SUBARU FORESTER 2001 SF / 1.G Owners Manual
Manufacturer: SUBARU, Model Year: 2001, Model line: FORESTER, Model: SUBARU FORESTER 2001 SF / 1.GPages: 357, PDF Size: 4.51 MB
Page 201 of 357

Starting and operating7-7
–
CONTINUED –
test simulates ac tual d riving c ond itions on a d ynam
ometer and p ermits
more ac c urate measurement of tailp ip e emitted p ollu tion than the b asic
emission test.
The U.S. Environmental Protec tion Ag enc y (EPA) and states using two-
wheel d ynamometers in their emission testing p rog ra ms have
EXEMPTED Sub aru AWD vehic les from the p ortion of the testin g p ro-
g ram that involves a two-wheel d ynamometer.
There are some states that use four-wheel d ynamomet ers in their testing
p rog rams. When p rop erly used , that eq uip ment will n ot d amag e an AWD
Sub aru vehic le.
Und er no c irc umstanc es should the rear wheels b e ja c ked off the
g round , nor should the d riveshaft b e d isc onnec ted f or state emission
testing .
Preparing to drive
You should p erform the following c hec ks and ad justm ents every d ay b e-
fore you start d riving .
1. Chec k that all wind ows, mirrors, and lig hts are c lean and unob -
struc ted .
2. Chec k the ap p earanc e and c ond ition of the tires. Also c hec k tires for
p rop er inflation.
3. Look und er the vehic le for any sig n of leaks.
4. Chec k that the hood , trunk and rear g ate are full y c losed .
5. Chec k the ad justment of the seat.
6. Chec k the ad justment of the insid e and outsid e mi rrors.
7. Fasten your seatb elt. Chec k that your p asseng ers have fastened their
seatb elts.
8. Chec k the op eration of the warning and ind ic ator lig hts when the ig ni-
tion switc h is turned to the “ON ” p osition.
9. Chec k the g aug es, ind ic ator and warning lig hts af ter starting the en-
g ine. NOTE Engine oil, engine coolant, brake fluid, washer fluid and other fluid
Page 202 of 357

7-8
levels should be checked daily, weekly or at fuel stops.
Starting the engine
CAUTION
Do not operate the starter motor continuously for more than ten
seconds. If the engine fails to start after operating the starter forfive to ten seconds, wait for ten seconds or more before tryingagain.
Starting the engine for a manual transmission vehicle
1. Ap p ly the p arking b rake.
2. Turn off unnec essary lig hts and ac c essories.
3. Press the c lutc h p ed al to the floor and shift the shift lever into neutral.
Hold the c lutc h p ed al to the floor while starting t he eng ine. The starter
motor will only op erate when the c lutc h p ed al is p r essed fully to the floor.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op eration
of the warning and ind ic ator lig hts. Refer to the “Warning and ind ic ator
lig ht ” sec tion (c hap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without d ep ressing
the ac c elerator p ed al. Release the key immed iately after the eng ine has
started .
If the eng ine d oes not start within ten sec ond s, wa it a while and then turn
the ig nition switc h to the “START ” p osition ag ain while d ep ressing the ac -
c elerator p ed al half way d own.
6. Confirm that all warning and ind ic ator lig hts hav e g one off after the
eng ine has started . The fuel injec tion system autom atic ally lowers the
id le sp eed as the eng ine warms up .