start stop button SUBARU IMPREZA 2015 4.G Smart Engine Start Guide

SUBARU — Smart Engine Start Page 3
OPERATION
SMART ENGINE START ENGINE STARTING PROCEDURE
To start a vehicle with Smart Engine Start, press and release the LOCK bu\
tton twice
within two seconds, then press and hold the LOCK button for three second\
s.
Engine starts successfully
A) Press and release the LOCK button.• The hazard lights flash once.
B) Press and release the LOCK button again. • The hazard lights flash again.
FOLLOWED IMMEDIATELY BY Step 3:
C) Press and hold the LOCK button. • The hazard lights flash 3 times [Car Finder]
• The horn sounds once [Car Finder]
• After three seconds, the horn sounds once.
D) Release the LOCK button.
• The parking lights and hazard lights flash once,
and the horn sounds once.
• The parking lights remain lit until the engine
stops.
Step 1
Step 2
Step 3
Engine running
WITHIN TWO SECONDS
THREE SECONDS
OR MORE

SUBARU — Smart Engine Start Page 5
OPERATION
SMART ENGINE START ENGINE STOPPING PROCEDURE
Press and hold the LOCK button on the remote for two or more seconds. The parking
lights turn off.


NOTES: • All doors will remain locked after the engine is shut off.
• The hazard lights flash once after the engine is shut off.
AUTOMATIC ENGINE SHUTDOWN
The engine will automatically shut down after a
pre-set amount of time.
To change this setting, please contact your local
SUBARU dealer. In some areas, the use of Smart
Engine Start may violate state, provincial, or local
laws. Check the laws in your area before using
Smart Engine Start.
Smart Engine Start will automatically shut down
or will not start the vehicle’s engine under the
following conditions:
20
If the total run-time has exceeded 20 minutes.
NOTE: The total run-time can be reset by
opening and closing one of the doors (including
the rear gate).
If any door or the rear gate is opened.