cam SUBARU FORESTER 1999 Service Repair Manual

3B22 : CHECK ACCELERATOR CABLE.
Check function of accelerator cable (A) and cruise
control cable (B).
S6M0099B
:Does the accelerator cable throttle
cam move when the cruise control
throttle is moved by hand?
: Repair accelerator cable throttle cam.
Go to step3B23.
: Go to step3B23.
3B23 : CHECK THROTTLE CAM.
Check function of throttle cam.
:Does the throttle cam move
smoothly?
: Go to step3B24.
: Repair throttle cam. Go to step3B24.3B24 : CHECK CABLE FREE PLAY.
Ensure that throttle cam-to-lever clearance is
within specifications.
B6M0241A
:Is throttle cam-to-lever clearance
between 0 and 1 mm (0 and 0.04 in)?
: Go to step3B31.
: Adjust cable end by adjusting nuts. Go
to step3B31.
NOTE:
Ensure that cap is positioned in groove.
3. VACUUM HOSE
3B31 : CHECK VACUUM HOSE VISUALLY.
Check vacuum hose (A) (which connects actuator
(B) and intake manifold).
S6M0216B
:Is there disconnection or cracks in
vacuum hose?
: Replace vacuum hose. Go to step
3B41.
: Go to step3B41.
14
6-2[T3B2]DIAGNOSTICS
3. Cruise Control System

B: REMOVAL AND INSTALLATION
1. ACTUATOR
1) Disconnect ground cable from battery.
2) Remove air intake chamber.
S6M0007
3) Remove air intake chamber stay.
4) Remove clip bands from cruise control cable.
S6M0087
5) Remove cruise control cable end from throttle
cam.
S6M0088
6) Disconnect cruise control vacuum hose from
intake manifold.
S6M0089
7) Remove actuator attaching bolts.
8) Disconnect connector from actuator, then
remove the actuator.
S6M0090
9) Install in the reverse order of removal.
Tightening torque:
7.4
±2.0 N´m (0.75±0.2 kg-m, 5.4±1.4 ft-lb)
CAUTION:
When inserting vacuum hose to intake
manifold, apply sealant to the fitting hose.
Fluid packing:
THREE BOND 1105 or equivalent
CAUTION:
IBe careful not to apply excessive load to the
wire cable when adjusting and/or installing;
otherwise, the actuator may be deformed or
damaged.
IDo not bend cable sharply with a radius less
than 100 mm (3.94 in); otherwise, the cable may
bend permanently, resulting in poor perfor-
mance.
IWhen installing the cable, be careful not to
sharply bend or pinch the inner cable;
otherwise, the cable may break.
2. CRUISE CONTROL MAIN SWITCH
1) Disconnect ground cable from battery.
20
6-2[W12B1]SERVICE PROCEDURE
12. Cruise Control