Daytime Running Lights
The daytime running lights automatically turn on when the engine has started, the parking
brake is fully released, the light switch is in the Off, “AUTO” (if equipped) or “
”
position, and the select lever is not in the “P” position. Always turn on the headlights when
it’s dark outside by rotating the dial to the “
” or “AUTO” position.
TURN SIGNALS
Push slightly up for right lane change or fully
up for right turn signal. Push slightly down for
left lane change or fully down for left turn
signal.
WINDSHIELD WIPERS
To turn on the wipers, press the wiper control
lever down one position for intermittent, two
positions for low speed, or three positions for
high speed. To turn the wipers off, return the
lever to the “OFF” position. For a single wipe,
move the lever up one position.
When the lever is in the intermittent position,
rotate the dial to adjust the operating interval
of the wipers.
Pull the lever toward you to spray washer fluid.
The washer will spray until you release the lever, then wipe twice.
CONTROLS
26
REAR WINDOW WIPER
Rotate the end of the lever up one position for
intermittent, or two positions for continuous
wipe.
When the lever in is the intermittent position,
the wiper operates at intervals corresponding
with vehicle speed. When you move the select
lever to the “R” position, the wiper will switch
to continuous operation. It will return to
intermittent when you move the select lever
out of “R”.
Rotate the dial up from the continuous wipe position or down from the ON position to
spray washer fluid. The washer will spray until you release the dial, then return to the
previous position and resume continue operation.
INSTRUMENT PANEL SWITCHES(LOWER LEFT)
The instrument panel contains these switches:
1 Power rear gate release switch (p. 42)
2 Illumination Brightness (p. 25)
3
Hands-free power rear gate off switch (p.6)
CONTROLS
27
