tire type SUZUKI BALENO 1999 1.G Owners Manual

60G-74E

BEFORE DRIVING

Pregnant women should use seat

belts, although specific recommen-

dations about restraint use should

be made by the woman's medical

advisor.

Periodically inspect seat belt

assemblies for excessive wear and

damage. Seat belts should be replaced

if webbing becomes frayed,

contaminated, or damaged in any way.

It is essential to replace the entire seat

belt assembly after it has been

stressed in an impact, even if damage

to the assembly is not obvious.

Infants and small children should never

be transported unless they are properly

restrained. Restraint systems for

infants and small children can be

purchased locally and should be used.

Make sure that the system you

purchase meets applicable safety

standards. Read and follow all the

directions provided by the

manufacturer.
Avoid contamination of seat belt

webbing by polishes, oils, chemicals,

and particularly battery acid. Cleaning

may safely be carried out using mild

soap and water.

For children, if the shoulder belt

irritates the neck or face, move the child

closer to the center of the vehicle.

A WARNING

Be sure to inspect all seat belt

assemblies after any collision. Any seat

belt assembly which was in use during

a collision (other than a very minor one)

should be replaced, even if damage to

the assembly is not obvious. Any seat

belt assembly which was not in use

during a collision should be replaced

if it does not function properly or is

damaged in any way.
70F-01-021

There are two types of seat belt, "Lap-shoulder

belt" and "Lap belt".

To fasten the seat belt, sit up straight and well

back in the seat, pull the buckle tongue

attached to the seat belt across your body and

slide it into the buckle catch on the opposite

side until you hear a "click".

25

3-12

BEFORE DRIVING
60G-74E

70F-01-022E

To reduce the risk of sliding under the belt

during a collision, position the lap portion of

the belt across your lap as low on your hips

as possible and adjust the belt to a snug fit

using the proper method for each type of the

belt as described below. Make sure that the

belt is not twisted.
70F-01-023E

To unfasten the belt, press the release button

on the buckle catch.
70F-01-024E

To Adjust the Belt

• Lap-shoulder belt

Pull the shoulder portion of the belt

upwards through the tongue plate.

The length of the diagonal shoulder strap

adjusts itself to allow freedom of movement.

The seat belt has an emergency locking

retractor (ELR), which is designed to lock the

seat belt only during a sudden stop or impact.

3-13
26