recommended oil SUZUKI ALTO 2013 7.G Owners Manual

7-17
INSPECTION AND MAINTENANCE
53MH0-74E
Gear Oil Change
Since special procedures, materials and
tools are required, it is recommended that
you trust this job to your authorized
MARUTI SUZUKI dealer.
Clutch Pedal
Cable control clutch
(For Manual Transaxle Model)
54G274
Clutch pedal play “d”:
10 - 15 mm (0.4 - 0.6 in.)
Measure the clutch pedal play by moving
the clutch pedal with your hand and mea-
suring the distance it moves until you feel
slight resistance. The play in the clutch
pedal should be between the specified val-
ues. If the play is more or less than the
above, or clutch dragging is felt with the
pedal fully depressed, have the clutch
inspected by your MARUTI SUZUKI
dealer.
Fuel Filter
The fuel filter is located on the way of the
fuel hose line under the vehicle body.
53MM07011
(1) Fuel filter
(2) Fuel inlet hose
(3) Fuel outlet hose
Replace the Fuel Filter
Since special procedures are required, we
recommend you take your vehicle to your
MARUTI SUZUKI dealer for fuel filter
replacement.
CAUTION
After driving the vehicle, the
transaxle oil temperature may be
high enough to burn your skin. Wait
until the oil filler plug is cool enough
to touch with your bare hands before
inspecting transaxle oil.
NOTICE
When tightening the plug, apply the
following sealing compound or
equivalent to the plug threads to pre-
vent oil leakage.
Manual transaxle sealant:
MARUTI SUZUKI Bond No. “1216E”
or “1217G”
EXAMPLE
(1)
(3)
(2)
EXAMPLE

9-4
APPEARANCE CARE
53MH0-74E
3) Wash the entire exterior with a mild
detergent or car wash soap using a
sponge or soft cloth. The sponge or
cloth should be frequently soaked in the
soap solution.
4) Once the dirt has been completely
removed, rinse off the detergent with
running water.
5) After rinsing, wipe off the vehicle body
with a wet chamois or cloth and allow it
to dry in the shade.
6) Check carefully for damage to painted
surfaces. If there is any damage,
“touch-up” the damage following the
procedure below:
1. Clean all damaged spots and allow
them to dry.
2. Stir the paint and “touch-up” the
damaged spots lightly using a small
brush.
3. Allow the paint to dry completely.
Waxing
60B211S
After washing the vehicle, waxing and pol-
ishing are recommended to further protect
and beautify the paint.
Only use waxes and polishes of good
quality.
When using waxes and polishes,
observe the precautions specified by the
manufacturers.
NOTICE
When using a commercial car wash
product, observe the cautions speci-
fied by the manufacturer. Never use
strong household detergents or
soaps.
NOTICE
If you use an automatic car wash,
make sure that your vehicle’s body
parts, such as spoilers, cannot be
damaged. If you are in doubt, consult
the car wash operator for advice.
EXAMPLE