instrument panel SUBARU LEGACY 2018 Quick Guide

Table of Contents
2-5 Getting Started

6-7 Instrument Panel

8-11 Gauges

12-13 Personalize

14-21 Controls

22-23 While Operating

24-25 Safety/In Case of Emergency

26-28 Additional Information
2926965_18a_Subaru_Legacy_QRG_050417.indd 55/4/17 3:12 PM

3
Seating
Getting
Started
10-Way Power Driver’s Seat (if equipped)
1. Forward/Backward,
Angle and Height

Move the switch toward the front
or rear to move the seat forward
or backward. Pull the switch up
or push down on the front of the
switch to adjust the angle of the
seat cushion. Pulling the switch
straight up or pushing the switch
straight down will adjust the height
of the entire seat cushion. 2. Seatback

Move the switch in the
corresponding direction to adjust
the angle of the seatback.
3. Lumbar Support
Press the front part of the switch
to increase lumbar support;
press the rear part of the switch
to decrease lumbar support.
3
2
1
Memory Driver’s Seat (if equipped)
While pressing the “SET” button, press and hold the desired button “1” or “2”.
A beep sounds when the seat position is registered. Press button “1” or “2” to
retrieve the seat positions.
2926965_18a_Subaru_Legacy_QRG_050417.indd 35/4/17 3:12 PM
Getting
StartedInstrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

5
Rear Seat Release Lever
Open the trunk lid. Pull the release lever on the seat side that you want to fold down.
To return the seatback to its original position, raise the seatback until it loc\
ks into
place, making sure that it is securely locked.
Getting
Started
Rear Seat Heater (if equipped)
Press the rear seat heater switch. Each time
you press the switch, the mode will change
as follows: High, Low, Off.
2926965_18a_Subaru_Legacy_QRG_050417.indd 55/4/17 3:12 PM
Getting
StartedInstrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

6
Instrument Panel
8-1121
20 1314, 19PAGE
NUMBER
2926965_18a_Subaru_Legacy_QRG_050417.indd 65/4/17 3:13 PM

7
Instrument Panel
Instrument
Panel
16-17
23
2926965_18a_Subaru_Legacy_QRG_050417.indd 75/4/17 3:13 PM
Getting
StartedInstrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

9
Gauges
Speedometer
Fuel gauge
Vehicle Dynamics Control/
Vehicle Dynamics Control
operation
Vehicle Dynamics Control OFF
CHECK ENGINE/
Malfunction indicator
Tire pressure warning light
Front passenger airbag ON
(Located on overhead
console)
Front passenger airbag OFF (Located on overhead
console)
Low windshield washer fluid
Hill Holder
Turn signals
Front fog light indicator
light (if equipped)
Headlight indicator light
Cruise control
indicator light
Cruise control SET
indicator light
2926965_18a_Subaru_Legacy_QRG_050417.indd 95/4/17 3:13 PM
Getting
StartedInstrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

11
Gauges
SpeedometerFuel gauge
Vehicle Dynamics Control/
Vehicle Dynamics Control
operation
Vehicle Dynamics Control OFF
CHECK ENGINE/
Malfunction indicator
Tire pressure warning light
Front passenger airbag ON
(Located on overhead
console)
Front passenger airbag OFF (Located on overhead
console)
Low windshield washer fluid
Hill Holder
Turn signals
Front fog light indicator
light (if equipped)
Headlight indicator light
Cruise control
indicator light
Cruise control SET
indicator light
2926965_18a_Subaru_Legacy_QRG_050417.indd 115/4/17 3:13 PM
Getting
StartedInstrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

13
Personalize
Power Exterior Mirrors
Turn the knob to the “L” side to adjust the left-hand mirror or to the “R” side to adjust
the right-hand mirror. Move the knob in the direction you want to move the mirror.
Then return the knob to the neutral/center position.
Combination Meter Display Controls (if equipped)
Use the i/SET controls to display and switch selected items in the Combination Meter
Display located between the tachometer and odometer. Please refer to your Owner’s
Manual for details on these controls.
2926965_18a_Subaru_Legacy_QRG_050417.indd 135/4/17 3:13 PM
Getting
StartedInstrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information

14
While the light switch is on, rotate the dial downward to dim the instrument panel illumination.
Rotate the dial upward to make the illumination brighter. When the dial is fully rotated upward,
the instrument panel illumination becomes full bright.
Controls
Light Controls
Push up for
right turn signal.
Push down for
left turn signal.
Push forward to change from low
beam to high beam. Pull the lever
back to center to return to low beam. Turns on instrument panel
lights, tail lights, parking lights
and license plate lights.
Turns on headlights, instrument
panel illumination, parking lights,
tail lights and license plate lights.
Turns on
fog lights
(if equipped).
AUTO (if equipped): The vehicle’s lights
are automatically on or off, depending
on the level of outside light.
2926965_18a_Subaru_Legacy_QRG_050417.indd 145/4/17 3:13 PM

15
Windshield Wipers
To turn on the wipers, press the wiper control lever down one level for intermittent,
two levels for low, or three levels for high speed. Return the lever to the “OFF”
position to stop the wipers. For a single wipe, move the lever up. To spray washer
fluid, pull and hold the lever toward you.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only a reduced brightness
high beam will be automatically turned on when the engine has started, the parking
brake is fully released and the light switch is in the “OFF” or “
” position. The
brightness of the illumination of the high beam headlights is reduced by the daytime
running light system. You must always switch on your headlights when it is dark
outside by turning the light switch to the “
” position.
1
2
3
INT.
LOW
HIGH OFF
Controls
2926965_18a_Subaru_Legacy_QRG_050417.indd 155/4/17 3:13 PM
Getting
StartedInstrument
Panel Gauges
Personalize ControlsWhile
Operating Safety/In Case
of Emergency Additional
Information