Low clutch piston SUBARU LEGACY 1999 Service User Guide

4) Install ST to low clutch drum.
ST 498437100 LOW CLUTCH PISTON
GUIDE
B3M1167A
5) Set the cover on the piston with a press using
ST1 and ST2, and attach the snap ring.
CAUTION:
Be careful not to fold cover seal during instal-
lation.
NOTE:
After installing snap ring, remove ST1, ST2 and
ST3.
ST1 498627100 SEAT
ST2 398673600 COMPRESSOR
ST3 498437100 LOW CLUTCH PISTON
GUIDE
B3M1168A
6) Install the dish plate, driven plates, drive plates,
and retaining plate, and secure with the snap ring.
NOTE:
Pay attention to the orientation of the dish plate.
B3M1169A
7) Check the low clutch for operation.
Set the one-way clutch inner race, and apply com-
pressed air for checking.
B3M0960A
8) Checking low clutch clearance
Measure the gap between the retaining plate and
the operation of the low clutch.
NOTE:
Before measuring clearance, place the same thick-
ness of shim on both sides to prevent retaining
plate from tilting.
If the clearance is out of the specified range, select
a proper retaining plate so that the standard clear-
ance can be obtained.
Standard value:
0.7 Ð 1.1 mm (0.028 Ð 0.043 in)
Allowable limit:
1.6 mm (0.063 in)
B3M0975A
Available retaining plates
Part No. Thickness mm (in)
31567AA830
31567AA840
31567AA850
31567AA860
31567AA8703.8 (0.150)
4.0 (0.157)
4.2 (0.165)
4.4 (0.173)
4.6 (0.181)
95
[W18C0]3-2SERVICE PROCEDURE
18. Low Clutch Drum and Planetary Gear