belt SUBARU OUTBACK 2004 4.G Repair Manual
[x] Cancel search | Manufacturer: SUBARU, Model Year: 2004, Model line: OUTBACK, Model: SUBARU OUTBACK 2004 4.GPages: 525, PDF Size: 5.68 MB
Page 77 of 525

1-52
Seat, seatbelt and SRS airbags
3. [If your child restraint system is of a flexible attach-
ment type (which uses tether belts to connect the child
restraint system properly to the lower anchorages)]
While pushing the child restraint into the seat cushion,
pull both left and right lower tether belts up to secure
the child restraint system firmly by taking up the slack
in the belt.
4. Connect the top tether hook to the tether anchor-
age and firmly tighten the tether.
For information on how to set the top tether, read the
following “Top tether anchorages”.
5. Before seating a child in the child restraint system,
try to move seat back and forth and left and right to
verify that it is held securely in position.
6. To remove the child restraint system, follow the re-
verse procedures of installation.
If you have any question concerning this type of child
restraint system, ask your SUBARU dealer. „
Top tether anchorages
Your vehicle is equipped with three top tether anchor-
ages so that a child restraint system having a top teth-
er can be installed in the rear seat. When installing a
child restraint system using top tether, proceed as fol-
UG1098BAUS1113BA
Page 78 of 525

1-53
Seat, seatbelt and SRS airbags
– CONTINUED –
lows, while observing the instructions by the child re-
straint system manufacturer.
Since a top tether can provide additional stability by of-
fering another connection between a child restraint
system and the vehicle, we recommend that you use
a top tether whenever one is required or available. T
Anchorage location
Sedan
A) Center anchorage
B) Left (right) anchorage
TOP TETHER
A B
UB1159BB
Page 79 of 525

1-54
Seat, seatbelt and SRS airbags
Station wagon
A) Center anchorage
B) Left (right) anchorage
Three anchorages, i.e., ones for the right, center and
left positions, are already installed on the rear shelf (on Sedan) or on the rear edge of the roof (on Station
wagon). T
To hook the top tether
V Sedan
1. Remove the headrest at the seating position where
the child seat has been installed with the seatbelt or
lower anchorages; lift up the headrest while pressing
the release button.
Store the headrest in the cargo area. Avoid placing the
headrest in the passenger compartment to prevent it
from being thrown around in the passenger compart-
ment in a sudden stop or a sharp turn.
TOP TETHER
A B
UB1160BB
UBS063BA
Page 80 of 525

1-55
Seat, seatbelt and SRS airbags
– CONTINUED –
2. Fasten the top tether hook of the child restraint sys-
tem to the appropriate upper anchorage. 3. Tighten the top tether securely.
Do not route the top tether over the headrest. It
may happen that the top tether cannot be fas-
tened tightly.
When the child restraint system is to be se-
cured using the top tether, pass the top tether
under the headrest between the headrest stay
posts. If the top tether still cannot be fastened
tightly, remove the headrest.
UG1087BAUB1163BA