warning SUZUKI GRAND VITARA 2008 3.G Operating Manual

Downloaded from www.Manualslib.com manuals search engine A WARNING
• The ESP® may not work properly if tires or wheels other than those specified in the Owner's Manual are
used. When replacing tires or wheels, use only the size and type
specified in this Owner's Manual. • The ESP® may not work properly if
tires are not inflated to the recom­mended tire inflation pressure. • The ESP® may not work properly if tires are fitted with tire chains. • The ESP® may not work properly if the tires are excessively worn. Be sure to replace tires when the tread
wear indicators in the grooves
appear
on the tread surface. • The ESP® is not a substitute for winter tires or tire chains on a snow covered road.
A WARNING
• The ESP® may not work properly if engine related parts such as 'the
muffler are not equivalent to stan­dard equipment or are extremely
deteriorated.
• Do not modify the vehicle's sus­pension since the ESP® may not
operate correctly.
The ESP® indicator lights are described below:
SLIP Indicator Light
79K019
The SLIP indicator light in the instrument cluster blinks 5 times per second when one
of the following systems is activated. • Stability control system ' • Traction control system • Hill descent control system (if equipped)
CAUTION
If the SLIP indicator light comes on and stays on while driving, there may
be a malfunction of the ESP® sys­tems (other than ABS). You should
have the systems inspected by an
authorized
SUZUKI dealer.
NOTE: When the SLIP indicator light comes on and stays on while driving, indicating a malfunction of the ES~ systems (other
than ABS), the brake system will function
as an ordinary ABS with no additional ES~ functions.
OPERATING YOUR VEHICLE
NOTE: When you disconnect and re-connect the
battery, ES~ system functions other than ABS will be deactivated and the slip indica­tor light will blink 1 time per second. In this
case, use the following procedure to re­activate the ES~ systems: 1) Drive your vehicle straight ahead with­out tire slippage at a speed greater than
approximately 15 kmlh (9 mph) for a few seconds
2) The slip indicator light will go out and
the ESf/8J systems (other than ABS) will
be re-activated
It may take more than few seconds before
the slip indicator light goes out depending
on the road. surface condition.
3-34

Downloaded from www.Manualslib.com manuals search engine OPERATING YOUR VEHICLE
"ESP" Warning Light
ESP
66J031
When the ESP® systems (other than ABS) have a system malfunction, the "ESP" warning light in the instrument cluster comes on.
CAUTION
If the "ESP" warning light comes on,
or stays on while driving, there may
be a malfunction of the ESP® sys­tems (other than ABS). You should
have the systems inspected by an authorized SUZUKI dealer.
NOTE: When the "ESP" warning light comes on, or stays on while driving, indicating a mal­function of the ESp!Y systems (other than ABS), the brake system will function as an
ordinary ABS that has no additional ESp!Y functions.
NOTE: The information display shows the warning and indicator message when this light
comes on.
3-35
"ESP OFF" Indicator Light
ESP
OFF
66J032
You should turn the ESP® on during your
ordinary driving, so that you have the ben­efits of all of the ESP® systems.
It may be required to turn the ESP® sys­tems (other than ABS) off if your vehicle is stuck in sand, mud, or snow, or when driv­ing in extreme off-road conditions where wheel spin is necessary.
"ESP OFF" switch
(without hill descent control)
(1)
78K045
(with hill descent control)
'"'---+-( 1 )
78K046
(1) "ESP OFF" switch
When the
"ESP OFF" switch located at the
center of the instrument panel is pushed
and held
to turn off the ESP® systems
(other than ABS), the "ESP OFF" indicator
light in the instrument cluster comes on. When you push and hold the "ESP OFF" switch again, the "ESP OFF" indicator light will go out and all of the ESP® systems will be activated.
NOTE: • When the vehicle speed is greater than
approximately 30 kmlh (19 mph), the ESp!Y systems (other than ABS) will turn on automatically and the "ESP OFP' indicator light will go out. • When the transfer switch (if equipped) is turned to the "4L LOCK" position, the

Downloaded from www.Manualslib.com manuals search engine ES~ systems (other than ABS) will be
canceled to provide improved vehicle
traction, and the
~'ESP OFF" indicator
light will come on. When the transfer switch (if equipped) is
turned to the "4L LOCK" position, brake­
traction control can be activated. Brake­
traction control brakes the spinning
wheel to distribute drive power to the other wheels for increased climbing abil­
ity or for better performance on a rolling
hill or a slipe,ery surface .. • If the ESpE> systems operate continu­ously, such as when driving on slippery roads, the traction control functions of the ES~ systems may be canceled
temporarily to avoid overheating the brake pads, and the "ESP OFF" indicator
light will come on. After a short period of time, the ES~ systems (other than ABS) will turn on automatically and the "ESP OFF" indicator light will go out. • If your vehicle is equipped with a hill
descent control system and a hill hold
control system, these systems will not be
turned off
when the "ESP OFF" switch is pushed to turn off the ES~ systems.
E'::.F' OFF I-Qf - -a.'ND S\l',/IT'_ H V"/I)R~;',. I-6-t ONL ',' IN 4HL
79K084
NOTE: If, you push the "ESP OFF" switch when the transfer switch is in the "4H" position, the ES~ systems will not be turned off, and the message shown in the above illus­
tration will appear on the information dis­play. You should turn the transfer switch to the "4H LOCK" position to turn off the ES~ systems. Refer to "Using the Transfer Switch" in this section.
ABS Warning Light I Brake System
Warning Light
See 'Braking" in the "OPERATING YOUR VEHICLE" section.
OPERATING YOUR VEHICLE
Hill descent control System
(if equipped)
The hill descent control system is designed
to reduce the driver's workload when going
down steep, rough and/or slippery hills where the vehicle cannot decelerate enough by engine braking alone. The hill descent control system helps to control
vehicle speed by automatically engaging
the vehicle's brakes, as needed, so you can concentrate on steering the vehicle.
A WARNING
Do not rely excessively on the hill
descent control system. The hill
descent control system may not con­trol vehicle speed on a hill under all load or road conditions. Always be prepared to control vehicle speed by applying the brakes. Failure to pay
attention and control vehicle speed
using the brakes when necessary
may
result in loss' of control or an accident.
3-36

Downloaded from www.Manualslib.com manuals search engine NOTE: If the hill descent control indicator does not come on when you push the hill descent
control switch, there may be a problem
with the hill descent control system and/or
the
ES~ system. Have your vehicle
inspected by an authorized SUZUKI dealer.
ESP HILL HOLD DI':: .. il.BLED
79K072
If the message shown in the above illustra­tion appears on the information display, there may be a problem with the hill descent control system and the hill hold
control system. Have your vehicle inspected by an authorized SUZUKI
dealer.
NOTE: You cannot activate the hill descent control
system while this message is displayed.
---------
Hill hold control System
(if equipped)
The hill hold control system is designed to
assist you in starting to move up steep or slippery hills. When you start to move up a hill, the system helps to prevent the vehicle from rolling downward while you move your
foot from the brake pedal to the accelerator
pedal.
A. WARNING
• Do not rely excessively on the hill hold control system. The hill hold control system may not prevent the vehicle from rolling downward on a hill under all load or road condi­tions. Always be prepared to depress the brake pedal to prevent
the vehicle from rolling downward. Failure to pay attention and
depress the brake pedal to hold the vehicle on a hill when necessary,
may result in loss of control or an
accident.
• Do not use the hill hold control sys­tem to bring the vehicle to a stop on a hill.
The hill hold control system activates for a
maximum of about 2 seconds if your foot is moved from the brake pedal when the fol­
lowing condition are all met. 1) The transfer switch is in a position other
than "N".
OPERATING YOUR VEHICLE
2) The gearshift lever is in a forward gear
or reverse gear.
3) The parking brake is released.
NOTE: You may hear a sound coming from the
engine when the hill hold control system is
activated. This sound is normal
and does not indicate a malfunction.
ESP HILL HOLD [II= .. il.BLED
79K072
If the message shown in the above illustra­tion appears on the information display, there may be a problem with the hill descent control system and the hill hold
control system. Have your vehicle inspected by an authorized SUZUKI
dealer.
NOTE: The hill hold control system will not acti­
vate while this message is displayed.
3-38