light SUBARU FORESTER 2001 SF / 1.G Owner's Manual

Instruments and controls3-19
–
CONTINUED –
When the lighting switch is in the
“p ” or “a ” position, you can adjust
brightness of the instrument panel illumination for better visibility.
To brighten, turn the control dial counterclockwise.
To darken, turn the control dial clockwise.
Parking light switch
HS0058
The parking light switch operates regardless of the ignition switch posi- tion.
By pushing the front end of this switch, following lights will come on. – Parking lights
– Front side marker lights
– Tail lights
– License plate lights
To turn off, push the rear end of the parking light switch.
Avoid leaving these lights on for a long time because that will run down
the battery.

3-20Fog light switch (if equipped)
The fog lights operate only when the headlights are on low beam.
Push the fog light switch to turn the fog lights on.
Press the switch again to turn them off.
HB2025BB
The indicator light located on the switch will illuminate when the fog
lights are on.
Wiper and washer
WARNING
In freezing weather, do not use the windshield washer until the
windshield is sufficiently warmed by the defroster.Otherwise the washer fluid can freeze on the windshield, blocking
your view.
CAUTION
Do not operate the washer continuously for more than ten se-
conds, or when the washer fluid tank is empty. This may cause
overheating of the washer motor. Check the washer fluid level fre-
quently, such as at fuel stops.

Instruments and controls3-25
–
CONTINUED –
Windshield wiper deicer (if equipped)
CAUTION
To prevent the battery from being discharged, do not operate the windshield wiper deicer continuously for any longer than neces-
sary.
The windshield wiper deicer operates only when the ignition switch is inthe “ON” position.
HB2027BB
Before turning on the windshield wiper deicer, remove any snow from the
windshield. To turn on the windshield wiper deicer, push the switch. The
indicator light located on the switch lights up while the windshield wiper
deicer is operating.
The windshield wiper deicer will automatically shut off after about 15 min-
utes. If the wiper blades have been deiced completely before that time,
push the switch to turn it off. It also turns off when the ignition switch is
turned to the “ACC” or “LOCK” position. If deicing is not complete when
you restart your vehicle, you have to push the switch to turn the deiceron again.

3-26Rear window defogger switch
CAUTION
Do not use sharp instruments or window cleaner containing
abrasives to clean the inner surface of the rear window. They may
damage the conductors printed on the window. To prevent the battery from being discharged, do not operate
the defogger continuously for any longer than necessary.
The rear window defogger operates only when the ignition switch is inthe “ON” position.
HS0063
Indicator light
To turn on the defogger, push the switch. To turn it off, push the switch again.
The indicator light located on the switch lights up while the rear windowdefogger is operating.
The defogger will automatically shut off after about 15 minutes. If the win-
dow clears before that time, push the switch to turn it off. It also turns off
when the ignition switch is turned to the “ACC” or “LOCK” position. If
defrosting or defogging is desired when you restart your vehicle, you
have to push the switch to turn it on again.
NOTE
If your vehicle is equipped with the outside mirror defogger, the out-
side mirror defogger operates while the rear window defogger is

3-28Horn
OM-H2736
To sound the horn, push the horn pad. Mirrors
Always check that the inside and outside mirrors are properly adjusted
before you start driving.
Inside mirror
HB4003BB
The inside mirror has a day and night position. Pull the tab at the bottom
of the mirror toward you for the night position. Push it away for the day
position. The night position reduces glare from headlights.

Instruments and controls3-29
–
CONTINUED –

Compass mirror (if equipped)
HB6019BB
The inside electronic compass mirror has an anti-glare feature which
automatically reduces glare coming from headlights of vehicles be-hind you. It also contains a built-in compass.By pressing and releasing the left button, the automatic dimming
function is toggled on or off. When the automatic dimming function is
on, the auto dimming indicator light (green) located to the right of the
button will illuminate. By pressing and releasing the right button, the compass display is
toggled on or off. When the compass is on, an illuminated compass
reading will appear in the lower part of the mirror.
Even with the mirror in anti-glare mode, the mirror surface turns bright
if the transmission is shifted into reverse. This is to ensure good rear-
ward visibility during reversing.

3-30n
Photosensors
HB6020BA
The mirror has a photosensor attached on both the front and back
sides. If the glare from the headlights of vehicles behind you strikes
the mirror, these sensors detect it and make the reflection surface of
the mirror dimmer to help prevent you from being blinded. For this
reason, use care not to cover the sensors with stickers, or other simi-
lar items. Periodically wipe the sensors clean using a piece of dry soft
cotton cloth or an applicator. nCompass calibration
1. For optimum calibration, switch off all nonessential electrical ac-
cessories (rear window defogger, heater/air conditioning system,
spotlight, etc.) and ensure all doors are shut.
2. Drive to an open, level area away from large metallic objects or
structures and make certain the ignition switch is in the “ON” position.
3. Press and hold the left button for 3 seconds then release, and thecompass will enter the calibration mode. “CAL” and direction will be
displayed.
4. Drive slowly in a circle until “CAL” disappears from the display
(about two or three circles).
5. The compass is now calibrated. Further calibration is not required.
The compass will automatically calibrate from this point forward.

Instruments and controls3-33
–
CONTINUED –

Outside mirror defogger (if equipped) CAUTION
To prevent the battery from being discharged, do not operate the
defogger continuously for any longer than necessary.
The outside mirror defogger shares the switch with rear window
defogger.
The outside mirror defogger operates only when the ignition switch is in the “ON” position.
HS0063
Indicator light
To turn on the outside mirror defogger, push the switch. To turn it off, push the switch again.
The indicator light located on the switch is on while the outside mirror
defogger is operation. The defogger will automatically shut off after
about 15 minutes. If the mirror clears before that time, push the switch
to turn it off. It also turns off when the ignition switch is turned to the “ACC” or “LOCK” position. If defrosting or defogging is desired when
you restart your vehicle, you have to push the switch to turn it onagain.
NOTE While the outside mirror defogger is operating, the rear window defogger also operates

Climate control4-11
–
CONTINUED –
2. Set the air outlet c ontrol d ial to the
“ ” p osition.
3. Push the air c ond itioner b utton to the “ON ” p osition.
4. Set the temp erature c ontrol d ial to the red area.
5. Set the fan sp eed c ontrol lever at the hig hest sp eed .
Operating tips for heater and air conditioner Cleaning ventilator grille
HS0083
Ventilator inlet grille
Always keep the front ventilator inlet g rille free of snow, leaves, or oth-
er ob struc tions to ensure effic ient heating and d ef rosting . Sinc e the
c ond enser is loc ated in front of the rad iator, this area should b e kep t
c lean b ec ause c ooling p erformanc e is imp aired b y an y ac c umulation
of insec ts and leaves on the c ond enser. Efficient cooling after parking in direct sunlight
After p arking in d irec t sunlig ht, d rive with the wi nd ows op en for a few
minutes to allow outsid e air to c irc ulate into the heated interior. This re-
sults in q uic ker c ooling b y the air c ond itioner. Ke ep the wind ows
c losed d uring the op eration of the air c ond itioner for maximum c ooling
effic ienc y. Lubrication oil circulation in the refrigerant circuit
Op erate the air c ond itioner c omp ressor at a low eng ine sp eed (at id le
or low d riving sp eed s) a few minutes eac h month d ur ing the off-sea-
son to c irc ulate its oil.

Audio5-9
–
CONTINUED –

Never expose cassettes to heat, direct sunlight or moisture.
Clean the tape head (once or twice a month) using a wet-type
cleaning cassette .
Cassette slot
Insert a cassette with the exposed tape side facing to the right. After
insertion, playback starts. TAPE button
Press the “TAPE button ”
9 when the cassette left in the cassette slot
is to be played back again. Tape travel indicators
These indicate the direction the cassette tape is moving. : Indicates that the top side of the cassette is being played back.
: Indicates that the bottom side of the cassette is being played
back. Program button (PROG)
When the program button Y is pressed during playback, the tape
travel indicators will switch and the player will begin playing back the opposite side of the tape. The same mechanism is automatically acti-
vated when the end of the tape is reached. This allows the opposite
side of the tape to play, providing continuous playback. Fast-forward button (FF)
To fast-forward the tape, press the “FF” button
E. To stop fast-for-
warding, lightly press the “
” 8 button.
Rewind button (REW)
To rewind the tape, press the “REW” button R. To stop rewinding,
lightly press the “
” 8 button.
Eject button (
)
When “
” button 8 is pressed, playback stops and the cassette
tape is ejected. The ejection function is also active when the ignition switch is in the
“LOCK” position. Always make certain that you remove the cassette
tape.