related parts
• Steering parts
• Suspension parts
• Brake parts
■ Cleaning the rear bumper cherry red stripe (tS models)
● When using a high pressure car wash (pressure washer) to wash your
vehicle, keep the nozzle a safe distance (11.9 in. [30 cm] or more) from the
stripe. Do not use the high pressure car wash on the same area continu-
ously.
● When using a heated or steam high pressure car wash or extra high-pres-
sure pressure washer, do not point the nozzle directly at the stripe, other-
wise the stripe may come off or be damaged.
● Carefully read the label of a car wash soap before using it, as some car
wash soaps may adversely affect the adhesion strength of the stripe.
● If dirt cannot be removed from the stripe, clean it off using a soft cloth
dampened with a neutral detergent diluted with water.
■ Avoiding damage to the under spoilers (tS models)
● When cleaning the under spoilers, do not use organic substances such as
gasoline, paint thinner, acidic or alkaline solutions, or other detergent.
● The under spoilers may deform if exposed to high temperatures or
extreme heat.