SUBARU LEGACY 2001 3.G Owners Manual

Climate control4-5
–
CONTINUED –
: Air flows throug h the foot outlets and some throug
h the wind -
shield d efroster outlets.
: Air flows throug h the wind shield d efroster outlets and foot
outlets.
: Air flows throug h the wind shield d efroster outlets .
n Air conditioner button (if equipped)
HB5010BB
The air c ond itioner op erates only when the eng ine i s running .
Push the air c ond itioner b utton while the fan is in op eration to turn on
the air c ond itioner. The ind ic ator lig ht will c ome on.
Push it ag ain to turn off the air c ond itioner. n Air inlet selection button
WARNING
Continued operation in the ON position may fog up the windows.
Switch to the OFF position as soon as the outside dusty condi-tion clears.

4-6
HB5008BB
ON position: Interior air is rec irc ulated insid e the vehic le. P ush the air
inlet selec tion b utton to the ON p osition. The ind i c ator lig ht will c ome
on. OFF position: Outsid e air is d rawn into the p asseng er c omp artmen t.
Push the air inlet selec tion b utton ag ain to the OF F p osition. The ind i-
c ator lig ht will g o off.
Heater operation Defrosting or defogging the windshield
HB5011AA
To d irec t warm air to the wind shield and front d oor wind ows:
1. Set the air inlet selec tion b utton to the “OFF ” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Turn the temp erature c ontrol d ial all the way to the rig ht.

Climate control4-7
–
CONTINUED –
4. Set the fan sp eed c ontrol d ial to the hig hest sp e
ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Heating and defrosting
HB5012AA
To d irec t warm air toward the floor and the wind shi eld :
1. Set the air inlet selec tion b utton to the “OFF ” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.

4-8
Heating
HB5013AA
To d irec t warm air toward the floor:
1. Set the air inlet selec tion b utton to the “OFF ” p osition
2 Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the most c omf ortab le level.
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
NOTE
Warm air also comes out from the right and left air outlets. To
stop warm air flow from these outlets, turn the correspondingthumb-wheel to the “
” position.
Bi-level heating
HB5014AA
This setting allows you to d irec t air of d ifferent temp eratures from the

Climate control4-9
–
CONTINUED –
instrument p anel and foot outlets. The air from the
foot outlets is
slig htly warmer than from the instrument p anel outl ets.
1. Set the air inlet selec tion b utton to the “OFF ” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial to the d esired t emp erature level.
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
Setting the temp erature c ontrol d ial fully turned t o the red area or b lue
area d ec reases the temp erature d ifferenc e b etween t he air from the
instrument p anel outlets and the air from the foot outlets.
Ventilation
WARNING
Continued operaton in the “ON” position may fog up the win-
dows. Switch to the “OFF” position as soon as the outside dusty
condition clears.
HB5015AA
To forc e outsid e air throug h the instrument p anel o utlets:
1. Set the air inlet selec tion b utton to the “OFF ” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the temp erature c ontrol d ial all the way left .
4. Set the fan sp eed c ontrol d ial to the d esired sp e ed .
When d riving on a d usty road , set the air inlet c on trol lever to the “ON ”
p osition.

4-10
Air conditioner operation Cooling or dehumidifying
HB5016BB
For c ooling and d ehumid ific ation of the p asseng er c omp artment, air
flows throug h the instrument p anel outlets:
1. Set the air inlet selec tion b utton to the “OFF ” p osition.
2. Set the air flow c ontrol d ial to the “
” p osition.
3. Set the air c ond itioner b utton to the “ON ” p osition.
4. Set the temp erature c ontrol d ial to the b lue area .
5. Set the fan sp eed c ontrol d ial at the hig hest sp e ed .
Defrosting or defogging
HB5011BB
To d irec t warm air to the wind shield and front d oor wind ows:
1. Set the air inlet selec tion b utton to the “OFF ” p osition.

Climate control4-11
–
CONTINUED –
2. Set the air outlet c ontrol d ial to the
“ ” p osition.
3. Set the air c ond itioner b utton to the “ON ” p osition.
4. Set the temp erature c ontrol d ial to the red area.
5. Set the fan sp eed c ontrol d ial at the hig hest sp e ed .
Automatic climate control system (if equipped) NOTE Operate the automatic climate control system when the engine is
running. When the engine coolant is cold, for instance in cold weather, the
air flows through the windshield defroster outlets and the blowerruns at the lowest speed to prevent cold air from blowing directly
against the driver and front passenger. In the “AUTO” mode, if the air temperature in the passenger
compartment is cooled down to the specified temperature, the air
conditioner compressor stops automatically. For efficient defogging
or dehumidifying in cold weather, press the “A/C” switch on.
Even when cooling is not necessary, setting the temperature
much lower than the current outlet air temperature turns on the airconditioner compressor automatically and the “A/C” indicator light
on the control panel comes on.
The automatic c limate c ontrol system automatic ally c ontrols outlet air
temp erature, fan sp eed , air flow d istrib ution air-i nlet c ontrol, and air c on-
d itioner c omp ressor op eration. It ac tivates when th e “AUTO ” switc h is
p ressed , and is used in c onjunc tion with the Temp er ature c ontrol d ial to
maintain a c onstant, c omfortab le c limate within the p asseng er c omp art-
ment.
The temp erature c an b e set within a rang e of 65 – 85 F (18 – 32 C).
NOTE
The temperature is shown in units of Fahrenheit for US model and in Centigrade for Canadian model.

4-12
Control panel
HB5017BC
1. AUTO switc h
2. OFF switc h
3. Outsid e air temp erature switc h
4. Defroster switc h
5. Rear wind ow d efog g er switc h (Refer to the “Rear wind ow d efog -
g er ” in c hap ter 3.)
6. Fan sp eed c ontrol switc h
7. Air c ond itioner switc h
8. Air flow c ontrol switc h
9. Air inlet selec tion switc h
10. Temp erature c ontrol d ial
11. In-vehic le temp erature sensor. n AUTO switch
AUTO mode operation:
The Automatic Climate Control system automatic ally c ontrols the air
temp erature of the p asseng er c omp artment in the AUT O mod e. When
the “AUTO ” switc h is p ressed , the ind ic ator lig ht “AUTO ” on the c on-
trol p anel c omes on. In this state, outlet air temp erature, fan sp eed , air
flow d istrib ution, air-inlet c ontrol, and air c ond i tioner c omp ressor op -
eration are automatic ally c ontrolled . ECON (economy) mode:
When you p ress the “AUTO ” switc h while the system is in the AUTO
mod e, it selec ts the ECON (ec onomy) mod e, turning o n the

Climate control4-13
–
CONTINUED –
“
ECON
” ind ic ator lig ht. In the ECON mod e, the c omp ressor runs to
b e thrifty with energ y c onsump tion. Interior wind ow s tend to fog in this
energ y-saving op eration. It is therefore rec ommend e d that the AUTO
mod e b e used only in hig h humid ity c ond itions. Manual mode operation:
When the Automatic Climate Control system is op erat ing in the AUTO
mod e, p ressing the “
”, “”, “MODE ”, “A/C ” or
“
” switc h shifts the op eration into the “MANUAL ” mod e and the
ind ic ator lig ht “AUTO ” on the c ontrol p anel will g o out.
When the “
”, “”, “MODE ”, “A/C ” or “”
switc h is p ressed , the c orresp ond ing func tion c an b e c ontrolled ind e-
p end ently, while automatic c ontrol of the other fun c tions are main-
tained .
To c hang e the system b ac k to the AUTO mod e, p ress t he “AUTO ”
switc h. n OFF switch
The Automatic Climate Control system turns off (the air c ond itioner
c omp ressor and fan turn off) when the “OFF ” switc h is p ressed .
When the “OFF ” switc h is p ressed , the outsid e air introd uc tion mo d e
( “
” p osition) is automatic ally selec ted .
NOTE Setting the light switch to the “p ” or “ a ” position causes the
illuminating icons on the display panel to dim. When traveling with the lights on in gloomy daylight or in twilight, press the OFFswitch for 1 second or longer if you feel it is too hard to identify
the icons clearly. The brightness comes back to normal. n OUT.TEMP switch
To c hec k the outsid e air temp erature, p ush the “OUT.TEMP ” switc h.
The outsid e air temp erature will b e d isp layed for f ive sec ond s, and
then the d isp lay automatic ally c hang es b ac k to the insid e air temp er-
ature.
The d isp lay c hang es over from the insid e air temp er ature to the out-
sid e air temp erature as its normal ind ic ation if yo u keep the switc h
p ressed for more than 2 sec ond s.

4-14NOTE
You can check the outside air temperature even when the Au-
tomatic Climate Control is off. (The ignition switch should be in the “ON” position.)
In the following cases, the display can indicate a higher tem-
perature than the actual outside air temperature: – In direct sunlight
– When the vehicle is parked for a long period of time with the
engine kept running.– During stop and go driving
n
— Defroster switch
To d efrost or d ehumid ify the wind shield and sid e wi nd ow, p ush the
d efroster switc h “
”. When the “” switc h is p ushed , re-
g ard less whether the air c ond itioner is op erating o r not, outsid e air is
d rawn into the p asseng er c omp artment, the air c ond i tioner c omp res-
sor turns on, air flow is d irec ted toward s the wind shield and sid e win-
d ows, and the ind ic ator lig ht “
” on the c ontrol p anel c omes on.
After eliminating the fog g ing from the wind shield , set the air c ond ition-
er b ac k in the AUTO mod e b y p ushing the “AUTO ” switc h or turn off
b y p ushing the “OFF ” switc h or “
” switc h.
n
— Fan speed control switch
HB5021BB
The fan sp eed c ontrol switc h has the 5 p ositions: A UTO p osition and
4 d ifferent fan sp eed p ositions.