jacking point SUZUKI IGNIS 2020 Owners Manual

8-2
EMERGENCY SERVICE
75RM4-01E
3) Turn on the hazard warning flasher ifyour vehicle is near traffic.
4) Block the front and rear of the wheel
diagonally opposite of the wheel being
lifted.
5) Place the spare wheel near the wheel
being lifted as shown in the illustration
in case the jack slips.
54G253 75RM077
75RM078
6) Position the jack at an angle as shown
in the illustration and raise the jack by
turning the jack handle clockwise until
the jack-head groove fits around the
jacking bar beneath the vehicle body.
7) Continue to raise the jack slowly and
smoothly until the tire clears the
ground. Do not raise the vehicle more
than necessary.
WA R N I N G
• Use the jack only to change wheelson level, hard ground.
• Never jack up the vehicle on an inclined surface.
• Never raise the vehicle with the jack in a location other than the
specified jacking point (shown in
the illustration) near the wheel to
be changed.
• Check that the jack is raised at
least 25 mm (1 inch) before it con-
tacts the flange. Use of the jack
when it is within 25 mm (1 inch) of
being fully collapsed may result in
failure of the jack.
• Never get under the vehicle when it
is supported by the jack.
• Never run the engine when the vehicle is supported by the jack
and never allow passengers to
remain in the vehicle.

8-3EMERGENCY SERVICE
75RM4-01E
Raising vehicle with garage jack• Apply the garage jack to one of thepoints indicated below.
• Always support the raised vehicle with jack stands (commercially available) at
the points indicated below.
75RM360
(1) Front
(2) Jack stand
(3) Garage jack (4) Rear
(5) Rear (4WD)
(6) Rear (2WD) (7) Jacking point for garage jack
(4)
(1)(1)(2)
(2)
(7)
(1)
(3)
(3)
(3)
(5)
(6)
(7) (7)