AIR CO SUZUKI JIMNY 2020 User Guide

FOR SAFE DRIVING
A. WARNING
If you need to carry cargo in the pas­senger compartment with the rear seatback folded forward, secure the cargo or it may be thrown about, causing injury. Never pile cargo higher than the seatbacks.
To return the seat to the normal position,
follow the procedure below.
NOTICE
When returning the rear seatback to the normal position, check that there is nothing around the striker. Any for­eign materials prevent the seatback from being locked securely.
1-7
78RB02013
Raise the seatback until it locks into place.
After returning the seat, move the seat­back back and forth to check if it is securely latched.
NOTICE
When returning the rear seatback to the normal position, handle it care­fully by hand to avoid any damage to the lock itself. Do not push it by using some material or by applying exces­
sive force.
Seat belts and child restraint
systems
650231S
A. WARNING
An airbag supplements or adds to the frontal collision protection offered by seat belts. The driver and all passen­gers must be properly restrained by fastening seat belts at all times, whether or not an airbag is mounted at their seating position, to minimize the risk of severe injury or death in the event of a collision.

FOR SAFE DRIVING
Seat belt hanger
NOTICE
When you move a seatback, make sure the belt webbing is hooked in the seat belt hangers so the seat belts are not caught by the seatback, seat hinge, or seat latch. This helps prevent damage to the belt system.
1-17
Seat belt inspection
65D209S
Periodically check if the seat belts work properly and are not damaged. Check the webbing, buckles, latch plates, retractors, anchorages and guide loops. Replace any seat belts which do not work properly ·or
are damaged.
A WARNING
Inspect all seat belt assemblies after any collision. Any seat belt assembly which was in use during a collision (other than a very minor one) should be replaced, even if damage to the assembly is not obvious. Any seat belt assembly which was not in use during a collision must be replaced if the airbags and the seat belt preten­sioners activated. The airbags, the pretensioners and the load limitter will only function once. In case they did not activate, consult with Suzuki dealer.

FOR SAFE DRIVING
58MS030
A WARNING
(Vehicle without the front passenger airbag deactivation system) Do not install a rear-facing child restraint in the front passenger's seat. If the passenger's front airbag inflates, a child in a rear-facing child restraint could be killed or severely injured. The back of a rear-facing child restraint would be too close to the inflating airbag.
1-19
A WARNING
(Vehicle with the front passenger air­bag deactivation system) When using a child restraint system on the front passenger's seat, the front passenger's airbag system must be deactivated; otherwise deployment of the front passenger's airbag could result in the death or serious injury of the child.
A WARNING
If you install a child restraint system in the rear seat, slide the front seat far enough forward so that the child's feet do not touch the front seatback. This will help avoid injury to the child in the event of an accident.
65D609
A WARNING
Children could be endangered in a collision if their child restraint sys­tems are not properly secured in the vehicle. When installing a child restraint system, follow the instruc­tions below. Secure the child in the restraint system according to the manufacturer's instructions.

Child restraint system for
countries applied for UN
Regulation No.16
.A. CAUTION
Adjust the height of the head restraint or remove it for fitting the child restraint, as necessary. How­ever, if a booster cushion not equipped with the head restraint is fitted, the head restraint should not be removed. If the head restraint is removed for fitting the child restraint, you need to install it again after removing the child restraint. If the child restraint is fitted improp­erly, a child sitting in it could be injured in a collision. (Refer to "Installation with lap-shoulder seat belts" section, 11lnstallation with ISO­FIX type anchorages" section and "Installation of child restraint with top tether11 section in this section for details.)
Child restraint
The suitability of each passenger's seat position for carriage of children and fitting of child restraint system is shown in the table.
Child restraint systems suitability for each seat position (for the vehicle with airbag deactivation switch)
The above illustration shows Left hand drive vehicle.
NOTE: Seat position number of G), @ and @ is same as Left hand drive vehicle for Right hand drive vehicle.
G) Front passenger's seat @ Rear seat right side @ Rear seat left side
G) (ID@ (#1. #2. #3)
(2) (ID~J,~ (#2, #3)
® (ID~J,~ (#2. #3)
FOR SAFE DRIVING
It is suitable for univer­sal category of child restraint system fixed with the vehicle seat belt.
It is suitable for i-Size and ISOFIX child restraint system.
This seat is equipped with Top tether anchor­age point.
Never use a rear-fac­ing child restraint sys­tem on the passenger seat when the front passenger airbag is activated.
#1: Move the front seat fully rearward. #2: When you install a forward-facing child restraint, if there is a gap or space between the child restraint and the seatback, adjust the seat­back angle in order to install the child restraint system properly. #3: If the head restraint interferes with the child restratint system, adjust the height of the head restraint or remove it, as necessary.
NOTE: For the Installation suitability of child restraint systems of Taiwan models, refer to "For Taiwan" in the "SUPPLE­MENT" section.
1-20

FOR SAFE DRIVING
Detailed information for child restraint system (for the vehicle with airbag deactivation switch)
Seating position
Seat position number
Seating position suitable for universal belted (YES/NO)
i-Size seating position (YES/NO)
Seating position suitable for lateral fixture (L 1/L2)
Suitable rear-facing fixture (R1/R2/R3)
Suitable front-facing fixture (F2X/F2/F3)
Key of letters to be inserted in the above table YES =Suitable for this seating position NO = Not suitable for this seating position
Front Passenger airbag is activated
NO
NO
NO
NO
NO
X =ISOFIX position is not suitable for ISOFIX child restraint systems in this fixture.
G)
ISOFIX child restraint systems are divided into different mass group, size class and fixture.
Front Passenger airbag is deactivated
YES
NO
NO
NO
NO
The child restraint system can be used in the seating positions for fixture shown in the above table. For mass group, size class and fixture, confirm the table of next page.
NOTE:
(2)
YES
YES
X
R1, R2
F2X, F2, F3
@
YES
YES·
X
R1, R2
F2X, F2, F3
For the Installation suitability of child restraint systems of Taiwan models, refer to "For Taiwan" in the "SUPPLEMENT' section.
1-21

FOR SAFE DRIVING
Installation suitability of SUZUKI recommendation child restraint systems (for the vehicle with airbag deactivation switch)
Recommendation of Mass group Child restraint system (#A)
0,0+ Britax Romer Baby-Safe i-Size (up to 13kg)
I Britax Romer Duo Plus (9kg to 18kg)
11, Ill Britax Romer Kid Fix XP (15kg to 36kg)
Key of letters to be inserted in the above table YES =It is suitable for this seating position NO = II is not suitable for this seating position
#1: Only belted.
Seating position
G)
Front Front (2) Passenger Passenger airbag is airbag is activated deactivated
NO YES (#1) YES (#1)
NO YES (#1) YES
NO YES (#1) YES
#A: These child restraint systems are SUZUKI Genuine Accessory, refer to the accessories catalog. However, there are countries which do not sell this child restraint system.
1-23
@
YES (#1)
YES
YES

Child restraint systems suitability for each seat position (for the vehicle with­out airbag deactivation switch)
The above illustration shows Left hand drive vehicle.
NOTE: Seat position number of G), @ and @ is same as Left hand drive vehicle for Right hand drive vehicle.
G) Front passenger's seat @ Rear seat right side @ Rear seat left side
G)
(#1, #2, #3)
~
(#2, #3)
@
(#2, #3)
(gJ
(g)@
[g)~l~
[g)~l~
It is suitable for univer­sal category of child restraint system fixed with the vehicle seat belt.
It is suitable for i-Size and ISOFIX child restraint system.
This seat is equipped with Top tether anchor­age point.
Never use a rear-fac­ing child restraint sys­tem on the passenger seat.
FOR SAFE DRIVING
#1: Move the front seat fully rearward. #2: When you install a forward-facing child restraint, if there is a gap or space between the child restraint and the seatback, adjust the seat­back angle in order to install the child restraint system properly. #3: If the head restraint interferes with the child restratint system, adjust the height of the head restraint or remove it, as necessary.
1-24

FOR SAFE DRIVING
Detailed information for child restraint system (for the vehicle without airbag deactivation switch)
Seat position number
Seating position suitable for universal belted (YES/NO)
· i-Size seating position (YES/NO)
Seating position suitable for lateral fixture (L 1 /L2)
Suitable rear-facing fixture (R1/R2/R3)
Suitable front-facing fixture (F2X/F2/F3)
Key of letters to be inserted in the above table YES =Suitable for this seating position NO = Not suitable for this seating position X =ISOFIX position is not suitable for ISOFIX child restraint systems in this fixture.
CD
YES (#1)
NO
NO
NO
NO
ISOFIX child restraint systems are divided into different mass group, size class and fixture. The child restraint system can be used in the seating positions for fixture shown in the above table. For mass group, size class and fixture, confirm the table of next page.
#1: When installing the child restraint systems, only a front-facing fixture is suitable.
1-25
Seating position
@
YES
YES
X
R1, R2
F2X, F2, F3
@
YES
YES
X
R1, R2
F2X, F2, F3

FOR SAFE DRIVING
Installation suitability of SUZUKI recommendation child restraint systems (for the vehicle without airbag deactivation switch)
Recommendation of Mass group Child restraint system (#A)
0,0+ Britax Romer Baby-Safe i-Size (up to 13kg)
I Britax Romer Duo Plus (9kg to 18kg)
II, II I Britax Romer KidFix XP (15kg to 36kg)
Key of letters to be inserted in the above table YES =II is suitable for this seating position NO = It is not suitable for this seating position
#1: Only belted.
G)
NO
YES (#1)
YES (#1)
#A: These child restraint systems are SUZUKI Genuine Accessory, refer to the accessories catalog. However, there are countries which do not sell this child restraint system.
1-27
Seating position
(2) @
YES (#1) YES (#1)
YES YES
YES YES

FOR SAFE DRIVING
ELR type belt
80JC021
1-29
(For models with front passenger airbag deactivation system) Whenever possible, SUZUKI recom­mends that child restraint systems be installed on . th_e rear seat. According to· accident stat1st1cs, children are safer when ~roperly restrained in rear seating posi­tions than in front seating positions. • If you must install the child restraint sys­tem on the front passenger's seat follow instructions below. ' -D_eactivate the front passenger's front airbag by the front passenger airbag d~activation system (if equipped). -Slide the seat to the most rear position by the seat position adjustment lever. -If there is a gap or space between the child restraint and the seatback, adjust the seatback angle in order to install the child restraint system properly.
Install your child restraint system accord­ing to the instructions provided by the child restraint system manufacturer.
Check that the seat belt is securely latched. Move the child restraint system in all direc­tions to check that it is securely installed. When you put your child in the child restraint system, appropriately slide the front seat forward not to touch a part of your child's body.
Installation with ISOFIX type
anchorages
78RB02020
Your vehicle is equipped with the lower anchorages in the rear seat outboard seat­ing positions for securing a ISOFIX type of child restraints with the connecting bars. The lower anchorages are located where the rear of the seat cushion meets the bot­tom of the seatback.
A WARNING
Install the ISOFIX type of child restraint(s) in the only outboard seat­ing positions, not in the central posi­tion for the rear seat.