open gas tank SUZUKI ALTO 2012 7.G CNG Manual
[x] Cancel search | Manufacturer: SUZUKI, Model Year: 2012, Model line: ALTO, Model: SUZUKI ALTO 2012 7.GPages: 14, PDF Size: 1.62 MB
Page 7 of 14
6
FOR VEHICLES FITTED WITH CNG FUEL SYSTEM
68PH0-74E
MANUAL SHUT-OFF VALVE
53MHMC010
Manual shut-off valve (2) is located on the
left hand side of the CNG cylinder.
MANUAL SHUT-OFF VALVE
OPERATION
53MHMC011
CNG supply can be switched off by closing
the manual shut-off valve.
Valve closing: Turn the knob completely
in clockwise direction to close the CNG
supply to Engine.
Valve opening: Turn the knob completely
in anti-clockwise direction to open the
CNG supply to Engine.
NOTE:
• If the manual shut-off valve is not
opened fully, then the engine may not
run properly.
• If the manual shut-off valve is in closed
condition, it is not possible to fill CNG
into the cylinder.
NOTE:
• As per Government regulation, CNG cyl- inder needs to be checked and certified
every three (3) years from the date of ini-
tial testing as mentioned on the CNG
cylinder identification plate.
• Customer has to present the vehicle to a government approved testing agency.
• Failure to test the cylinder may result in
denying of CNG filling by the CNG dis-
pensing stations or may result in confis-
cating the vehicle by enforcement
authorities.
• All the expenses for CNG cylinder test- ing has to be borne by the customer.
• As per Government regulation, CNG cyl- inder has to be discarded at 20 years
from the date of in itial testing as men- tioned in the CNG cylinder identification
plate.
• Customer has to discard the cylinder at his / her expense through government
approved scrap agencies.
• No person shall refill any cylinder, which has been repaired under sub-rule (2)
with any gas unless a full report on the
repairs and test carried out on the cylin-
der, accompanied by the repairer's certif-
icate of testing are furnished to the Chief
Controller and his permission is obtained
for its refilling.
OPENOMBCN G
onl yCLOSE(2)
12Open
Close
WA R N I N G
• Never remove the cylinder valve
from the cylinder assembly. For
any assistance consult Maruti
Suzuki authorized workshop.
• Never try to clean the cylinder. In case of any problem, contact
Maruti Suzuki au thorized work-
shop.
• Do not reuse the cylinder valve,
once it is replaced / removed from
cylinder assembly.
•Even if the CNG from the cylinder
is consumed till engine stops,
some amount of CNG will be left
out in the tank under pressure.