Downloaded from www.Manualslib.com manuals search engine 4683K
BEFORE DRIVING
4-34(1) Speedometer
(2) Display
(3) “MODE” knobSpeedometerThe speedometer indicates vehicle speed in
km/h.Odometer/Trip meterThe odometer/trip meter is shown when the
ignition switch is in the “ON” position. The
odometer records the total distance the
vehicle has been driven. The trip meter can
be used to measure the distance traveled
on short trips or between fuel stops.Speedometer/Odometer/Trip meter/
Meter Illumination Control
83K-02-090
EXAMPLE
NOTE:
When the ignition switch is turned to “ON”,
the display (2) shows the latest display that
the ignition switch was turned to “OFF” last
time.Keep track of your odometer reading
and check the maintenance schedule
regularly for required services.
Increased wear or damage to certain
parts can result from failure to
perform required services at the
proper mileage intervals.
NOTICE
83K-02-091
When the ignition switch is turned to “ON”,
the display shows three or six types of
indication; odometer (a), trip meter A (b),
trip meter B (c), and if your vehicle is
equipped with the information display,
instantaneous fuel consumption (d), average
fuel consumption (e), and driving range (f).
Push the “MODE” knob (3) quickly to switch
the indication among three or six. For the
indication (d), (e), or (f), refer to “Information
Display” in this section for details.
If you attempt to adjust the display
while driving, you could lose control
of the vehicle.
Do not attempt to adjust the display
while driving.
w ww w
w WARNING
83K-02-092
Downloaded from www.Manualslib.com manuals search engine 9183K
INSPECTION AND MAINTENANCE
9-2
w ww w
w WARNING
MARUTI SUZUKI recommends that
maintenance on your MARUTI SUZUKI
vehicle should be performed by
MARUTI SUZUKI authorised Dealer/
Service Station.
CAUTION
Whenever it becomes necessary to
replace parts on your vehicle, it is
recommended that you use MARUTI
GENUINE PARTS (MGP) only.Periodic Maintenance Sched-
ule
“A” : Adjust
“C” : Clean
“R” : Replace or Change
“I” : Inspect, correct or replace if
necessary
“L” : Lubricate
“T” : Tighten to Specified Torque
“O” : Rotate
NOTE:
This table includes services as scheduled
up to 80,000 km mileage. Beyond 80,000
km, carry out the same services at the
same intervals respectively.
